All Products

SKU: SF-SEN-22397 | Brand: SparkFun

The SparkFun BMI270 6DoF IMU Breakout is a Qwiic-enabled board featuring the ultra-low-power BMI270 inertial measurement unit from Bosch. It combines a 16-bit tri-axial accelerometer and 16-bit tri-axial gyroscope wit...

SKU: DF-DFR0996 | Brand: DFRobot

A Magnetic latching relay is a new type of relay.  It features low power dissipation and noiseless.  Unlike other non-latching relay, the latching relay needs two digital pulse signal to switch ON/OFF state....

SKU: AF-5665 | Brand: Adafruit

The Adafruit Sensirion SHT45 is the highest-accuracy sensor in the SHT4x family, delivering ±1.0% typical relative humidity accuracy and ±0.1 °C typical temperature accuracy. This version does not include a PTFE membr...

SKU: LB-LR0097-1-NEW | Brand: Little Bird

This infra-red receiver module is perfect for Arduino projects. It has a wide range of applications, including remote control, wireless data transmission, etc.

SKU: DF-DFR0719 | Brand: DFRobot

A compact Bluetooth 5.0 audio receiver board that turns any wired speaker into a wireless one. Simply connect power (3.7–24V) and wire up your speaker — pair it with your phone and start streaming music wirelessly. Th...

SKU: AF-5181 | Brand: Adafruit

The AM2301B is an affordable enclosed temperature and humidity sensor featuring an I2C interface — a modern upgrade over the classic DHT22/AM2302 sensors that required bit-bang timing protocols. Inside is the proven A...

SKU: AF-5027 | Brand: Adafruit

The Adafruit MCP9808 is a high-accuracy digital temperature sensor with ±0.25°C typical accuracy over its −40°C to +125°C range and 0.0625°C resolution. It communicates over standard I2C and runs on 2.7V to 5.5V power...

SKU: AF-4570 | Brand: Adafruit

The Adafruit DS1841 is an I2C-controlled logarithmic digital potentiometer from Maxim with a resistance range of 3.7 kΩ to 22 kΩ across 128 tap points. Unlike linear potentiometers, the DS1841's logarithmic response c...

SKU: AF-3967 | Brand: Adafruit

The Adafruit VL53L1X (also known as VL53L1CX) is a next-generation Time-of-Flight (ToF) distance sensor from ST with an impressive 4-metre range and LIDAR-like precision. Using an invisible laser and matching sensor, ...

SKU: AF-5309 | Brand: Adafruit

The Adafruit MSA311 is a compact, low-cost triple-axis accelerometer with 14-bit resolution and a rich set of built-in motion detection features. Very similar to the MSA301 but with an updated I2C address (0x62 instea...

SKU: DF-SEN0497 | Brand: DFRobot

The DHT20 temperature & humidity sensor is the newly upgraded version of the DHT11. Data accuracy, stability, response speed, measurement range are greatly improved up. DHT20 is a brand new ASIC dedicated chip, an imp...

SKU: AF-4899 | Brand: Adafruit

The Adafruit SPI Flash SD Card breakout features an XTSD 512 MB chip — an SD card in an SMT package that you can wire up like standard SPI flash but use with existing SD card libraries. It comes pre-formatted as a 512...

SKU: DF-DFR0745 | Brand: DFRobot

Wanna buy a simple & practical voice recorder? This one is right for you! The voice recorder module supports 4 controlling modes (Arduino, AT command, on-board buttons, and ADKEY), and multi-segment voice recording. Y...

SKU: AF-4711 | Brand: Adafruit

The AP3429A Buck Converter Breakout steps down 3.4–5.5V input to a stable 3.3V output at up to 1.2A, with 90–95% efficiency. It's ideal for powering 3.3V circuits from LiPo batteries, 3× alkaline cells, or USB power s...

SKU: AF-4488 | Brand: Adafruit

The Adafruit LIS2MDL is a triple-axis magnetometer (compass) breakout from ST, capable of sensing magnetic fields across a wide ±50 gauss (±5000 µT) range with no range configuration required. It's ideal for detecting...

SKU: AF-4494 | Brand: Adafruit

The Adafruit DPS310 is a high-precision barometric pressure and altitude sensor from Infineon, mounted on a breakout board with STEMMA QT / Qwiic connectors for solderless I2C wiring. It delivers ±1 hPa absolute accur...

SKU: LB-TILT | Brand: Little Bird

A simple tilt sensor module that detects orientation changes. When tilted, the internal conductive ball breaks the circuit; when returned upright, it reconnects — providing a digital output signal. It's a compact, low...

SKU: DF-DFR0231-H | Brand: DFRobot

Gravity: UART & I2C NFC Module adopts NXP PN532, a highly integrated NFC communication controller, which supports various types of NFC smart cards or tags like the commonly used MIFARE Classic series and NTAG series i...

SKU: LB-JSTBOARD | Brand: Little Bird

This E-textiles board is a breakout for a JST, so you can sew it onto a garment or use it in Paper Circuits! The JST breakout board can be easily sewn through the large holes. For paper circuits, simply apply coppe...

SKU: DF-SEN0250 | Brand: DFRobot

The BMI160 6-axis inertial motion sensor is a new product from DFRobot. It is based on Bosch BMI160 6-axis MEMS sensor which integrates 16-bit 3-axis accelerometer with ultra-low-power 3-axis gyroscope. Bosch BMI160 ...