Brands

SKU: DF-SEN0248 | Brand: DFRobot

DFRobot BME680 Environmental Sensor is a low power gas, pressure, temperature & humidity sensor based on BOSCH BME680 sensor. It is a 4-in-1 multi-functional MEMS environmental sensor which integrates VOC (Volatil...

SKU: DF-FIT0554 | Brand: DFRobot

The LiitoKala Lii-402 is a four-slot smart charger that supports Li-ion, Ni-MH, and LiFePO4 rechargeable batteries. It automatically identifies Li-ion and Ni-MH battery types, with manual mode selection for LiFePO4 an...

SKU: AF-3694 | Brand: Adafruit

These Banana Plugs not only look great, they're also solder-free and stackable! Banana plugs are often used on test equipment, tools, synthesizers and other electronic patch panels. Each connector is designed ...

SKU: AF-3709 | Brand: Adafruit

The Adafruit SGP30 is a multi-pixel MOX (metal-oxide) gas sensor from Sensirion that measures Total Volatile Organic Compounds (TVOC) and equivalent CO2 (eCO2) for indoor air quality monitoring. With fully calibrated ...

SKU: AF-3670 | Brand: Adafruit

High-conductive heating fabrics are Literally! This non-woven fabric feels a little like felted paper but is filled with conductive material that can make the fabric emit heat when powered. Resistive heating fabrics s...

SKU: AF-1532 | Brand: Adafruit

This RF adapter bit is great for anyone doing RF work. If your receiver/transmitter/transceiver has an MCX connector but you really want to tie it to an SMA antenna, this dongle will do the trick!

SKU: AF-1381 | Brand: Adafruit

This breakout board is the ultimate companion for the VLSI VS1053B DSP codec chip. The VS1053 can decode a wide variety of audio formats such as MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM). It can al...

SKU: AF-1570 | Brand: Adafruit

A compact 3.7 V lithium-ion polymer (LiPo) battery with approximately 100 mAh capacity (0.4 Wh). Thin, lightweight, and powerful, this cell is suited for small wearable projects, IoT devices, and compact electronics w...

SKU: DF-TEL0116 | Brand: DFRobot

A long-range, low-data-rate radio modem pair based on the Semtech SX1276 LoRa transceiver. Operating on the 433 MHz ISM band, these modules deliver robust wireless links with excellent sensitivity and low power consum...

SKU: DF-TEL0115 | Brand: DFRobot

LoRa Radio Module is a type of long range low data rate data radio modem based on Sx1276 from Semtech. It is a low-cost sub-1 GHz transceiver module designed for operations in the unlicensed ISM (Industrial Scient...

SKU: DF-TEL0114 | Brand: DFRobot

LoRa MESH Radio Module is a high performance, low power, long-range micro-power RF module, using a distributed ad-hoc network communication mode, embedded wireless MESH MANET protocols, users do not need to do any...

SKU: AF-1590 | Brand: Adafruit

Have you gazed longingly at large TFT displays - you know what I'm talking about here, 4", 5" or 7" TFTs with up to 800x480 pixels. Then you look at your Arduino. You love your Arduino (you really do!) but there's ...

SKU: AF-1622 | Brand: Adafruit

A diffused white LED backlight strip in a 3.5 mm thick acrylic enclosure. Normally found behind LCDs, this module uses a single white LED with a specially designed acrylic diffuser to provide near-uniform illumination...

SKU: DF-TEL0122 | Brand: DFRobot

DFRobot FireBeetle series are low power consumption controllers designed for Internet of Things (IoT) development. The FireBeetle series are aiming straight at the point fast and convenient low-power IoT bu...

SKU: AF-1626 | Brand: Adafruit

These pretty strips of light are plastic diffused backlights, often seen in LCD displays. Normally they're tucked behind the LCD and shine white light from below. Here, we've got the LEDs available individually and th...

SKU: DF-SEN0232 | Brand: DFRobot

The Gravity Analog Sound Level Meter is an Arduino-compatible decibel meter that accurately measures environmental noise levels. It uses an instrumentation-grade circuit with a low-noise microphone for high-precision ...

SKU: AF-1657 | Brand: Adafruit

Get started with Adafruit GEMMA with this lovely starter kit! Included is everything you need to make a basic project. There's a GEMMA board, four sewable bright RGB pixels, a battery holder and batteries, 2-p...

SKU: AF-1661 | Brand: Adafruit

uFL connectors are very small surface-mount parts used when an external RF antena is desired but a big bulky SMA connector takes up too much space. We use this part on our GPS and WiFi boards, they're great! Chances a...

SKU: AF-1662 | Brand: Adafruit

Streeeeetch your resistive touch-screen's reach with a 20cm extension cord. This is a great accessory for our resistive touch screen controller breakouts. Plug your 4-pin 1mm pitch FPC into the socket end and the othe...

SKU: AF-2038 | Brand: Adafruit

A 16×8 LED matrix backpack kit featuring two ultra-bright 1.2" white 8×8 round LED matrices on a single I2C-controlled driver board. The HT16K33 chip handles all the multiplexing, so you only need two I2C pins (SDA an...