Brands and Manufacturers

SKU: LB-FLAME-LIGHT | Brand: Little Bird

This IR flame sensor module detects flames and infrared light sources in the 760–1,100 nm wavelength range. With a detection angle of approximately 60° and a test range of up to 80 cm (depending on flame size), it pro...

SKU: LB-LS6232 | Brand: Little Bird

For better audio quality when playing music, consider using a USB audio card with your Raspberry Pi. This upgrade can greatly enhance sound quality and volume since the on-board audio is produced through a minimally f...

SKU: KI-5647 | Brand: Kitronik

The Prong Soil Moisture Sensor mounts directly onto a BBC micro:bit to monitor soil moisture levels. Two conductive tines are inserted into the soil — any moisture conducts an analogue voltage that the micro:bit reads...

SKU: SF-DEV-15845 | Brand: SparkFun

This is the Teensy Audio Adapter Board that can be added to a Teensy 4.0 for your next audio project. The shield provides you with an easy-to-use tool to add high quality 16 bit, 44.1 kHz sample rate audio to your Tee...

SKU: DF-DFR0675-EN | Brand: DFRobot

This is a small size and cost-effective Bluetooth 5.0 digital amplifier module with a volume adjustment function. It can connect to two speakers and match a wide variety of high-power speakers (40W-200W). This boar...

SKU: AF-356 | Brand: Adafruit

These are our favorite trim pots, perfect for breadboarding and prototyping. They have a long grippy adjustment knob and with 0.1" spacing, they plug into breadboards or perfboards with ease. This is the same pot t...

SKU: AF-3857 | Brand: Adafruit

The Feather M4 Express is built around the ATSAMD51J19, a 120 MHz Cortex M4 processor with hardware floating point and DSP instructions, 512 KB flash, and 192 KB RAM. It ships with CircuitPython pre-loaded — plug it i...

SKU: SF-SEN-15901 | Brand: SparkFun

This Weather Meter Kit provides the three core sensors for a DIY weather station: an anemometer (wind speed), a wind vane (wind direction), and a rain gauge. All three sensors use passive magnetic reed switches rather...

SKU: AF-1475 | Brand: Adafruit

The Raspberry Pi has an on-board audio jack, which is super handy for all kinds of sound effects and speech, just plug and go! However, for when you want better audio for music playback, a USB audio card can greatly i...

SKU: AF-1739 | Brand: Adafruit

This large enclosed piezo element (30 mm diameter) converts vibration to voltage and voltage to vibration, making it useful both as a buzzer for generating tones and as a sensor for detecting knocks and impacts. The e...

SKU: AF-2831 | Brand: Adafruit

This Photo Transistor Light Sensor is a simple sensor that detects ambient light. It's kind of the opposite of an LED - when light hits the little chip inside, it induces current to flow from the long pin...

SKU: SF-SEN-10293 | Brand: SparkFun

A simple piezo element that can be used as both a sensor and a small audio transducer. When flexed or tapped, it generates a voltage that can be read by a microcontroller, making it ideal for knock and vibration detec...

SKU: AF-3405 | Brand: Adafruit

The Adafruit HUZZAH32 ESP32 Feather Board brings the powerful Espressif ESP32 dual-core processor into the Adafruit Feather form factor. With WiFi, Bluetooth Classic, and BLE support, a built-in USB-to-serial converte...

SKU: WS-25506 | Brand: Waveshare

Waveshare RP2040-PiZero Development Board, Based On The Raspberry Pi RP2040 Dual-core Processor, 264KB SRAM and 16MB onboard Flash memory, compatible with Raspberry Pi 40PIN GPIO header RP2040-PiZero Development Bo...

SKU: DF-DFR0052 | Brand: DFRobot

The DFRobot Vibration Sensor buffers a piezoelectric transducer that responds to strain changes by generating a measurable output voltage change which is propotional with the strength of vibration.So you can know the...

SKU: AF-165 | Brand: Adafruit

The TMP36 is a low-power analog temperature sensor that outputs a voltage proportional to ambient temperature. It operates on 2.7–5.5V and requires no external calibration — simply read the analog voltage and convert ...

SKU: AF-3333 | Brand: Adafruit

The Circuit Playground Express is an all-in-one development board packed with sensors, LEDs, and a speaker — all on a round, beginner-friendly PCB with alligator-clip pads. No soldering required. It supports four prog...

SKU: AF-5463 | Brand: Adafruit

This rubber sheet is made of the same carbon-black impregnated rubber material that our conductive rubber cord uses. Traditionally it would be used for EMF shielding, or conductive gaskets - but it's very fun to play ...

SKU: SF-SEN-14727 | Brand: SparkFun

This miniature straight bar load cell (sometimes called a strain gauge) can translate up to 100g of pressure (force) into an electrical signal. Each load cell is able to measure the electrical resistance that cha...

SKU: AF-2796 | Brand: Adafruit

The Feather M0 Adalogger is an all-in-one datalogger built around the ATSAMD21G18 ARM Cortex M0 processor, with a built-in MicroSD card holder, native USB, and LiPo battery charging. With 256KB of flash and 32KB of RA...