Brands and Manufacturers

SKU: SF-COM-18161 | Brand: SparkFun

Although small in size, KW4-Z5F roller microswitches are rated for controlling electrical loads ranging from logic level (computer based circuits) to power duty switching (up to 16.1 A and 250 Vac). The package size o...

SKU: AF-5309 | Brand: Adafruit

The Adafruit MSA311 is a compact, low-cost triple-axis accelerometer with 14-bit resolution and a rich set of built-in motion detection features. Very similar to the MSA301 but with an updated I2C address (0x62 instea...

SKU: AF-4899 | Brand: Adafruit

The Adafruit SPI Flash SD Card breakout features an XTSD 512 MB chip — an SD card in an SMT package that you can wire up like standard SPI flash but use with existing SD card libraries. It comes pre-formatted as a 512...

SKU: DF-DFR0827 | Brand: DFRobot

PiTray mini is a Model B liked carrier board for building cluster with Raspberry Pi Computed Module 4 (CM4). PiTray mini focuses on providing a neat and budget solution for CM4 applications. With the same outline...

SKU: DF-DFR0745 | Brand: DFRobot

Wanna buy a simple & practical voice recorder? This one is right for you! The voice recorder module supports 4 controlling modes (Arduino, AT command, on-board buttons, and ADKEY), and multi-segment voice recording. Y...

SKU: AF-4759 | Brand: Adafruit

The Feather M4 CAN Express upgrades the popular Feather M4 platform with the ATSAME51J19 processor, which adds built-in CAN bus support. It features a 120 MHz Cortex M4 with hardware floating point and DSP instruction...

SKU: EC-DPO28090B | Brand: Elecrow

The NodeMCU V2 is a Wi-Fi development board based on the ESP8266 (ESP-12E module) with an on-board PCB antenna and USB programming interface. It supports 802.11 b/g/n wireless networking and can operate in STA, AP, or...

SKU: SF-DEV-17287 | Brand: SparkFun

The BBC micro:bit v2.21 is your gateway to hands-on learning, creativity, and innovation with digital technology. This pocket-sized powerhouse packs impressive features into a board that’s half the size of a credit ca...

SKU: AF-4663 | Brand: Adafruit

The 6V Air Valve (FA0520E) is a 3-port solenoid valve for pneumatic systems, functioning similarly to an electrical relay. It features a common port (COM), a normally open port, and a normally closed port, allowing yo...

SKU: AF-4711 | Brand: Adafruit

The AP3429A Buck Converter Breakout steps down 3.4–5.5V input to a stable 3.3V output at up to 1.2A, with 90–95% efficiency. It's ideal for powering 3.3V circuits from LiPo batteries, 3× alkaline cells, or USB power s...

SKU: EC-PCW10301C | Brand: Elecrow

This is a Type-B USB cable, which is compatible with Arduino Uno. It's a 3m cable and long enough for normal use.

SKU: EC-ARS27361T | Brand: Elecrow

This motor shield uses dual TB6612 MOSFET drivers and a PCA9685PW I2C PWM controller to drive up to 4 DC motors or 2 stepper motors from an Arduino or compatible board. All motor control and speed management is handle...

SKU: EC-ACS15238R | Brand: Elecrow

The RFM69HCW is an inexpensive and versatile radio module that operates in the unlicensed ISM (Industry, Science and Medicine) band, a set of frequencies set aside for low-power, short-range, license-free radios. I...

SKU: EC-ACA30002A | Brand: Elecrow

The Component Kit for Arduino E3 is a starter-friendly assortment of essential electronic components for use with any Arduino-compatible board. It includes a broad range of resistor values, LEDs in four colours, tacti...

SKU: DF-DFR0647 | Brand: DFRobot

A compact 0.91-inch monochrome OLED display module with 128×32 white self-illuminating pixels, driven by the SSD1306 over I2C. The chip-on-back pad design and ultra-narrow PCB (41 × 12 mm) make it ideal for wearables,...

SKU: AF-4488 | Brand: Adafruit

The Adafruit LIS2MDL is a triple-axis magnetometer (compass) breakout from ST, capable of sensing magnetic fields across a wide ±50 gauss (±5000 µT) range with no range configuration required. It's ideal for detecting...

SKU: EC-DRA43145S | Brand: Elecrow

This black acrylic case is designed to house and protect the official Raspberry Pi 7-inch touchscreen display. It consists of three layers of acrylic plate with two triangular support brackets, creating a stable, free...

SKU: AF-4489 | Brand: Adafruit

Run two solenoids, or a single DC motor with up to 800mA per channel using the super-simple L9110H H-bridge driver. This bridge chip is an 8 DIP package so it's easy to fit onto any breadboard or perfboard.Each chip c...

SKU: SF-DEV-15795 | Brand: SparkFun

Here at SparkFun, we refuse to leave 'good enough' alone. That's why we're adding to our line-up of Arduino-compatible microcontrollers once more! The SparkFun Qwiic Pro Micro is a revision of the original Pro Micro a...

SKU: LB-TILT | Brand: Little Bird

A simple tilt sensor module that detects orientation changes. When tilted, the internal conductive ball breaks the circuit; when returned upright, it reconnects — providing a digital output signal. It's a compact, low...