SparkFun

SKU: SF-PRT-17258 | Brand: SparkFun

This is a 200mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but can be used for other applications as well. The cable insulation is made from silicon mak...

SKU: SF-DEV-14012 | Brand: SparkFun

This is a simple pack of five Blue LilyPad LEDs that are still attached to one another, letting you snap the LEDs apart at your leisure to sew into clothing or whatever else you can dream up.LilyPad is a wearable e-te...

SKU: SF-PRT-12002 | Brand: SparkFun

This is your tried and true white solderless breadboard. It has 2 power buses, 10 columns, and 30 rows - a total of 400 tie in points. All pins are spaced by a standard 0.1". The two sets of five columns are separa...

SKU: SF-BOB-00716 | Brand: SparkFun

RJ45 connectors are the kind that are used for Ethernet jacks, but they make great general purpose connectors when you need a lot of conductors. This is a small PCB that brings out the pins of the RJ45 connector to an...

SKU: SF-COM-11452 | Brand: SparkFun

These color-changing LEDs take the work out of creating crazy, flashy, blinky… ness. Simply apply power and the LED will cycle through the RGB colorspace: no external controller necessary! These bright and festive LED...

SKU: SF-COM-11274 | Brand: SparkFun

It’s the end of the world, and you need a button to press. This is it. A 100mm diameter (outside diameter) dome illuminated push button comes with an LED, securing nut and a pre-installed long life horizontal micro...

SKU: SF-DEV-10899 | Brand: SparkFun

The LilyTiny is a compact LilyPad board with a built-in ATtiny85 microcontroller that drives four pre-programmed LED patterns. Simply sew on four LEDs and connect a battery — no programming or main board required. Ea...

SKU: SF-PRT-10811 | Brand: SparkFun

This DC power jack/connector is just like the other one that we carry except that it’s terminated with breadboard-friendly pins instead of wide solder terminals. These are also compatible with our DC wall supplies and...

SKU: SF-PRT-10288 | Brand: SparkFun

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positive female barrel jack. If you have a power supply with a barrel jack an...

SKU: SF-WRL-17146 | Brand: SparkFun

The ESP8266 WiFi Module is a self contained SOC with integrated TCP/IP protocol stack that can give any microcontroller access to your WiFi network. The ESP8266 is capable of either hosting an application or offloa...

SKU: SF-SEN-14727 | Brand: SparkFun

This miniature straight bar load cell (sometimes called a strain gauge) can translate up to 100g of pressure (force) into an electrical signal. Each load cell is able to measure the electrical resistance that cha...

SKU: SF-WRL-14875 | Brand: SparkFun

A compact 1/4-wave rubber duck antenna for LoRa and other 860–960MHz communication. With a centre frequency of 915MHz and 2dBi gain, this 110mm antenna is ideal for space-constrained LoRa nodes where a smaller antenna...

SKU: SF-TOL-08639 | Brand: SparkFun

A USB-A to 5.5 × 2.1 mm barrel jack adapter cable for powering development boards and small devices from any USB port. Centre-positive polarity, delivering up to 5 V at 500 mA (per USB specification). Specifications ...

SKU: SF-DEV-14014 | Brand: SparkFun

This is a simple pack of five Yellow LilyPad LEDs that are still attached to one another, letting you snap the LEDs apart at your leisure to sew into clothing or whatever else you can dream up.LilyPad is a wearable e-...

SKU: SF-ROB-13302 | Brand: SparkFun

These are a pair of hobby gearmotors from DAGU. These gearmotors are the same ones recommended for use in the Shadow Chassis and offer a cheap and easy-to-use setup to get your wheels turning. Each Hobby Gearmotor als...

SKU: SF-DEV-11114 | Brand: SparkFun

It’s blue! It’s thin! It’s the Arduino Pro Mini! SparkFun’s minimal design approach to Arduino. This is a 3.3V Arduino running the 8MHz bootloader. Arduino Pro Mini does not come with connectors populated so tha...

SKU: SF-PRT-12978 | Brand: SparkFun

A pack of 10 multicoloured alligator-to-alligator clip test leads — an essential for any electronics workbench. Whether you're making quick connections to test a circuit or extending your multimeter leads, these sprin...

SKU: SF-COM-10632 | Brand: SparkFun

Check out these big 10mm through-hole LEDs! The opaque epoxy package causes these LEDs to have a soft, diffuse glow.

SKU: SF-SEN-10266 | Brand: SparkFun

Use this simple IR receiver for infrared remote control of your next project. With low power consumption and an easy to use package, it mates well with embedded electronics and can be used with common IR remotes. The...

SKU: SF-DEV-12640 | Brand: SparkFun

Here at SparkFun, we refuse to leave ‘good enough’ alone. That’s why we’re adding to our line-up of Arduino-compatible microcontrollers once more! The Pro Micro is similar to the Pro Mini except with an ATmega32U4 on ...