Arduino Sensors

SKU: DF-SEN0253 | Brand: DFRobot

This compact Gravity module combines a Bosch BNO055 absolute orientation sensor with a BMP280 barometric pressure and temperature sensor to create a 10DOF AHRS module for motion, heading and environmental sensing.The ...

SKU: DF-SEN0661 | Brand: DFRobot

This Gravity-series module is a high-precision electrochemical sensor for monitoring formaldehyde (HCHO) in indoor air. It is built around Sensirion’s SFA40 sensing chip and is designed to selectively detect HCHO whil...

SKU: DF-SEN0469 | Brand: DFRobot

This calibrated gas sensor measures ammonia concentration in the environment using an electrochemical probe. It supports three output modes — analogue, I2C and UART — so it can slot into a wide range of microcontrolle...

SKU: SF-GPS-23288 | Brand: SparkFun

Bring high-precision GNSS positioning to your project with the u-blox NEO-F9P engine and dual-band L1/L5 reception. L5 signals sit in the protected ARNS band, helping reduce RF interference and improve reliability in ...

SKU: SF-KIT-23452 | Brand: SparkFun

Get started with high-precision RTK GNSS and dead reckoning using u-blox's ZED-F9R module. This kit combines a sensor-fusion GPS breakout, a multiband SMA antenna and a USB cable so you have the core hardware needed f...

SKU: SF-GPS-22693 | Brand: SparkFun

This high-precision GNSS breakout is built around the u-blox ZED-F9R, combining RTK positioning with Automotive Dead Reckoning (ADR) sensor fusion. It fuses a 3D IMU sensor, wheel ticks, a vehicle dynamics model, corr...

SKU: SF-SEN-29529 | Brand: SparkFun

This ultra-small Qwiic-enabled breakout adds three-axis acceleration sensing to compact projects using the LIS3DH, a smart, low-power capacitive micro-machined accelerometer with 12-bit resolution. It can be used for ...

SKU: SF-GPS-30018 | Brand: SparkFun

Built around the u-blox SAM-M8Q module, this compact GNSS receiver is a straightforward way to add location tracking to a project. Plug in USB-C for power and configuration, or use the Qwiic connectors for solder-free...

SKU: SF-GPS-30975 | Brand: SparkFun

Built around the u-blox ZED-F9T-20B receiver, this breakout is made for projects where precise time matters as much as location. Under clear skies it can provide five nanoseconds of timing accuracy without requiring e...

SKU: SF-SEN-23220 | Brand: SparkFun

Measure visible and near-infrared light with a compact Qwiic breakout based on the AS7343 multi-spectral sensor. It covers approximately 380nm to 1000nm and is suited to reflected, emitted and transmitted light measur...

SKU: DF-SEN0646 | Brand: DFRobot

This ultra-compact dToF laser ranging sensor uses 940nm laser pulses to measure distance up to 7.8 metres with typical ±4cm accuracy. It is designed for precise, real-time ranging in compact robotics, drone, IoT and a...

SKU: AF-6489 | Brand: Adafruit

This breakout makes it easy to add 3D Hall-effect magnetic sensing to a microcontroller project. The TMAG5273 integrates independent X, Y and Z Hall-effect sensors with a 12-bit ADC, giving you magnetic measurements o...

SKU: AF-6064 | Brand: Adafruit

Need approximate distance sensing over tens of centimetres to around a metre, plus ambient light measurement from the same board? This breakout carries Vishay’s VCNL4200, a two-in-one IR proximity and ambient light se...

SKU: SF-SEN-31437 | Brand: SparkFun

Monitor DC current and power over I2C with this Qwiic breakout based on the Texas Instruments INA237 digital power monitor. It measures current, bus voltage, internal temperature and power for an in-line DC input usin...

SKU: SF-SEN-31438 | Brand: SparkFun

This compact Qwiic breakout uses the Texas Instruments INA228 digital power monitor to measure DC current and power with high precision over I2C. The onboard 20-bit delta-sigma ADC supports readings for current, volta...

SKU: M5-U029 | Brand: Little Bird

Description HEART is build with MAX30100.. MAX30100 is a complete pulse oximetry and heartrate sensor system solution designed for the demanding requirements of wearable devices. The MAX30100 provides ...

SKU: AF-5989 | Brand: Adafruit

The Adafruit HDC3021 is a high-precision I²C temperature and humidity sensor breakout featuring the TI HDC302x series chip. With typical humidity accuracy of ±0.5% RH (and just 0.19% long-term drift) and temperature a...

SKU: DF-SEN0647 | Brand: DFRobot

The TOFSense F2 is a high-performance laser distance sensor using dTOF (Direct Time-of-Flight) technology. With 25m range, ±3cm accuracy, and 100Hz refresh rate, it's ideal for robotics, industrial automation, drones,...

SKU: WS-28730 | Brand: Waveshare

Elevate your precision measurement needs with our cutting-edge TOF (Time of Flight) Laser Range Sensor, designed for remarkable long-range detection with steadfast accuracy. Whether you're engineering automation solut...

SKU: M5-A006 | Brand: Little Bird

Description FACES Kit is a feast of functional panels, contains the most commonly used panels and keyboards with MEGA328processor inside, communication protocol through IIC(0x08) as slave mode. With these...