LattePanda 2 Alpha 800s Kit with Titan Case & 7-inch Touch Display

Jargon buster

Plain-language definitions for the technical terms used above.

5G

A mobile network standard used for high-speed wireless data links. If a project uses a 5G gateway, its power system must be able to supply enough current reliably for outdoor or remote operation.

CE certification

A marking used in Europe to indicate that a product is declared to meet relevant safety, health, or environmental requirements. It can matter when choosing parts for school, workplace, or regulated projects, but it is not the same as an independent performance guarantee.

DisplayPort

A digital display interface used to connect monitors and other video displays. It matters because the supported DisplayPort version affects display resolution, refresh rate and monitor compatibility.

edge computing

Edge computing means processing data close to where it is collected, such as on the device itself, rather than sending everything to the cloud. This can reduce delays, internet dependence, and privacy concerns in sensor, camera, and robotics projects.

eDP

Embedded DisplayPort is an internal display connection commonly used between a computer board and a built-in screen. It matters because this display needs a matching eDP connector and support on the host board, so it will not plug into a normal HDMI-only output.

GPIO

General-purpose input/output pins are microcontroller pins you can set in software to read signals, switch devices on and off, or connect to peripherals. The number of GPIO pins matters because it limits how many buttons, LEDs, sensors, and other parts you can wire directly to the board.

HDMI

HDMI is a common digital video and audio connection used by computers, media players, and many displays. If a display kit has HDMI input, it is usually much easier to test with a single-board computer because it can act like a normal monitor.

I2C

I2C is a two-wire communication bus used by many sensors and small modules. It matters because several I2C devices can share the same two wires, but each device needs a compatible address and your controller must support I2C.

I2S

I2S is a digital audio interface used to send sound data between chips, such as from a microcontroller to an audio amplifier or DAC. It matters if your project needs cleaner digital audio output than a basic buzzer or PWM signal can provide.

IoT

Short for Internet of Things, meaning physical devices that connect to networks or the internet to send data or be controlled remotely. It matters if you want projects such as connected sensors, remote controls or classroom data-logging activities.

M.2

A compact edge-connector format commonly used to plug small modules into a carrier board without soldering. On this product it is the physical connector used by the MicroMod system, so compatibility with the matching processor board is important.

NVMe

A high-speed storage standard commonly used by modern SSDs. NVMe support matters if you want faster storage for large AI models, video files or operating system images than a typical microSD card can provide.

RAM

RAM is temporary memory used while a device is running, and its contents are lost when power is removed. A “Run in RAM” mode is useful for testing settings without permanently programming the module, but it may not support every feature.

RTC

A Real-Time Clock keeps track of time even when the main processor is asleep or powered down, usually with a small backup battery. It matters for data logging and tracking projects that need accurate timestamps.

Thread

A low-power wireless mesh networking standard designed for smart home and IoT devices. It matters because Thread devices can relay messages through each other, helping build reliable networks for sensors and controllers.

UART

UART is a simple serial connection that sends data over separate transmit and receive wires, often labelled TX and RX. It matters because this module is designed to replace a wired UART cable with a wireless link while keeping the same serial data format.

USB Type-C

A reversible USB connector used for power and data on many modern devices. On this kit it indicates an alternate 5V power input, which may be useful for setup or charging without the solar panel.