Adafruit
Male DC Power adapter - 2.1mm plug to screw terminal block
·
If you need to connect a battery pack or wired power supply to a board that has a DC jack - this adapter will come in very handy! There is a 2.1mm DC plug on...
Get notified when back in stock
If you need to connect a battery pack or wired power supply to a board that has a DC jack - this adapter will come in very handy! There is a 2.1mm DC plug on one end, and a screw terminal block on the other. The terminals are labeled with positive/negative assuming a positive-tip configuration (which is the most common)
Find this product in
Brands
Power & Batteries
You might also like
Customers who bought this also bought
Female DC Power adapter - 2.1mm jack to screw terminal block
$4.00
Motion Activated Audio Player with Two Separate PIR
$100.70
DC-DC 12V To 3.3V 5V Buck Step down Power Supply Module For Arduino
$6.00
USB A Jack to 5.5/2.1mm jack adapter
$6.30
Snap-action 5-Wire Block Connector (12-28 AWG) - Pack of 3
$9.95
9V to Barrel Jack Adapter
$1.35
Jumper Wires Premium 6 F/F - 20 AWG (10 Pack)
$15.65
Jumper Wires Premium 6 M/M - 20 AWG (10 Pack)
$15.65
Jargon buster
Plain-language definitions for the technical terms in the product description.
- DC
- DC means direct current, where electricity flows in one constant direction, as supplied by batteries, USB ports and many plug-pack power supplies. When a product specifies DC, it runs from a DC supply rather than mains AC, so you need to provide the correct voltage and polarity.
- Terminal block
- A terminal block is a connector that joins wires together in a neat, removable, or serviceable way, usually clamping each wire under a screw or spring instead of soldering. It makes it easier to connect, change, or service wiring without permanent joints.