Brands

SKU: SF-COM-11275 | Brand: SparkFun

It’s the end of the world, and you need a button to press. This is it. A 100mm diameter (outside diameter) dome illuminated push button comes with an LED, securing nut and a pre-installed long life horizontal micro...

SKU: SF-COM-11274 | Brand: SparkFun

It’s the end of the world, and you need a button to press. This is it. A 100mm diameter (outside diameter) dome illuminated push button comes with an LED, securing nut and a pre-installed long life horizontal micro...

SKU: AF-388 | Brand: Adafruit

Infrared LEDs are used for remote controls (they're the little LED in the part you point at your TV) and 'night-vision' cameras, and these little blue guys are high powered ones! They are 940nm wavelength, which is...

SKU: DF-DFR0010 | Brand: DFRobot

The DFRduino Nano USB Microcontroller V3.1 (ATMega 328) is a breadboard ready version of the Arduino mini with integrated USB. The arduino Nano has everything that the Diecimila has (electronically) with more anal...

SKU: SF-DEV-10899 | Brand: SparkFun

The LilyTiny is a compact LilyPad board with a built-in ATtiny85 microcontroller that drives four pre-programmed LED patterns. Simply sew on four LEDs and connect a battery — no programming or main board required. Ea...

SKU: SF-PRT-10811 | Brand: SparkFun

This DC power jack/connector is just like the other one that we carry except that it’s terminated with breadboard-friendly pins instead of wide solder terminals. These are also compatible with our DC wall supplies and...

SKU: SF-COM-12986 | Brand: SparkFun

We know these look like a lot of our other LEDs, but they’re not! These are PTH Addressable RGB LEDs with a WS2812 control IC built right into the them. This PTH version is incredibly similar to its SMD cousin, except...

SKU: AF-3328 | Brand: Adafruit

The Adafruit PT100 RTD Temperature Sensor Amplifier is a breakout board for the MAX31865 precision RTD-to-digital converter. It reads 2-, 3-, or 4-wire PT100 platinum resistance temperature detectors over SPI, deliver...

SKU: DF-TEL0094 | Brand: DFRobot

You must have used a GPS receiver. It is easy to be found in most places, such as smartphones, cars, and computers. They are used to track your loaction all over the globe. GPS Receiver for Arduino is a unit embed...

SKU: AF-954 | Brand: Adafruit

The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36" cable are four wire - ...

SKU: SF-PRT-10288 | Brand: SparkFun

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positive female barrel jack. If you have a power supply with a barrel jack an...

SKU: DF-FIT0492-A | Brand: DFRobot

A high-torque 12V DC geared motor with a 100:1 metal gear reducer. Built with 100% copper coils and a metal gearbox for durability, this compact motor delivers up to 50 kg·cm of stall torque at 50 RPM — ideal for robo...

SKU: DF-DFR0429 | Brand: DFRobot

INTRODUCTION An ordinary DC motor requires an H Bridge to work with a microcontroller such as an UNO. For newcomers to electronics, the process of finding the right motor driver, connecti...

SKU: DF-SEN0204 | Brand: DFRobot

A non-contact liquid level sensor that detects the presence of liquid through a container wall — no direct contact with the liquid required. Using advanced signal processing via the XKC-Y25-T12V chip, it works through...

SKU: AF-3333 | Brand: Adafruit

The Circuit Playground Express is an all-in-one development board packed with sensors, LEDs, and a speaker — all on a round, beginner-friendly PCB with alligator-clip pads. No soldering required. It supports four prog...

SKU: AF-3487 | Brand: Adafruit

This 30mm translucent green arcade button has built-in LEDs for a beautiful illuminated look. Two surface-mount LEDs with resistors are embedded in the button body, ready to light up from a microcontroller pin or dire...

SKU: AF-3562 | Brand: Adafruit

If you're looking to make a custom cable with any two of our HDMI adapters, then you'll need to have these flex cables handy!&nbsp;Making custom&nbsp;HDMI cables has never been easier. Just grab one of these cables...

SKU: EF-EF04097 | Brand: ElecFreaks

The Octopus Capacitive Soil Moisture Sensor uses capacitive sensing to detect soil moisture levels, avoiding the corrosion problems common with resistive sensors for a much longer service life. It outputs an analogue ...

SKU: SF-PRT-08430 | Brand: SparkFun

Premium female-to-female jumper wires, 155mm (6″) long, for connecting between male headers on development boards, breakout boards, and breadboards. The 0.1″ pitch connectors fit standard pin headers and can be instal...

SKU: PR-PIM375 | Brand: Little Bird

A really sophisticated and accurate colour and luminance sensor breakout that's Raspberry Pi and Arduino compatible. As well as detecting RGB colour and&nbsp;light level, it has added bells and whistles like 50/...