New Arrivals

SKU: DF-TEL0140-1 | Brand: DFRobot

This Gravity wireless switch kit provides simple 433 MHz RF communication between a transmitter and receiver module. Based on digital signal transmission, it offers strong wall penetration, ultra-low standby power con...

SKU: SF-SEN-18364 | Brand: SparkFun

The DHT20 is a factory-calibrated digital humidity and temperature sensor with an I²C interface. An upgrade to the popular DHT11/DHT22 series, it provides reliable environmental measurements without requiring addition...

SKU: AF-4718 | Brand: Adafruit

The Adafruit SPI Non-Volatile FRAM Breakout provides 2 Mbit (256 KBytes) of ferroelectric RAM (FRAM) storage over SPI. FRAM combines the non-volatile retention of flash with the instant read/write speed of SRAM — no p...

SKU: AF-4719 | Brand: Adafruit

The Adafruit SPI Non-Volatile FRAM Breakout provides 4 Mbit (512 KBytes) of ferroelectric RAM (FRAM) storage over SPI. FRAM combines the non-volatile retention of flash with the instant read/write speed of SRAM — no p...

SKU: MM-SKU00066 | Brand: Monk Makes

The 7-Segment for micro:bit by Monk Makes is a 4-digit 7-segment display designed specifically for BBC micro:bit. It can display numbers, letters, and limited characters using simple serial communication from a single...

SKU: SF-SEN-15440 | Brand: SparkFun

The BME280 Atmospheric Sensor Breakout measures barometric pressure, relative humidity, and temperature from a single compact board. With both Qwiic (I2C) and 0.1″ header connections, it integrates easily into Arduino...

SKU: EF-EF04024 | Brand: ElecFreaks

This is a Rain/steam sensor from ElecFreaks. This steam sensor can be connected to the Arduino IO Expansion shield directly. The output voltage will increase when the humidity of the sensor surface goes up.You even co...

SKU: AF-4172 | Brand: Adafruit

The Adafruit HUZZAH32 ESP32 Breakout is a compact, breadboard-friendly development board built around the Espressif ESP32 dual-core processor. With WiFi, Bluetooth Classic, and BLE support, 4 MB SPI Flash, and a gener...

SKU: AF-1231 | Brand: Adafruit

The ADXL345 from Analog Devices is a triple-axis digital accelerometer with both I2C and SPI interfaces. This breakout board includes an on-board 3.3V regulator and logic-level shifting, making it easy to interface wi...

SKU: PI-COM2800 | Brand: Pimoroni

Add Internet to your next project with an adorable, bite-sized WiFi microcontroller, at a price you like! The ESP8266 processor from Espressif is an 80 MHz microcontroller with a full WiFi front-end (both as client...

SKU: AF-3986 | Brand: Adafruit

This T-Slot Photo Interrupter is a simple plastic sensor with two elements - an IR LED and an IR photo-transistor, situated across a U-shaped gap. You can control the IR LED and turn it on to transmit IR light acro...

SKU: LB-LR0214-73A | Brand: Little Bird

Secure your project with biometrics - this all-in-one optical fingerprint sensor will make adding fingerprint detection and verification super simple. These modules are typically used in safes - there's a high powered...

SKU: LB-LR0205 | Brand: Little Bird

An alcohol sensor module for Arduino with both digital (TTL) and analog output. It detects alcohol vapour in the 10–1000 PPM range, with analog output voltage increasing proportionally with concentration. The module a...

SKU: AF-2340 | Brand: Adafruit

The Adafruit Capacitive Touch HAT adds 12 capacitive touch sensors to your Raspberry Pi using the MPR121 touch controller over I2C. Each sensor has a figure-8 hole designed for alligator clip connections — attach clip...

SKU: DF-DFR0106 | Brand: DFRobot

This fantastic light disc consists of 7 SMD RGB LED. It illustrates a beautiful color combination much better than traditional RGB led. You can control the LEDs via the RGB pins. By pulse-width-modulating the pins an...

SKU: AF-2809 | Brand: Adafruit

The Adafruit LIS3DH is a popular, low-power triple-axis accelerometer breakout packed with features typically found only on higher-end sensors. With selectable measurement ranges, multiple interface options, and built...

SKU: SF-BOB-13878 | Brand: SparkFun

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. If you open up an electronic bathroom scale, you’ll find a large rat’s ne...

SKU: SF-WRL-13231 | Brand: SparkFun

The SparkFun ESP8266 Thing is a breakout and development board for the ESP8266 WiFi SoC — a popular platform for IoT and WiFi-connected projects. All module pins are broken out to breadboard-compatible rows, and on-bo...

SKU: DF-SEN0211 | Brand: DFRobot

INTRODUCTION When you want to measure AC current it is impractical and hazardous to cut in to your live wiring. The analog AC current sensor developed by DFRobot is a good solution to this p...

SKU: DF-SEN0197 | Brand: DFRobot

The Gravity Voice Recorder Module is a compact board with integrated record and playback functions, based on the ISD1820 chip. Simply press the record button, speak into the onboard microphone, and release to save up ...