All Products

SKU: SF-SEN-09269 | Brand: SparkFun

Breakout board for the 3 axis ADXL335 from Analog Devices. This is the latest in a long, proven line of analog sensors - the holy grail of accelerometers. The ADXL335 is a triple axis MEMS accelerometer with extremely...

SKU: SF-SEN-13968 | Brand: SparkFun

The SparkFun OpenPIR is a highly customizable Passive Infrared (PIR) sensor based around the NCS36000 PIR controller. Passive infrared (PIR) sensors are able to detect motion in a small/local area –– they’re the senso...

SKU: SF-DEV-13956 | Brand: SparkFun

The SparkFun Weather Shield is an easy-to-use Arduino shield that grants you access to barometric pressure, relative humidity, luminosity and temperature. There are also connections on this shield to optional senso...

SKU: SF-SEN-00250 | Brand: SparkFun

10K thermistor with a negative temperature coefficient. Good choice for temp-sensing applications when you need a reliable NTC thermistor. Vishay part #: NTCLE100E3103JB0 Note: You get only one thermistor. Document...

SKU: SF-SEN-13763 | Brand: SparkFun

A low-cost, highly accurate digital humidity and temperature sensor breakout board based on the Silicon Labs Si7021. Communicates over I²C with just two data lines, providing relative humidity and precise temperature ...

SKU: DF-SEN0134 | Brand: DFRobot

The Gravity MQ-9 gas sensor detects carbon monoxide (CO) and combustible gases including methane and propane. It uses a semiconductor SnO2 sensing element that cycles between high and low temperatures — detecting CO a...

SKU: AF-381 | Brand: Adafruit

This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PVC ...

SKU: AF-364 | Brand: Adafruit

The PN532 is the most popular NFC chip, and is what is embedded in pretty much every phone or device that does NFC. It can pretty much do it all, such as read and write to tags and cards, communicate with phones (s...

SKU: SF-SEN-09836 | Brand: SparkFun

This new version adds 2 standoff holes as well as an extra decoupling capacitor. The ADXL345 is a small, thin, low power, 3-axis MEMS accelerometer with high resolution (13-bit) measurement at up to +-16 g. Digital...

SKU: LB-ABX00162 | Brand: Little Bird

Meet Arduino UNO Q — a dual-processor development board that combines a Debian-based Linux computer with a real-time microcontroller. Build robots, edge-AI systems, and connected IoT devices on a single platform where...

SKU: DF-DFR1199 | Brand: DFRobot

An all-in-one stepper motor module combining the 28BYJ-48 geared stepper with an A4988 driver on a single board. The simplified 4-pin interface (STEP, DIR, 5V, GND) connects directly to Arduino, Raspberry Pi, or ESP32...

SKU: FT-MCULABEL | Brand: Freetronics

A set of 10 self-adhesive pinout labels for ATmega328 and ATmega168 microcontrollers. Stick one on top of your DIP-package chip and instantly see the Arduino pin mapping for each physical pin — no more checking datash...

SKU: DF-SEN0641 | Brand: DFRobot

The RS485 PAR Sensor measures photosynthetically active radiation in the 400–700 nm wavelength range — the light spectrum that plants use for photosynthesis. It converts incident radiation into a signal proportional t...

SKU: DF-DFR1085 | Brand: DFRobot

##Introduction The new Arduino UNO R4 comes in two versions: the UNO R4 WiFi and the UNO R4 Minima. It runs on the Renesas RA4M1 (Arm Cortex®-M4) processor, with a clock speed of 48MHz, which provides a 3x increase ov...

SKU: DF-SEN0623 | Brand: DFRobot

The C1001 mmWave Human Detection Sensor is a high-precision 60GHz millimeter-wave radar sensor engineered for advanced human detection. Unlike standard 24GHz millimeter-wave sensors that are limited to detecting prese...

SKU: SF-SEN-22494 | Brand: SparkFun

The STHS34PF80 sensor, from ST Microelectronics, is designed to measure the precise black-body radiation (as described by Planck's law) of an object; as well as monitor ambient temperature conditions within its 80° fi...

SKU: LB-PIR-CABLE | Brand: Little Bird

A compact passive infrared (PIR) motion sensor housed in a protective case with a 45cm cable. Detects motion within a 6-metre range and 120° field of view, making it ideal for security systems, automatic lighting, and...

SKU: AF-5651 | Brand: Adafruit

An I2C breakout board for the RDA5807M FM radio chip, designed by ScoutMakes as a beginner-friendly introduction to electronics and wireless communications. Tune into FM stations, display RDS data (station and song na...

SKU: PL-5030 | Brand: Pololu

The Motoron M3S256 Triple Motor Controller Shield for Arduino makes it easy to control DC motors from an Arduino or Arduino-compatible board through an I²C interface. Each module can independently control up to three ...

SKU: LB-FINCH-5 | Brand: Little Bird

Bulk pack of 5The Little Bird Finch is our smallest programmable board. The Finch is a tiny little  board designed to add flashy functionality to your project without taking up a lot of room. It has an ...