SparkFun

SKU: SF-CAB-10759 | Brand: SparkFun

Integrating Ethernet support into your project is a great way to relay data through a local area network and even bounce information out to the internet. Sometimes it’s hard to get power to your Ethernet devices. Woul...

SKU: SF-PRT-10739 | Brand: SparkFun

Metal short standoffs: 3/8" long x ¼"OD. Used to get your proto board up off the table. #4-40 thread. Fits all development boards with available holes. Don’t forget the screws! Related below. Note: These are sold as a...

SKU: SF-TOL-10721 | Brand: SparkFun

This is a replacement soldering tip for our Hakko FX-888 soldering iron. This is a conical type of soldering tip. Replacing the tip is very easy - simply unscrew the shield, slip the replacement tip in, and screw t...

SKU: SF-WRL-12938 | Brand: SparkFun

The SparkFun FM Tuner Evaluation Board features the Silicon Laboratories Si4703 FM tuner chip, capable of receiving FM radio stations as well as detecting and processing Radio Data Service (RDS) and Radio Broadcast Da...

SKU: SF-BOB-10616 | Brand: SparkFun

The TLC5940 is a 16 channel PWM unit with 12 bit duty cycle control (0-4095), 6 bit current limit control (0-63), and a daisy chainable serial interface. This breakout board is a good way to take full advantage of thi...

SKU: SF-SEN-12909 | Brand: SparkFun

This is the MS5803-14BA Pressure Sensor Breakout, a high resolution pressure sensor with both an I2C and SPI interface. This MEMS pressure sensor measures the absolute pressure of the fluid around it which includes ai...

SKU: SF-COM-10594 | Brand: SparkFun

Rubber feet raise your PCB or project up off your desk. This helps prevent short circuiting from bits of scrap wire floating about or setting a project down on a conductive surface. They also prevent your enclosure or...

SKU: SF-PRT-12885 | Brand: SparkFun

This is the Sunny Buddy, a maximum power point tracking (MPPT) solar charger for single-cell LiPo batteries. This MPPT solar charger provide you with the ability to get the most possible power out of your solar panel ...

SKU: SF-PRT-10550 | Brand: SparkFun

BNC connectors are ideal for quick connects to audio coax and high-frequency signal lines. This is a right-angle connector and comes with a lock washer and nut. Documents: Dimensional Drawing

SKU: SF-WRL-10534 | Brand: SparkFun

A simple 434 MHz ASK RF transmitter module for creating basic one-way wireless data links. Breadboard-friendly and easy to pair with a microcontroller, this transmitter works with compatible 434 MHz receiver modules t...

SKU: SF-WRL-10532 | Brand: SparkFun

The RF Link Receiver is a simple 434 MHz wireless receiver module designed for one-way data communication with a compatible 434 MHz transmitter. It fits easily into a breadboard and pairs with microcontrollers to crea...

SKU: SF-TOL-12878 | Brand: SparkFun

This is 50g of high quality, Lead-Free Solder Paste, the perfect amount to keep around for prototyping and hobby projects that require a bit of SMD soldering. Solder Paste Stenciling is the easiest and quickest way t...

SKU: SF-WRL-12861 | Brand: SparkFun

This is a basic SMA (Sub-Miniature A) male to female connector cable. Each cable is 25cm (9.8") long and has a 50Ω impedance that can handle frequencies up to 17 GHz. The SMA connectors at each end are small enough...

SKU: SF-WRL-12847 | Brand: SparkFun

XBee radios are an awesome way to add wireless capability to your Arduino project and now it’s even easier with the SparkFun XBee Shield. The shield form-factor mates directly with any dev board that has an Arduino...

SKU: SF-PRT-10462 | Brand: SparkFun

Nylon standoffs for mounting PCBs in enclosures or elevating boards off work surfaces. These ¾" (19mm) long standoffs are tapped for 4-40 screws and sold in a pack of 10. Key Features Nylon Construction – Non-condu...

SKU: SF-SEN-12829 | Brand: SparkFun

If you’ve had ideas for a project that depends on the ability to sense different spectrums of visible light and react based on those measurements, the ISL29125 breakout board may be just what you need. The ISL29125 br...

SKU: SF-WRL-12823 | Brand: SparkFun

This is the SparkFun RFM69 Breakout, a small piece of tech that breaks out all the pins available on the RFM69HCW module as well as making the transceiver easy to use. The RFM69HCW is an inexpensive and versatile r...

SKU: SF-PRT-10401 | Brand: SparkFun

A simple single-cell LiPo/Li-Ion battery charger based on the MCP73831T charge controller IC. Connect a battery via the JST connector, plug in a Mini-USB cable for power, and the board handles charging automatically w...

SKU: SF-SEN-12784 | Brand: SparkFun

This is the SparkFun “Time-of-Flight” Range Finder, a breakout for the VL6180 distance sensor. Unlike most distance sensors that rely reflected light intensity or reflected angles to determine range, the VL6180 use...

SKU: SF-PRT-12791 | Brand: SparkFun

This is a 2x23 pin male PTH header. This piece is in the common configuration for Beaglebone Black headers that can be broken apart to form smaller header formations. Each pin has a spacing of 0.1" in between each oth...