Adafruit
Snap-on Enclosure for Adafruit Pixel Trinkey
· MPN: ADA5998
$4.05
|
In stock at supplier
Here is a cute and minimal enclosure for your Pixel Trinkey to keep it safe during use and transport. This case has been custom-designed and 3D printed to ac...
Get notified when back in stock
Estimated Delivery
Arrives
Disclaimer
Secure checkout
Here is a cute and minimal enclosure for your Pixel Trinkey to keep it safe during use and transport. This case has been custom-designed and 3D printed to accommodate the reset button, 3-pin JST SH port, and the 4 terminal block outputs. No screws or glue are required; simply snap the two pieces together over the Trinkey.
It's made of translucent milky white plastic with an SLA process, so you can still easily see the NeoPixel LED shining through, and there are no lines or blobbiness to the print.
No boards, cables, or accessories are included. Designed for the Pixel Trinkey only.
Jargon buster
Plain-language definitions for the technical terms used above.
- LED
- A light-emitting diode (LED) is a small electronic component that emits light when current flows through it in the correct direction. Because it only conducts one way, its polarity matters, and a through-hole LED must be soldered the correct way around to light up.
- NeoPixel
- A type of addressable LED system where colour data is sent along a single digital data line from one LED or controller to the next. Compatibility matters because the timing and signal format must match for the lights or driver board to respond correctly.
- Terminal block
- A terminal block is a connector that joins wires together in a neat, removable, or serviceable way, usually clamping each wire under a screw or spring instead of soldering. It makes it easier to connect, change, or service wiring without permanent joints.
Find this product in
Prototyping & Wiring
Related Tutorials
Free guides on learn.littlebird.com.au
