Brands and Manufacturers

SKU: DF-DFR0076 | Brand: DFRobot

This Gravity analog flame sensor detects fire and infrared light sources in the 760–1,100 nm wavelength range. With a 60° detection angle and analogue output proportional to flame distance, it's widely used in firefig...

SKU: AF-5464 | Brand: Adafruit

This rubber sheet is made of the same carbon-black impregnated rubber material that our conductive rubber cord uses. Traditionally it would be used for EMF shielding, or conductive gaskets - but it's very fun to play ...

SKU: AF-987 | Brand: Adafruit

This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 3.7W channels into 3 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2.7V-5.5VDC. Since...

SKU: AF-1789 | Brand: Adafruit

This 1K potentiometer is a two-in-one, good in a breadboard or with a panel. Its a fairly standard linear taper 1K ohm potentiometer, with a grippy shaft. Its smooth and easy to turn, but not so loose that it will ...

SKU: AF-1792 | Brand: Adafruit

Add a little sparkle to your wearable project with Adafruit LED Sequins. These tiny sewable LED boards are the simpler sibling of Flora NeoPixels — they display a single colour with no digital control needed, making t...

SKU: SF-SEN-00246 | Brand: SparkFun

This sensor uses an infrared emitted diode combined with an infrared phototransistor to detect the reflected infrared signal. Ideal for sensing black-to-white transitions or can be used to detect nearby objects (.5-1cm).

SKU: DF-DFR0023 | Brand: DFRobot

This is an Arduino Temperature Sensor based on LM35 temperature chip. A Temperature Sensor can be used to detect ambient air temperature.The LM35 chip is produced by National Semiconductor Corporation and offers a fun...

SKU: DF-SEN0043 | Brand: DFRobot

An analog ambient light sensor based on the TEMT6000 detector, which has a spectral response closely matching the human eye with very low IR sensitivity. It outputs an analog voltage proportional to the ambient light ...

SKU: AF-1831 | Brand: Adafruit

This potentiometer is a two-in-one, good in a breadboard or with a panel. It's a fairly standard linear taper 100K ohm potentiometer, with a grippy shaft. It's smooth and easy to turn, but not so loose that it will...

SKU: AF-3406 | Brand: Adafruit

The Feather nRF52 Bluefruit LE is an all-in-one Bluetooth Low Energy development board built around the Nordic nRF52832. Unlike earlier Bluefruit Feathers that used a separate helper chip, the nRF52832 runs your appli...

SKU: AF-3517 | Brand: Adafruit

Everything you need to get started with the Circuit Playground Express — a feature-packed, all-in-one development board that works with Microsoft MakeCode (block-based or JavaScript), CircuitPython, code.org CS Discov...

SKU: DF-DFR0067 | Brand: DFRobot

This Gravity-compatible DHT11 sensor provides calibrated digital temperature and humidity readings via a single data pin. With an integrated 8-bit microcontroller and factory-calibrated coefficients stored in OTP memo...

SKU: AF-3481 | Brand: Adafruit

A panel-mount 10 kΩ logarithmic potentiometer with an integrated on/off switch. The logarithmic taper is designed for audio volume control — resistance increases on a curve that matches how the human ear perceives lou...

SKU: SF-SEN-09376 | Brand: SparkFun

This is a force sensitive resistor with a square, 1.75x1.5", sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the res...

SKU: DF-DFR0604 | Brand: DFRobot

The IO Expansion HAT adds digital, analogue, I2C, PWM, UART, and SPI ports to the Raspberry Pi Zero and Zero W. An on-board STM32F030 MCU provides 8-channel 12-bit ADC and PWM output, communicating with the Raspberry ...

SKU: WS-30945 | Brand: Waveshare

Waveshare RP2350 CAN Development BoardUnleash the power of robust embedded systems with the cutting-edge Waveshare RP2350 CAN Development Board. Crafted meticulously for those who demand precision and reliability in t...

SKU: AF-4759 | Brand: Adafruit

The Feather M4 CAN Express upgrades the popular Feather M4 platform with the ATSAME51J19 processor, which adds built-in CAN bus support. It features a 120 MHz Cortex M4 with hardware floating point and DSP instruction...

SKU: EF-EF04092 | Brand: ElecFreaks

The Octopus Light Sensor Brick reads the ambient light level of its surrounding environment and outputs an analog signal. The 3-pin GVS connector makes it easy to plug into micro:bit expansion boards, Arduino, and oth...

SKU: AF-913 | Brand: Adafruit

Yes, this is an adorable small television! The visible display measures only 3.5" (8.9cm) diagonal, the TFT comes with a NTSC/PAL driver board. The display is very easy to use - simply connect 6-12VDC to the red (+) a...

SKU: AF-1083 | Brand: Adafruit

Add high-speed analog-to-digital conversion to any microcontroller with the ADS1015 breakout. This 12-bit ADC delivers 3,300 samples per second over I2C, with four single-ended or two differential input channels and a...