Adafruit
Stacking M2.5 Hardware Kit for STEMMA QT and RP2040 Trinkey
All Products
New Arrivals
Adafruit
Brands and Manufacturers
Electronics Kits
Components
Standoffs & Screws
Prototyping & Wiring
$3.08
|
Out of stock
Here is the perfect hardware kit to make a RP2040 QT Trinkey into any kind of USB-connected smart sensor with a QT-sensor-sandwich! You can assembl...
Estimated Delivery
Arrives
Disclaimer
Secure checkout
Here is the perfect hardware kit to make a RP2040 QT Trinkey into any kind of USB-connected smart sensor with a QT-sensor-sandwich! You can assemble it with just a plain Phillips screwdriver. Takes less than a minute to bolt on your favorite STEMMA QT or Qwiic board on top. And best of all, its stackable, so you could have multiple boards sandwiched on top of each other.
Includes:
- 4 x black nylon M2.5 M-F hex standoff
- 4 x black nylon M2.5 hex nuts
- 4 x black nylon M2.5 screw 4mm tall
Note: Neither Trinkey QT2040 nor sensor are included, just the nylon standoffs, screws, and nuts. You'll also definitely want a shorty 50mm Stemma QT cable.
Jargon buster
Plain-language definitions for the technical terms used above.
- M2.5
- A metric screw thread size with a 2.5 mm nominal diameter. It matters for mounting because screws, standoffs, and holes must use the same size to fit securely without damaging the board.
- Qwiic
- Qwiic is a plug-in connector system for I2C devices that uses small 4-pin cables, so you can connect compatible sensors without soldering. It matters because your controller or adapter also needs Qwiic, or you will need a cable or breakout to wire it up.
- STEMMA QT
- A small plug-in connector system for I2C boards that lets you connect compatible sensors and controllers without soldering. It matters because it can make wiring faster and less error-prone, especially when adding several small modules to a project.
Find this product in
Brands
Related Tutorials
Free guides on learn.littlebird.com.au
