Enclosures & Hardware

SKU: DF-FIT0064 | Brand: DFRobot

A 10-pack of M3 × 50mm hexagonal standoffs with matching screws and nuts. Use them to mount circuit boards, sensors, and other components with consistent 50mm spacing and secure mechanical support. At 50mm height, th...

SKU: AF-4631 | Brand: Adafruit

A pack of four magnetic mounting feet designed for RGB LED matrix panels. At 16.6 mm long, each magnet-screw slots into the standard 3 mm mounting bosses found on most RGB matrix panels, providing a quick and secure w...

SKU: AF-6183 | Brand: Adafruit

Here is a cute, minimal snap-on mount for your QT Py to keep it safe during use and transport. It has been custom-designed and 3D printed to accommodate the USB-C connector, along with four M3 mounting holes. No screw...

SKU: SF-PRT-21232 | Brand: SparkFun

This is an M3 hex nut. For use with M3 screws.

SKU: AF-4807 | Brand: Adafruit

An acrylic faceplate and hardware kit for the Adafruit MagTag. The kit includes two front plate options — a red arrow and a white cloud — plus a back plate and all the nylon mounting hardware needed for assembly. Take...

SKU: AF-4103 | Brand: Adafruit

A simple, solder-free way to make secure wire connections to development boards with large alligator-clip pads. Thread a screw through the pad, wrap your wire around it, and tighten the hex nut to hold everything firm...

SKU: DF-FIT0139 | Brand: DFRobot

These nuts can be used to install your circuit boards, sensors and mechanical mountings. The wide flange at one end with an uneven surface eliminates the need for using extra washers to keep the nut tightly secur...

SKU: DF-FIT0060 | Brand: DFRobot

A 10-pack of M3 × 5mm mounting screws with matching nuts. A staple for securing circuit boards, sensors, and mechanical components in electronics projects. Key Features M3 Thread – Standard M3 size compatible with ...

SKU: DF-FIT0061 | Brand: DFRobot

A 10-pack of M3 × 8mm mounting screws with matching nuts. A staple for securing circuit boards, sensors, and mechanical components in electronics projects. Key Features M3 Thread – Standard M3 size compatible with ...

SKU: DF-FIT0063 | Brand: DFRobot

A 10-pack of M3 × 10mm hexagonal standoffs with matching screws and nuts. Use them to mount circuit boards, sensors, and other components with consistent spacing and secure mechanical support. Standoffs are ideal for...

SKU: DF-FIT1020 | Brand: DFRobot

This protective back cover is designed for the UNIHIKER K10, helping shield the exposed back-side components from accidental contact and unexpected short circuits during classroom, workshop and maker use.The case is m...

SKU: SF-PRT-17867 | Brand: SparkFun

This protective case is designed for the BBC micro:bit and works with both the original micro:bit V1 and the micro:bit V2. Its four-layer construction surrounds the board while keeping the important buttons, ports and...

SKU: SF-KIT-24115 | Brand: SparkFun

Keep your electronics bench ready for the next enclosure, PCB stack or prototype with this 210-piece brass standoff kit. It covers two common PCB hardware sizes, M3 and M2.5, with a mix of standoff heights, nuts, scre...

SKU: AF-6480 | Brand: Adafruit

This machined aluminium servo arm is a tougher, longer-lasting upgrade from the standard plastic servo horns commonly supplied with hobby servos. The red anodised finish looks neat in robotics, animatronics and mechan...