Breakouts

SKU: AF-1918 | Brand: Adafruit

An analog UV light sensor breakout based on the GUVA-S12SD photodiode, detecting the 240–370nm range covering UVB and most of the UVA spectrum. An on-board op-amp amplifies the tiny photodiode current to a readable vo...

SKU: DF-SEN0220 | Brand: DFRobot

The Gravity UART Infrared CO2 Sensor uses non-dispersive infrared (NDIR) technology to measure carbon dioxide concentrations from 0 to 50,000 ppm. It offers excellent selectivity with no oxygen dependency, built-in te...

SKU: SF-ROB-09454 | Brand: SparkFun

The SparkFun QRE1113 Line Sensor Breakout (Digital) is a compact IR reflectance sensor board that outputs a digital signal based on surface reflectivity. It uses a capacitor discharge circuit — the faster the 10 nF ca...

SKU: PL-2126 | Brand: Pololu

A breakout board for ST's LPS331AP digital barometric pressure sensor. This sensor measures absolute pressure from 260 to 1260 mbar with excellent accuracy (±2 mbar), making it ideal for altitude estimation, weather m...

SKU: SF-BOB-29762 | Brand: SparkFun

  The WS2812 (often referred to as a "NeoPixel") has become the standard for addressable LED projects. This RGB LED Breakout board, now with pre-soldered right-angle headers, is the absolute easiest way to st...

SKU: SF-LCD-29467 | Brand: SparkFun

  The SparkFun Red Vision Touch Display for Pico features a 2.0", 320x240px capacative touch LCD mounted on a breakout board designed to plug directly into the Control Board on the Experiential Robotics ...

SKU: AF-6250 | Brand: Adafruit

The Adafruit PCM5102 I2S DAC converts digital I2S audio into excellent stereo line-level output through a 3.5mm jack. With an impressive 112dB signal-to-noise ratio and no MCLK or I2C configuration required, simply pi...

SKU: AF-5976 | Brand: Adafruit

The Adafruit DS2484 is a single-channel I2C-to-1-Wire bus adapter breakout with built-in ESD protection and split supply support. Simply connect it to an existing I2C bus and use the screw terminals to attach DS18B20 ...

SKU: LB-COCKATOO-V2 | Brand: Little Bird

The Cockatoo v2 is a simple breakout board for the BBC micro:bit, designed for school projects involving basic lighting circuits. Slide the micro:bit into the edge connector and access three pins — Pin 2, 3.3 V, and G...

SKU: AF-5769 | Brand: Adafruit

The Adafruit Audio BFF is a compact add-on board that turns your QT Py or Xiao into a powerful audio playback device. It features a microSD card slot (up to 64 GB) and a MAX98357 I2S 3W amplifier, all designed to fit ...

SKU: DF-SEN0543 | Brand: DFRobot

This GR10-30 gesture sensor is capable of recognizing 12 hand gestures: move up, down, left, right, forward & backward, rotate clockwise & counterclockwise, rotate clockwise & counterclockwise continuously, hover, and...

SKU: AF-5695 | Brand: Adafruit

The Adafruit NeoKey BFF adds a single mechanical key switch with RGB backlighting to any QT Py or Xiao board. Designed to solder or plug onto the back of your QT Py, it features a Kailh hot-swap socket for tool-free M...

SKU: SF-SEN-18823 | Brand: SparkFun

MIKROE Weather Click carries BME280 integrated environmental unit from Bosch. It’s a sensor that detects humidity, pressure, and temperature, specifically designed for low current consumption and long-term stability. ...

SKU: AF-4464 | Brand: Adafruit

The Adafruit ICM-20649 breakout features a wide-range 6-DoF IMU capable of measuring up to ±30g acceleration and ±4000°/s gyroscope rotation — roughly double the range of standard IMUs. When typical ±16g accelerometer...

SKU: AF-5146 | Brand: Adafruit

The Adafruit 24LC32 I2C EEPROM Breakout provides 32 Kbit (4 KB) of reliable, non-volatile storage over a simple I2C interface. Store calibration values, MAC addresses, access tokens, or any data that needs to persist ...

SKU: PR-PIM532 | Brand: Little Bird

Breakout Garden plugs into your shiny new Pi 400's GPIO pins and lets you connect up to three of our extensive selection of Pimoroni breakouts so they're conveniently facing towards you and the right way up. We've got...

SKU: PL-1317 | Brand: Pololu

This compact USB-to-serial adapter lets you easily connect TTL serial devices to a computer, where it appears as a virtual COM port. The board is a Micro-USB carrier for the Silicon Labs CP2102N USB-to-UART bridge, pr...

SKU: SF-DEV-17119 | Brand: SparkFun

The SparkFun Qwiic Shield for Teensy adds four Qwiic (I2C) connectors to your Teensy board, providing quick access to the SparkFun Qwiic ecosystem of sensors, actuators, and displays. Sized to fit the Teensy 4.0, Teen...

SKU: AF-4627 | Brand: Adafruit

The Adafruit H3LIS331 is an ultra-high-range triple-axis accelerometer capable of measuring up to ±400g across all three axes. Part of the ST LIS331 family, it's designed for applications where standard ±16g accelerom...

SKU: EC-RPA01921N | Brand: Elecrow

We all know that the core system of Raspberry Pi Zero is Linux, and without NIC inconvenient. However, most of the operations are based on linux’s command line via ssh service, that’s why we introduce this product.Thi...