All Products

SKU: LB-SHAKEUP-DELUXE

The ShakeUp makes you a STE(A)M inventor by helping you to connect everyday objects to your computer. If you can plug in a Keyboard and Mouse, you can use the ShakeUp.  The Magic Science When you plug the ShakeUp into your computer, your computer thinks it's just a regular keyboard a...

SKU: AF-5708

The Adafruit CAN Pal is a CAN bus transceiver breakout for microcontrollers that have a native CAN peripheral. It converts 3.3V logic-level CAN TX/RX signals to the differential signalling required for the CAN bus. This is a transceiver only — it does not include a CAN controller, so your microco...

SKU: AF-2571

This 50-pin FPC extension board lets you add approximately 22cm of reach to any 50-pin, 0.5mm pitch FPC/FFC connection. The board features two 50-pin flex connectors with a 200mm (20cm) FPC cable included, giving a total extension of about 22cm when the board length is included. Works with 50-pi...

SKU: DF-MBT0044-1 · MPN: MBT0044-1

This bundle adds motor, servo and sensor expansion to the UNIHIKER M10 single-board computer, using the included Type-C to HY2.0-4P communication cable to bridge the M10 to the expansion board.The board includes an integrated 18650 battery holder so your controller, motors and sensors can run fro...

SKU: LB-SHAKEUP-STD

The ShakeUp makes you a STEAM inventor by helping you to connect everyday objects to your computer. If you can plug in a Keyboard and Mouse, you can use the ShakeUp.  The Magic Science When you plug the ShakeUp into your computer, your computer thinks it's just a regular keyboard and mous...

SKU: SF-PRT-16890

These are the surface mount 50 pin 0.5mm Board to Board Double Slot Female Connectors found on the Alchitry FPGA boards. These headers allow for Alchitry FPGA Boards to stack on one another by being soldered to the topside of the board.These connectors are sold in single units. Four of these conn...

SKU: KI-56115

The Kitronik :VIEW Graphics128 OLED display gives the user the ability to add a monochrome 128x64 display to the BBC micro: bit. The onboard edge connector allows the micro:bit to slot into the board without any additional fixings. The board also features a micro:bit style I/O connector which mea...

SKU: DF-DRI0054 · MPN: DRI0054

##Introduction The multifunctional motor driver expansion board is designed for Raspberry Pi Zero/Zero W/A+/B+/2B/3B/3B+/4B. This fully-featured robot motor expansion board is capable of supporting multiple motors, stepper motors, and servos simultaneously. It also provides spare camera and DIP d...

SKU: WS-24664

Waveshare RP2040-Tiny Development Board, Raspberry Pi Microcontroller Development Board, Based on Official RP2040 Dual Core Processor, USB Port adapter board Optional RP2040-Tiny Development Board Based On RP2040, USB Port Adapter Board Optional ...

SKU: SF-DD-27675 · MPN: DD-27675

This Thing Plus board is a wireless development platform built around the Raspberry Pi Foundation RP2350 microcontroller. It combines the familiar Thing Plus form factor with Qwiic expansion, a µSD card socket, USB-C, LiPo charging hardware and a fuel gauge for local or remote projects.The RP2350...

SKU: YH-6000300221

The 6WD expansion board is a versatile expansion board tailored for DIY, supporting four major controllers, including Raspberry Pi, Arduino UNO, STM32 and 51 controllers. You can switch between one of them to achieve a variety of creative gameplay. The motor drive module and expansion board are s...

SKU: PL-2739

The Pololu AltIMU-10 v5 is a compact inertial measurement unit (IMU) and altimeter that combines a gyroscope, accelerometer, magnetometer, and barometric pressure sensor on a single board. It provides ten independent measurements — pressure, 3-axis rotation, 3-axis acceleration, and 3-axis magnet...

SKU: WS-25081

A compact ESP32-S3 development board based on the ESP32-S3FH4R2 dual-core processor running at up to 240MHz. Features 4MB flash, 2MB PSRAM, 2.4GHz Wi-Fi (802.11 b/g/n), and Bluetooth 5 (LE). The castellated module design with on-board ceramic antenna allows direct soldering to carrier boards, mak...

SKU: WS-29927 · MPN: 29927

Transform your D-Robotics RDK X5 development board into a powerhouse of connectivity and reliability with the latest Power Over Ethernet Expansion Board. Designed to seamlessly integrate with the RDK X5, this PoE module not only simplifies your network setup by combining data and power into a sin...

SKU: EC-DTS01559G

This is a GPIO expansion board for Micro: bit, it’s convenient to operate. It can be inserted the expansion board directly into the Micro: bit, and this expansion board can be cascaded.SpecificationsSize: 64 x 37 x 12 mmPackage listMicro: bit GPIO expansion board x 1

SKU: EF-EF08413 · MPN: EF08413

The ELECFREAKS micro:bit Space Science Kit is a comprehensive STEAM education kit that lets students build space-themed projects and simulate moon missions. Powered by the Nezha Breakout Board V2, it includes PlanetX sensors, smart motors, over 400 building blocks, and a moon landing competition ...

SKU: DF-EDU0208-1 · MPN: EDU0208-1

This hands-on STEM kit helps students build a working smart watering system while learning about automated agriculture, water conservation and climate action. It combines BOSON environmental sensors and a water pump with the included UNIHIKER K10 AI Coding Board to monitor soil moisture and avail...

SKU: YH-6000300577

This expansion board is specially designed for the Uno board and can be plugged directly into the Uno board without a cable. Equipped with 4 motor interfaces, 4 servos interface, wifi camera interface, IIC interface, various sensor sockets, etc. It also expand all the pins of Uno board, which is ...

SKU: LB-LS1202

Oooh it's so soft and pretty! If you have to have visible cables then you might as well have the nicest fabric bound cable with a eye-catching snake-like pattern.  That's why we now carry this standard A to micro-B USB cable for USB 1.1 or 2.0. Perfect for connecting a PC to your BBC Micro:...

SKU: SF-PRT-16891

This surface-mount 50-pin board-to-board connector with 0.5 mm pitch and double-slot male configuration is used on Alchitry FPGA boards. Soldered to the underside of a board, these connectors allow Alchitry FPGA boards to stack on one another for modular expansion. Sold as a single connector — f...