New Arrivals

SKU: DF-DFR0827 | Brand: DFRobot

PiTray mini is a Model B liked carrier board for building cluster with Raspberry Pi Computed Module 4 (CM4). PiTray mini focuses on providing a neat and budget solution for CM4 applications. With the same outline...

SKU: DF-DFR0745 | Brand: DFRobot

Wanna buy a simple & practical voice recorder? This one is right for you! The voice recorder module supports 4 controlling modes (Arduino, AT command, on-board buttons, and ADKEY), and multi-segment voice recording. Y...

SKU: EC-ARS01119B | Brand: Elecrow

ESP-WROOM-32 is a powerful, generic Wi-Fi+BT+BLE MCU module that targets a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streamin...

SKU: AF-4759 | Brand: Adafruit

The Feather M4 CAN Express upgrades the popular Feather M4 platform with the ATSAME51J19 processor, which adds built-in CAN bus support. It features a 120 MHz Cortex M4 with hardware floating point and DSP instruction...

SKU: YH-6000300953 | Brand: Little Bird

A protective silicone case designed for the BBC micro:bit, compatible with both V1.5 and V2 boards. Precision-cut openings provide full access to the 5×5 LED matrix, A/B buttons, edge connector pins, and all V2 featur...

SKU: DF-FIT0723 | Brand: DFRobot

Protect your electronics projects from rain and water splash with this IP68-rated waterproof enclosure. Made from sturdy ABS with a transparent polycarbonate lid and silicone gasket, it's built for both indoor and out...

SKU: DF-SEN0365 | Brand: DFRobot

This compact breakout uses the AMS AS7341 spectral sensor IC to measure colour across multiple visible-light bands. It is designed for projects that need more detail than a basic RGB colour sensor, with channels cover...

SKU: AF-4776 | Brand: Adafruit

These are the smallest NeoPixel breakouts around! Tiny, bright RGB+White pixels to your project. These little PCBs are only 9.1mm x 9.1mm and have two sets of three pads on the back for soldering wires. These ultra...

SKU: EC-DPO28090B | Brand: Elecrow

The NodeMCU V2 is a Wi-Fi development board based on the ESP8266 (ESP-12E module) with an on-board PCB antenna and USB programming interface. It supports 802.11 b/g/n wireless networking and can operate in STA, AP, or...

SKU: PR-COM-B018 | Brand: Little Bird

Keep dust and dirt off your Raspberry Pi High Quality Camera lens without touching the glass. This lens air duster uses a quick squeeze to send a gentle breeze across the lens surface, helping clear loose particles be...

SKU: DF-SER0056 | Brand: DFRobot

The DFRobot 2Kg 300° Clutch Servo features built-in clutch protection and electronic overload protection, making it ideal for robotics and model applications where servos may encounter external forces or stalling. Wh...

SKU: SF-DEV-17287 | Brand: SparkFun

The BBC micro:bit v2.21 is your gateway to hands-on learning, creativity, and innovation with digital technology. This pocket-sized powerhouse packs impressive features into a board that’s half the size of a credit ca...

SKU: AF-4696 | Brand: Adafruit

Perhaps your smart phone, tablet, or even your Raspberry Pi 4, charges off of USB, but can you really trust that charging station at the airport? Now you can control when to allow data in or out of your device with th...

SKU: AF-4663 | Brand: Adafruit

The 6V Air Valve (FA0520E) is a 3-port solenoid valve for pneumatic systems, functioning similarly to an electrical relay. It features a common port (COM), a normally open port, and a normally closed port, allowing yo...

SKU: AF-4711 | Brand: Adafruit

The AP3429A Buck Converter Breakout steps down 3.4–5.5V input to a stable 3.3V output at up to 1.2A, with 90–95% efficiency. It's ideal for powering 3.3V circuits from LiPo batteries, 3× alkaline cells, or USB power s...

SKU: AF-4685 | Brand: Adafruit

A comprehensive 420-piece set of black nylon M3 screws, nuts, and hex standoffs in a reusable storage container. Nylon fasteners are non-conductive, making them ideal for mounting PCBs and breakout boards without inte...

SKU: AF-4687 | Brand: Adafruit

The Adafruit 2.13" Monochrome E-Ink Bonnet brings crisp, paper-like displays to your Raspberry Pi with no soldering required. Simply plug this pre-assembled bonnet onto any Pi with a 2×20 header and start displaying h...

SKU: RP-SC0450 | Brand: Raspberry Pi Ltd

Red T-shirt White Logo Adult Size Small. Sizing is to a standard UK high-street size, and the shirts fit true to size. We recommend purchasing your usual size. If you fall between two sizes, we advise purcha...

SKU: RP-SC0452 | Brand: Raspberry Pi Ltd

Red T-shirt White Logo Adult Size Large. Sizing is to a standard UK high-street size, and the shirts fit true to size.  We recommend purchasing your usual size.  If you fall between two sizes, we advise p...

SKU: DF-FIT0662-1 | Brand: DFRobot

Note: The kits include two pairs of Mecanum wheels: two left-handed wheels and two right-handed wheels. Please pay attention to the L and R noted on the back of the product when installing,What wheels should...