SparkFun

SKU: SF-COM-10931 | Brand: SparkFun

A basic 4-digit 7-segment display in white. This common anode display features one decimal point per digit, plus individually controllable apostrophe and colon points — perfect for clocks, counters, and numeric readou...

SKU: SF-COM-13105 | Brand: SparkFun

So much power and light from such a small package. This 5 pack of “Cool” white 3 Watt aluminum backed PCBs is sure to shed a lot of light on any project you add it to. These LEDs act as any other LED except these l...

SKU: SF-COM-13104 | Brand: SparkFun

So much power and light from such a small package. This 5 pack of “Warm” white 3 Watt aluminum backed PCBs is sure to shed a lot of light on any project you add it to. These LEDs act as any other LED except these litt...

SKU: SF-COM-10924 | Brand: SparkFun

These are massive single pole - double throw (SPDT) sealed relays. This means that when current is applied to the coil it throws a simple changeover switch, terminating the connection from the NC contact to ground and...

SKU: SF-PRT-13102 | Brand: SparkFun

The Raspberry Pi is everybody’s favorite little computer, the last thing that you’d want is for something bad to happen to it. Why not protect it with one of these snazzy plastic enclosures? These cases protect the Ra...

SKU: SF-BOB-13099 | Brand: SparkFun

The SparkFun Rotary Switch Potentiometer Breakout is a small board the allows you to add resistors to a 10-position rotary switch, turning it into a potentiometer with 10 discrete steps. Multiple applications requi...

SKU: SF-DEV-10914 | Brand: SparkFun

It’s blue! It’s skinny! It’s the Arduino Pro! SparkFun’s minimal design approach to Arduino. This is a 3.3V Arduino running the 8MHz bootloader. Because the system voltage for this board is lower than other Arduino...

SKU: SF-PRT-13061 | Brand: SparkFun

This 6 position screw terminal block provides a simple way to connect wires to a single connection point. These blocks allow wires to be screwed together and self-isolated without needing to twist, solder or any other...

SKU: SF-ROB-10848 | Brand: SparkFun

These steppers have a threaded shaft, which allows them to be used as a linear actuator. As the motor runs, it moves along the shaft at a specific rate of 1cm per 5 full rotations. These are a good choice for linear m...

SKU: SF-PRT-10853 | Brand: SparkFun

This is a wire assembly terminated with the same 8-pin JST-SH connector which is on the Mega Pro Mini. Pick up a few of these to break out all of those pesky pins. Integrating these connectors into your projects ma...

SKU: SF-TOL-10829 | Brand: SparkFun

This smart SMD tester is essentially a pair of multimeter tweezers. This allows you to troubleshoot circuits with small SMD parts without having to fumble with large probes or long wires. Test resistors, capacitors an...

SKU: SF-KIT-13006 | Brand: SparkFun

This is the SparkFun Decade Resistance Box, an involved PTH soldering kit that allows you to quickly and accurately dial in a specific resistance value between 0 and 999,990 Ω, in 10 Ω increments. The concept is simpl...

SKU: SF-WRL-13002 | Brand: SparkFun

This ANT500 is a telescopic antenna designed for operation from 75 MHz to 1 GHz with a total length that is configurable from 20 cm to 88 cm long. Each ANT500 is constructed of stainless steel and features an SMA male...

SKU: SF-CAB-10759 | Brand: SparkFun

Integrating Ethernet support into your project is a great way to relay data through a local area network and even bounce information out to the internet. Sometimes it’s hard to get power to your Ethernet devices. Woul...

SKU: SF-SEN-10740 | Brand: SparkFun

An evaluation board for the MLX90614 non-contact infrared thermometer sensor. It pairs the MLX90614 with an ATmega328 running at 3.3 V (8 MHz Arduino bootloader), giving you a ready-to-use IR temperature sensor with s...

SKU: SF-PRT-10739 | Brand: SparkFun

Metal short standoffs: 3/8" long x ¼"OD. Used to get your proto board up off the table. #4-40 thread. Fits all development boards with available holes. Don’t forget the screws! Related below. Note: These are sold as a...

SKU: SF-TOL-10721 | Brand: SparkFun

This is a replacement soldering tip for our Hakko FX-888 soldering iron. This is a conical type of soldering tip. Replacing the tip is very easy - simply unscrew the shield, slip the replacement tip in, and screw t...

SKU: SF-BOB-10616 | Brand: SparkFun

The TLC5940 is a 16 channel PWM unit with 12 bit duty cycle control (0-4095), 6 bit current limit control (0-63), and a daisy chainable serial interface. This breakout board is a good way to take full advantage of thi...

SKU: SF-SEN-12909 | Brand: SparkFun

This is the MS5803-14BA Pressure Sensor Breakout, a high resolution pressure sensor with both an I2C and SPI interface. This MEMS pressure sensor measures the absolute pressure of the fluid around it which includes ai...

SKU: SF-COM-10594 | Brand: SparkFun

Rubber feet raise your PCB or project up off your desk. This helps prevent short circuiting from bits of scrap wire floating about or setting a project down on a conductive surface. They also prevent your enclosure or...