Adafruit Mini Skinny NeoPixel Digital RGB LED Strip 1m - White PCB 60 LED

The Mini Skinny NeoPixel strip packs 60 individually addressable RGB LEDs into one metre, with an ultra-narrow 7.5 mm wide flexible PCB (5 mm without casing). This is the white PCB, 60 LED/m version — a lower-density option that's easier to power and ideal for projects where pixel spacing isn't critical.

Each LED is controlled by a built-in WS2812B driver, giving you full 24-bit colour (8-bit per channel) on every pixel. Only a single data pin is needed, and once you set your colours, the strip continues to drive the LEDs without further commands. Cut every 17 mm (1 LED) and solder to 0.1" pads to customise the length. Also available in a higher-density 144 LED/m white PCB version.

Key Features

• 60 LEDs per Metre – Addressable RGB pixels with 17 mm spacing between LEDs
• Ultra-Narrow – Only 7.5 mm wide (5 mm without casing) for tight-space installations
• Single-Pin Control – One digital output drives the entire strip via the WS2812B protocol
• 24-Bit Colour – 8-bit PWM per red, green, and blue channel on every LED
• Chainable – Connect multiple strips end to end (watch your current budget)
• Cuttable – Trim at any LED with cut lines every 17 mm
• Weatherproof Sheathing – Flexible PCB comes with a protective silicone sleeve

Power Requirements

• Maximum draw – ~9.5 W per metre (2 A at 5 V) with all LEDs on full white
• Typical draw – About one-third to one-half of maximum for colourful patterns
• Recommended: 5 V 2 A supply for one metre, or 5 V 10 A supply for longer runs

Ideal For

• Accent lighting and edge illumination
• Wearable electronics and cosplay costumes
• LED art installations where individual pixel spacing is acceptable
• Battery-friendly projects (lower current draw than 144 LED/m strips)

Package Contents

• 1× 1 m Mini Skinny NeoPixel Strip – 60 LED/m, white PCB (with weatherproof sheathing)

Resources

• NeoPixel Uberguide – Comprehensive guide with wiring, code examples, and best practices