Wearable Tech & E-textiles

SKU: KI-5625 | Brand: Kitronik

The ZIP Halo is a circular LED board for the BBC micro:bit featuring 24 individually addressable full-colour ZIP LEDs (WS2812B). Each LED can display a huge spectrum of colours, enabling vibrant rainbow effects, colou...

SKU: SF-BOK-14270 | Brand: SparkFun

The full-color LilyPad Sewable Electronics Kit Guidebook contains step-by-step instructions for creating four interactive projects from the materials contained in the kit. Examples and circuits are provided and exp...

SKU: AF-921 | Brand: Adafruit

This blank 13.56 MHz RFID/NFC silicone bracelet contains a Mifare Classic 1K chip with 1 KB of writable EEPROM storage. The embedded chip and antenna are passively powered — no battery is needed. Simply hold the brace...

SKU: AF-1349 | Brand: Adafruit

A really tiny portable inverter for EL wire. Powers off of a single AAA battery (not included!), it can drive up to 50cm / 20 inches of our high-brightness EL wire or 10cm x 1cm long piece of EL tape for 3 hours (o...

SKU: SF-SEN-08606 | Brand: SparkFun

A simple flex sensor 4.5" in length. As the sensor is flexed, the resistance across the sensor increases. Patented technology by Spectra Symbol - they claim these sensors were used in the original Nintendo Power Gl...

SKU: SF-SEN-12969 | Brand: SparkFun

A 10-pack of disposable biomedical sensor pads (electrodes) for measuring EEG, ECG, and EMG signals. Each pad features integrated latex-free gel for strong skin adhesion and a snap connector that attaches easily to el...

SKU: SF-SEN-09673 | Brand: SparkFun

A compact force sensitive resistor (FSR) from Interlink Electronics with a 4 mm (0.16″) diameter active sensing area. The resistance changes based on applied pressure — from over 1 MΩ with no pressure down to approxim...

SKU: DF-DFR0185-LB | Brand: DFRobot

Electroluminecent wire, otherwise known as EL Wire, is a thin phosphor coated wire in a tube that lights up when you apply a high AC voltage to it. EL Wire typically needs anywhere between 20Vac to 220Vac, at a very ...

SKU: AF-406 | Brand: Adafruit

EL Wire, also known as Electroluminescent wire is a stiff wire core coated with phosphor and then covered with a protective PVC sheath. When an AC signal is applied to it, it glows an aqua (blue green) color. You c...

SKU: AF-546 | Brand: Adafruit

A little bundle to get you started! This project pack contains: 2.5 meters (over 8 ft) of high-brightness, long-life EL wire in White. 2.5 meters is the maximum amount for the pocket driver - it is cut and solder...

SKU: DF-DFR0185-R | Brand: DFRobot

Electroluminecent wire, otherwise known as EL Wire, is a thin phosphor coated wire in a tube that lights up when you apply a high AC voltage to it. EL Wire typically needs anywhere between 20Vac to 220Vac, at a very ...