Breakouts

This is a breakout board for the Bosch BMP180 high-precision, low-power digital barometer. The BMP180 offers a pressure measuring range of 300 to 1...

The NCP1402 is a 5V DC-DC converter. This breakout board will accept voltage inputs between 1 and 4 Volts and output a constant, low ripple 5V outp...

This Nintendo DS Screen Kit joins two of our more unique products together to provide you with an easy means to equip your next project with tou...

The Intel® Edison is an ultra small computing platform that will change the way you look at embedded electronics. Each Edison is packed with a huge...

The Intel® Edison is an ultra small computing platform that will change the way you look at embedded electronics. Each Edison is packed with a huge...

This is the SparkFun Pi Wedge B+, a small board that connects to the 40-pin GPIO connector on the Raspberry Pi B+, and breaks the pins out to bread...

The BME680 from Bosch is a powerful sensor capable of sensing humidity, barometric pressure, temperature and indoor air quality. The BME680 can ...

This is a simple kit that allows the use of very large, very bright, 10mm red/green/blue LEDs. We cannot begin to describe how bright these are whe...

This is the RFduino Proto Shield, a finger-tip sized board that can be attached to the main RFduino Dip module to create your own custom circuits a...

This item is just for the Trellis driver PCB assembly: LEDs and buttons not included. Trellis is an open source backlight keypad driver system. ...

This inertial-measurement-unit combines 3 of the best quality sensors available on the market to give you 11 axes of data: 3 axes of acceleromet...

You hear it all the time in the Arduino community, “will this shield work with my other shield?.” I think we’ve all been disappointed to find that ...

The SparkFun BlackBerry Trackballer Breakout gives you easy access to a trackball which measures up, down, left, and right movements, clicks on the...

DFRobot FireBeetle series are low power consumption controllers designed for Internet of Things (IoT) development. The FireBeetle series are aimin...

This is a simple breakout board for the SHT15 humidity sensor from Sensirion. The SHT15 digital humidity and temperature sensor is fully calibrated...

Connect your own PCB to a Raspberry Pi with this extra-tall female header. The female header part has extra spaces to make it 13.6mm tall: when ...

This is a breakout board for the ISD1932, a multiple-message record/playback device. This single chip can record up to 64 seconds worth of voice me...

The SN74HC165N is a neat little IC that will take an input of up to 8 parallel lines and produce a single, serial output. It’s a great way to incre...

This is a simple breakout board for Analog Device’s AD5330 8-bit digital-to-analog converter (DAC). The AD5330 has a parallel interface, and can op...

This is a breakout board for the built in WS2812 RGB LED. The WS2812 is actually an RGB LED with a WS2811 built right into the LED! All the necessa...

Introducing the 3.3V SparkFun FT231X Breakout board, complete with the full UART hardware handshake feature! The pinout of this board matches the F...