All Products

SKU: AF-355 | Brand: Adafruit

When you need to switch a lot of power, N channel MOSFETs are best for the job. These FETs can switch over 60A and 30V and are TO-220 package so they fit nicely into any breadboard or perfboard. Heat sinking is eas...

SKU: AF-369 | Brand: Adafruit

If you need to connect a battery pack or wired power supply to a board that has a DC jack - this adapter will come in very handy! There is a 2.1mm DC plug on one end, and a screw terminal block on the other. The termi...

SKU: SF-DEV-11114 | Brand: SparkFun

It’s blue! It’s thin! It’s the Arduino Pro Mini! SparkFun’s minimal design approach to Arduino. This is a 3.3V Arduino running the 8MHz bootloader. Arduino Pro Mini does not come with connectors populated so tha...

SKU: AF-189 | Brand: Adafruit

PIR sensors are used to detect motion from pets/humanoids from about 20 feet away (possibly works on zombies, not guaranteed). This one has an adjustable delay before firing (approx 2-4 seconds), adjustable sensiti...

SKU: AF-3174 | Brand: Adafruit

This is a box of ten 25ft spools of solid-core wire. The wire is easy to solder to, and when bent it keeps its shape pretty well. We like to have a few spools of this stuff around which is why this set is quite n...

SKU: AF-449 | Brand: Adafruit

This 8×AA battery holder provides a portable 12V power source by connecting 8 AA batteries end-to-end in series. It delivers approximately 12VDC with alkaline cells (9.6V with NiMH rechargeables) and supports up to 2A...

SKU: SF-PRT-12978 | Brand: SparkFun

A pack of 10 multicoloured alligator-to-alligator clip test leads — an essential for any electronics workbench. Whether you're making quick connections to test a circuit or extending your multimeter leads, these sprin...

SKU: SF-COM-10632 | Brand: SparkFun

Check out these big 10mm through-hole LEDs! The opaque epoxy package causes these LEDs to have a soft, diffuse glow.

SKU: PL-1900 | Brand: Pololu

These single-pin crimp connector housings let you quickly build custom cables that mate with standard 0.1" (2.54mm) spaced connectors. Simply pair them with pre-crimped terminal wires or crimp pins to create reliable,...

SKU: AF-640 | Brand: Adafruit

After months of searching, we finally have what we consider to be the ultimate conductive thread. It's thin, strong, smooth, and made completely of 316L stainless steel. Once you start working with this thread you'...

SKU: SF-SEN-10266 | Brand: SparkFun

Use this simple IR receiver for infrared remote control of your next project. With low power consumption and an easy to use package, it mates well with embedded electronics and can be used with common IR remotes. The...

SKU: SF-DEV-12640 | Brand: SparkFun

Here at SparkFun, we refuse to leave ‘good enough’ alone. That’s why we’re adding to our line-up of Arduino-compatible microcontrollers once more! The Pro Micro is similar to the Pro Mini except with an ATmega32U4 on ...

SKU: DF-FIT0484 | Brand: DFRobot

INTRODUCTION A new micro metal gear motor with a difference! This motor comes with a built-in encoder which measures the motor's speed in real time. The average output number of pulses ca...

SKU: SF-PRT-12615 | Brand: SparkFun

A standard full-size solderless breadboard with 830 tie points for prototyping electronic circuits. The two sets of five columns are separated by a 0.3″ channel — perfectly sized for straddling DIP IC packages. Split ...

SKU: SF-SWG-10108 | Brand: SparkFun

This handy resistor code sticker allows you to decipher the color coded bands on resistors and determine their value. It measures about 4" x 5" and is adhesive-backed for sticking to your wall, workbench, or coworker.

SKU: SF-COM-09806 | Brand: SparkFun

There are lots of trimpots out there. Some are very large, some so small they require a screwdriver. Here at Little Bird, we just needed a simple one that worked. This 10K trimmable potentiometer has a small knob...

SKU: SF-DEV-09718 | Brand: SparkFun

The FTDI Cable is a USB-to-Serial (TTL level) converter that provides a simple way to connect TTL interface devices to USB. Built around the FTDI FT232RQ chip housed in the USB-A connector, this cable operates at 5V l...

SKU: AF-4867 | Brand: Adafruit

The Adafruit SCD-30 is a true NDIR (Non-Dispersive Infrared) CO2 sensor that directly measures carbon dioxide concentration in ambient air, rather than estimating it from volatile organic compounds. With an integrated...

SKU: SF-SEN-09375 | Brand: SparkFun

This is a force sensitive resistor with a round, 0.5" diameter, sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the ...

SKU: LB-LS2429 | Brand: Little Bird

Totalling 1080 pieces, this Stainless Steel Screws and Nuts Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker tendencies for days on end! These screws will ...