SparkFun Qwiic Ecosystem

SKU: SF-SEN-24409 | Brand: SparkFun

This compact breakout board measures moisture in soil and similar materials using two large exposed pads as conductivity probes. As the soil gets wetter, conductivity between the pads increases, resistance drops, and ...

SKU: SF-LCD-29530 | Brand: SparkFun

This compact OLED board gives your project a crisp monochrome white-on-black interface in a 1.5-inch square form factor. With 128x128 pixels and a 1:1 aspect ratio, it suits custom graphics, menus, status screens and ...

SKU: SF-COM-30416 | Brand: SparkFun

Control higher-power loads from a microcontroller over I2C with this Qwiic relay board. It is built around the Omron G6K-2F-Y DC3 dual-pole/dual-throw relay, letting a low-voltage logic system switch loads up to 1A at...

SKU: AF-5603 | Brand: Adafruit

Add a bright numeric display to your project without giving up a pile of microcontroller pins. This assembled Adafruit LED backpack pairs an ultra-bright green 4-digit, 0.56 inch seven-segment display with a driver bo...

SKU: SF-DEV-20748 | Brand: SparkFun

This single-board carrier lets you connect one MicroMod Processor Board to one MicroMod Function Board using SparkFun’s M.2-based MicroMod ecosystem. Align the keyed edge connector, fasten the boards with screws, and ...

SKU: SF-COM-16917 | Brand: SparkFun

Show numbers, letters, characters and symbols in bright blue with this compact four-character alphanumeric display. Each digit uses fourteen segments, giving you far more flexibility than a standard seven-segment disp...

SKU: SF-GPS-23288 | Brand: SparkFun

Bring high-precision GNSS positioning to your project with the u-blox NEO-F9P engine and dual-band L1/L5 reception. L5 signals sit in the protected ARNS band, helping reduce RF interference and improve reliability in ...

SKU: SF-GPS-26620 | Brand: SparkFun

Built around the Quectel LG290P, this compact RTK GNSS breakout is designed for high-precision positioning projects that need quad-band, multi-constellation reception. It follows the same board dimensions, pin layout ...

SKU: SF-KIT-23452 | Brand: SparkFun

Get started with high-precision RTK GNSS and dead reckoning using u-blox's ZED-F9R module. This kit combines a sensor-fusion GPS breakout, a multiband SMA antenna and a USB cable so you have the core hardware needed f...

SKU: SF-WRL-21327 | Brand: SparkFun

This board is a low-power 2.4GHz BT beacon breakout built around the InPlay IN100 NanoBeacon. It is designed for fast deployment in wireless sensor monitoring, asset tracking, retail beaconing and real-time location t...

SKU: SF-GPS-22693 | Brand: SparkFun

This high-precision GNSS breakout is built around the u-blox ZED-F9R, combining RTK positioning with Automotive Dead Reckoning (ADR) sensor fusion. It fuses a 3D IMU sensor, wheel ticks, a vehicle dynamics model, corr...

SKU: SF-SEN-27544 | Brand: SparkFun

When the ADC built into your microcontroller is not precise enough, this Qwiic breakout adds a high-resolution Texas Instruments ADS1219 for measuring very small analogue voltage changes.The board provides four channe...

SKU: SF-COM-28236 | Brand: SparkFun

This add-on board solves a common Raspberry Pi Pico HAT problem: fixed orientation. It takes the standard pinout for a Raspberry Pi Pico development board and flips it as if the Pico had been physically rotated over, ...

SKU: SF-SEN-29529 | Brand: SparkFun

This ultra-small Qwiic-enabled breakout adds three-axis acceleration sensing to compact projects using the LIS3DH, a smart, low-power capacitive micro-machined accelerometer with 12-bit resolution. It can be used for ...

SKU: SF-GPS-28019 | Brand: SparkFun

This high-precision positioning breakout is built around the Quectel LG580P GNSS module, giving projects centimetre-level RTK positioning plus instantaneous heading when used with two GNSS antennas. Unlike systems tha...

SKU: SF-GPS-30018 | Brand: SparkFun

Built around the u-blox SAM-M8Q module, this compact GNSS receiver is a straightforward way to add location tracking to a project. Plug in USB-C for power and configuration, or use the Qwiic connectors for solder-free...

SKU: SF-GPS-30975 | Brand: SparkFun

Built around the u-blox ZED-F9T-20B receiver, this breakout is made for projects where precise time matters as much as location. Under clear skies it can provide five nanoseconds of timing accuracy without requiring e...

SKU: SF-WRL-17381 | Brand: SparkFun

Built around Espressif’s ESP32-WROOM-32UE module, this Thing Plus board gives you a compact foundation for connected projects that need WiFi, Bluetooth and a flexible antenna setup. The onboard U.FL connector lets you...

SKU: SF-SEN-23220 | Brand: SparkFun

Measure visible and near-infrared light with a compact Qwiic breakout based on the AS7343 multi-spectral sensor. It covers approximately 380nm to 1000nm and is suited to reflected, emitted and transmitted light measur...

SKU: SF-WRL-30678 | Brand: SparkFun

Built around Espressif’s ESP32-C5-WROOM-1 module, this Thing Plus board gives IoT projects a compact microcontroller platform with dual-band WiFi 6, Bluetooth 5 LE, Zigbee and Thread connectivity. It pairs a 32-bit RI...