All Products

SKU: SF-COM-12096

This 0.012" Flexinol® Actuator Wires (aka shape memory Nitinol) is a one foot long piece of nickel-titanium alloy that can flex and contract when a specific amount of heat or current is applied to it and are made specifically for linear actuators to replace small motors or solenoids. If you are a...

SKU: SF-COM-00540

Standard ‘Watch’ or Real-Time-Clock crystal. 32.768kHz means it is precisely half of a 16-bit counter. Start counting at 0x8000 (or 32768). When the counter rolls over from 65535 to 0, then you know that exactly one second has passed. Reset the interrupt, reset the counter, and start counting aga...

SKU: SF-DEV-21326 · MPN: DEV-21326

This compact MicroMod processor board adds an STM32F405 to a compatible MicroMod Carrier Board, giving your project an ARM® Cortex®-M4 32-bit RISC core in a small, swappable M.2 module.The bevelled edge connector keys into the MicroMod M.2 socket and is secured with the screw supplied with MicroM...

SKU: AF-4133

A compact 10K ohm linear potentiometer with a built-in knurled plastic knob — no separate knob needed. The 0.1" pin spacing plugs directly into a standard breadboard, making it perfect for prototyping and quick adjustments. Larger than a trim-pot but smaller than a full-size panel-mount potentio...

SKU: AF-1387

Build custom USB connections without slicing apart a cable and soldering those thin internal wires. This DIY USB shell gives you a proper Type A male plug connector with easy-to-solder tabs and a two-part snap-together plastic housing. Key Features Easy-to-Solder Tabs – Large solder points for...

SKU: AF-1389

Make your own USB connections without slicing apart a USB cable and soldering those thin wires inside. These DIY "USB shells" are available in USB A plug, micro B, mini B and USB A socket.Each shell comes with a two-part snap plastic shell and a proper connector with easy-to-solder tabs.

SKU: AF-1388

Make your own USB connections without slicing apart a USB cable and soldering those thin wires inside. These DIY "USB shells" are available in USB A plug, micro B, mini B and USB A socket.Each shell comes with a two-part snap plastic shell and a proper connector with easy-to-solder tabs.

SKU: SF-TOL-09317

This is a solderer’s best helper, the third hand. Comes with a heavy base, two alligator clips, a soldering iron holder, and a good magnifying glass. Note that we don’t normally need a third hand. It’s nice, but soldering flat on a table works just fine. Then again, the desk is starting to loo...

SKU: AF-1446

This stuff is called "wire-wrap wire" because it used to be used for wire-wrapping high-speed digital circuits on a special kind of contact board. It's pretty rare to see wire-wrapping in these days of low-cost PCB fabrication but the wire is still really handy for prototyping work. It's extre...

SKU: DF-DFR0123

This 20W adjustable DC-DC boost converter with a digital display is based on the professional boost chip and supports 3~32V power input, 5~35V output, and an accuracy of ±0.05V. The switching frequency is 400KHz, the conversion efficiency can reach 94%, it has the functions of overheating prote...