Arduino Sensors

SKU: DF-SEN0475 | Brand: DFRobot

Measure hydrogen fluoride concentration with a factory-calibrated electrochemical probe that supports analogue, I2C and UART output modes. It is designed for quickly building an HF concentration detector for industria...

SKU: DF-SEN0253 | Brand: DFRobot

This compact Gravity module combines a Bosch BNO055 absolute orientation sensor with a BMP280 barometric pressure and temperature sensor to create a 10DOF AHRS module for motion, heading and environmental sensing.The ...

SKU: DF-SEN0639 | Brand: DFRobot

This compact digital anemometer measures air velocity for embedded electronics and intelligent control systems. It is built around the Posifa PAV3015D thermal sensing element, using temperature differences across a th...

SKU: DF-SEN0469 | Brand: DFRobot

This calibrated gas sensor measures ammonia concentration in the environment using an electrochemical probe. It supports three output modes — analogue, I2C and UART — so it can slot into a wide range of microcontrolle...

SKU: SF-GPS-23288 | Brand: SparkFun

Bring high-precision GNSS positioning to your project with the u-blox NEO-F9P engine and dual-band L1/L5 reception. L5 signals sit in the protected ARNS band, helping reduce RF interference and improve reliability in ...

SKU: SF-GPS-22693 | Brand: SparkFun

This high-precision GNSS breakout is built around the u-blox ZED-F9R, combining RTK positioning with Automotive Dead Reckoning (ADR) sensor fusion. It fuses a 3D IMU sensor, wheel ticks, a vehicle dynamics model, corr...

SKU: SF-SEN-29529 | Brand: SparkFun

This ultra-small Qwiic-enabled breakout adds three-axis acceleration sensing to compact projects using the LIS3DH, a smart, low-power capacitive micro-machined accelerometer with 12-bit resolution. It can be used for ...

SKU: SF-GPS-30018 | Brand: SparkFun

Built around the u-blox SAM-M8Q module, this compact GNSS receiver is a straightforward way to add location tracking to a project. Plug in USB-C for power and configuration, or use the Qwiic connectors for solder-free...

SKU: SF-GPS-30975 | Brand: SparkFun

Built around the u-blox ZED-F9T-20B receiver, this breakout is made for projects where precise time matters as much as location. Under clear skies it can provide five nanoseconds of timing accuracy without requiring e...

SKU: DF-SEN0704 | Brand: DFRobot

This flexible thin-film array gives robots, wearables and HCI projects a compact way to sense where pressure is being applied. It integrates 36 independent sensing points into a 15 x 15mm active area, enabling real-ti...

SKU: DF-SEN0646 | Brand: DFRobot

This ultra-compact dToF laser ranging sensor uses 940nm laser pulses to measure distance up to 7.8 metres with typical ±4cm accuracy. It is designed for precise, real-time ranging in compact robotics, drone, IoT and a...

SKU: AF-6064 | Brand: Adafruit

Need approximate distance sensing over tens of centimetres to around a metre, plus ambient light measurement from the same board? This breakout carries Vishay’s VCNL4200, a two-in-one IR proximity and ambient light se...

SKU: AF-6051 | Brand: Adafruit

Add magnetic sensing to your project with this breakout built around the Texas Instruments DRV5032 digital Hall effect sensor. Its digital output changes when the magnetic flux density threshold is crossed, making it ...

SKU: LB-DHT11-SENSOR | Brand: Little Bird

The Little Bird DHT11 Temperature and Humidity Sensor Module provides calibrated digital temperature and humidity readings from a single sensor. Designed and made in Sydney, Australia, it requires no extra components ...

SKU: LB-LR0102 | Brand: Little Bird

The DHT22 (also known in Australia by RHT03) is a low cost humidity and temperature sensor with a single wire digital interface. The sensor comes pre-calibrated and in a breadboard compatible module form so you don...

SKU: DF-SEN0158 | Brand: DFRobot

Want a robot to hunt down heat objects or navigated with fire? This is a small form factor IR camera capable of tracking up to four heat/IR sources. The applications are plenty and can go from tracking of robots wi...

SKU: M5-U029 | Brand: Little Bird

Description HEART is build with MAX30100.. MAX30100 is a complete pulse oximetry and heartrate sensor system solution designed for the demanding requirements of wearable devices. The MAX30100 provides ...

SKU: PL-2458 | Brand: Pololu

The QTR-1A reflectance sensor carries a single infrared LED and phototransistor pair in an inexpensive, tiny 0.5" x 0.3" module that can be mounted almost anywhere and is great for edge detection and line fo...

SKU: AF-6174 | Brand: Adafruit

The Adafruit Sensirion SHT45 is the highest-accuracy sensor in the SHT4x family, delivering ±1.0% typical relative humidity accuracy and ±0.1 °C typical temperature accuracy. Featuring a PTFE membrane for protection a...

SKU: TB-XC4478 | Brand: Little Bird

A compact 3-axis accelerometer module based on the ADXL335 sensor IC. Measures acceleration along the X, Y, and Z axes with a range of ±3g, providing one analogue output channel per axis. Useful for detecting motion, ...