All Products
Showing 41-51 of 51 products · 9 unavailable products hidden
22-pin 0.5mm pitch FPC Flex Cable for DSI CSI or HSTX - 5cm
·
A compact 22-pin flexible flat cable (FPC) with 0.5mm pitch, just 5cm in length. This A-B style cable has matching pin orientation on both ends — pin 1 on one side aligns with pin 1 on the other — ideal for compact builds where the peripheral sits close to the main board. Designed to work with R...
10 sets M3 * 50 hexagonal standoffs mounting kit
A 10-pack of M3 × 50mm hexagonal standoffs with matching screws and nuts. Use them to mount circuit boards, sensors, and other components with consistent 50mm spacing and secure mechanical support. At 50mm height, these are the tallest in the range — ideal for multi-level robot chassis builds, e...
PCIe Flex Cable for NVMe Base and Raspberry Pi 5 – PCIe Pipe
·
This PCIe Flex Cable gives you a variety of options for connecting and placing your Pimoroni NVMe Base with Raspberry Pi 5. They have a 'one way' design with 16 pads at the Raspberry Pi 5 end and 18 pins at the NVMe Base end to prevent incorrect installation. The designed is set up for PCIe Gen 3...
NeoPixel LED Outdoor Netting - 40 x 20 LEDs
·
Creating large LED grids just got easier with this ready-to-use NeoPixel LED Outdoor Netting! No need to piece together multiple strips—this 40x20 RGB LED matrix delivers a seamless 800-pixel display, all controlled with a single data pin. Key Features: 800 RGB LEDs arranged in a 40x20 grid, wi...
DFRobot AS7341 11-Channel Visible Light Sensor-Breakout
This compact breakout uses the AMS AS7341 spectral sensor IC to measure colour across multiple visible-light bands. It is designed for projects that need more detail than a basic RGB colour sensor, with channels covering the visible spectrum plus near-IR and an unfiltered channel.The board includ...
EYESPI Cable - 18-pin 50mm long Flex PCB (FPC) A-B Type
·
Connect this to that when an 18-pin FPC connector is needed. This 50mm long cable is made of a flexible PCB. It's A-B style which means that pin one on one side will match with pin one on the other side. How handy! We're stocking this to fit with our EYESPI-compatible boards, but you could, of co...
5V Square USB Fan - 6 cm
·
A compact 60mm USB-powered cooling fan that provides instant airflow for electronics projects. Simply plug into any USB port for immediate cooling — no drivers or setup required. The USB connector can be cut off to wire the fan directly to a 5V power source. While there's no built-in PWM or feed...
GPIO Terminal Block Breakout Board Module for Raspberry Pi
This terminal block breakout module comes fully assembled and soldered, ready for use with Raspberry Pi boards.It is compatible with Raspberry Pi 1 Model B+, Pi 2 Model B, Pi 3 Model B, Pi 3 Model B+, Pi 4 Model B, Pi Zero, and Pi Zero W.The module features 2.54 mm (0.1″) pitch terminal blocks su...
915MHz LoRa Antenna RP-SMA - 1/4 Wave 2dBi
A compact 1/4-wave rubber duck antenna for LoRa and other 860–960MHz communication. With a centre frequency of 915MHz and 2dBi gain, this 110mm antenna is ideal for space-constrained LoRa nodes where a smaller antenna is preferred. Specifications Frequency Range – 860–960MHz (centre 915MHz) G...
GPS Module with Enclosure
You must have used a GPS receiver. It is easy to be found in most places, such as smartphones, cars, and computers. They are used to track your loaction all over the globe. GPS Receiver for Arduino is a unit embedding GPS module and antenna in a small foot-print enclosure. By using TinyGPS li...
Raspberry Pi USB Free-drive Speaker
Raspberry Pi can not be used directly with the speaker, so this speaker is a built-in power amplifier dual-channel speaker, driver-free, USB power supply. Come with a volume decoder, it can adjust the volume. Note: Not includes the Raspberry Pi board.Specifcation: Size: 70 x 30mm Impedance...
