Little Bird
STEM components for Raspberry Pi
The Little Bird STEM Components Kit for Raspberry Pi provides everything you need to start learning electronics. Packed with LEDs, resistors, buttons, sensor...
Get notified when back in stock
The Little Bird STEM Components Kit for Raspberry Pi provides everything you need to start learning electronics. Packed with LEDs, resistors, buttons, sensors, and an analog-to-digital converter, this kit is the perfect companion for hands-on Raspberry Pi projects.
Whether you're following along with a tutorial or experimenting on your own, this kit covers the essential components you'll reach for again and again when building circuits with your Pi.
Key Features
- Complete Starter Selection – LEDs, resistors, buttons, sensors, and an ADC in one box
- MCP3008 ADC Included – Read analog sensors with your Raspberry Pi via SPI
- DHT11 Temperature & Humidity Sensor – Get started with environmental sensing
- Wide Resistor Range – 10 values from 10 Ω to 1 MΩ, 20 of each
- Multiple LED Colours – White, yellow, blue, green, and red
Ideal For
- STEM education and classroom projects
- Learning electronics with Raspberry Pi
- Breadboard prototyping and experimentation
- Following along with Raspberry Pi tutorials and guides
Package Contents
- 5× White LEDs
- 5× Yellow LEDs
- 5× Blue LEDs
- 5× Green LEDs
- 5× Red LEDs
- 1× Breadboard Potentiometer
- 1× MCP3008 8-Channel 10-Bit ADC (SPI)
- 1× DHT11 Temperature and Humidity Sensor
- 6× Buttons 12 mm × 12 mm (round and square caps)
- 20× Resistors (10 Ω)
- 20× Resistors (100 Ω)
- 20× Resistors (220 Ω)
- 20× Resistors (330 Ω)
- 20× Resistors (1 kΩ)
- 20× Resistors (2 kΩ)
- 20× Resistors (5.1 kΩ)
- 20× Resistors (10 kΩ)
- 20× Resistors (100 kΩ)
- 20× Resistors (1 MΩ)
- 2× Pin Headers (40-pin)
Jargon buster
Plain-language definitions for the technical terms used above.
- ADC
- An analogue-to-digital converter reads a changing voltage and turns it into a number the microcontroller can use. It matters when connecting analogue sensors such as light, sound, or variable-resistor sensors.
- Headers
- Rows of connector contacts on a fixed pitch (commonly 2.54 mm) used to link a board to a breadboard, jumper wires, or another board. They come as male pin headers and female socket headers; when a module ships with pre-soldered headers it can be used straight away, whereas bare pads require soldering the pins yourself.
- LED
- A light-emitting diode (LED) is a small electronic component that emits light when current flows through it in the correct direction. Because it only conducts one way, its polarity matters, and a through-hole LED must be soldered the correct way around to light up.
- potentiometer
- A variable resistor usually turned with a knob or shaft to create an adjustable electrical signal. It is often used for inputs such as volume, brightness or position, so it helps beginners learn how a microcontroller reads changing values.
- SPI
- A fast serial communication bus often used for displays, memory cards, and sensors. It matters because SPI devices need specific pins for clock and data, plus a separate chip-select line for each device.
Find this product in
STEM & Education
