New Arrivals

SKU: EF-EF09079 | Brand: ElecFreaks

Ring:bit car is a DIY smart car which is based on BBC micro:bit and ELECFREAKS ring:bit. Ring:bit has extended 3 channels of GPIO, among which 2 channels are used for driving servos and one channel of GPIO is undefine...

SKU: PI-COM0002 | Brand: Pimoroni

This 2×20 pin female GPIO header with extended 11 mm pins is designed for Raspberry Pi boards with 40-pin GPIO headers. The extra-tall pins are perfect for stacking pHAT boards on top of each other while still leaving...

SKU: TB-WH5682 | Brand: Little Bird

A 5-metre roll of 2:1 ratio heatshrink tubing in black, with a 3 mm pre-shrink diameter. Shrinks to half its original size when heated, providing insulation, strain relief, and protection for solder joints, wire splic...

SKU: AF-1476 | Brand: Adafruit

A 16mm illuminated pushbutton with a built-in blue LED and latching on/off action. Press once to switch on, press again to switch off — ideal for power switches, mode selectors, and control panels. The LED is wired i...

SKU: AF-3488 | Brand: Adafruit

This 30mm translucent yellow arcade button has built-in LEDs for a beautiful illuminated look. Two surface-mount LEDs with a ~1K resistor are embedded in the button body in a series configuration, drawing just 5mA fro...

SKU: SF-COM-14567 | Brand: SparkFun

It’s tiny, it’s handy, and it can give your normal USB-equipped device a micro-B connector! With the USB to Micro-B Adapter you can make a flash drive connect to your tablet, connect a keyboard to your phone in order ...

SKU: LB-LS0153G | Brand: Little Bird

Green Wire Wrap Wire on Spool 250m 30AWG Wire Wrapping Wire, 30 AWG External Material :PVC PVC insulation, Tinned copper conductor Diameter: 0.5 mm Inner diameter:0.25 mm Length:250 meters Heat-resistant: 80 degrees

SKU: TB-RR2558 | Brand: Little Bird

A pack of two 220Ω carbon film resistors rated at 1W continuous power. These through-hole axial resistors are suitable for general-purpose electronics projects requiring higher power handling than standard ¼W resistor...

SKU: LB-00339 | Brand: Little Bird

This is a 5-pin female header, with extra long legs  Pins are spaced by 0.1".    

SKU: LB-LR0022 | Brand: Little Bird

It's a push button!A push button with resistors and breadboard friendly layout.**Push Button Pinout:**- Signal (High when button pushed)- Positive- Ground**Specifications:**- 600mW MAX (50mA at 12v)

SKU: AF-1620 | Brand: Adafruit

Add a power switch to any USB-powered project simply by plugging this between the USB power port and the USB cable. This is the most useful thing you never knew you needed! You'll want to pick up a bunch for your elec...

SKU: AF-1608 | Brand: Adafruit

The Adafruit Perma-Proto Quarter-Sized Breadboard PCB mirrors the layout of a tiny solderless breadboard with power rails, making it simple to transfer small prototyped circuits to a permanent soldered board. The comp...

SKU: SS-110060024 | Brand: Seeed Studio

The Grove Starter Kit for Arduino from Seeed Studio is a beginner-friendly electronics kit built around the Grove modular connector system. It includes a Base Shield with multiple Grove connectors, twelve plug-and-pla...

SKU: AF-2005 | Brand: Adafruit

Silicone-sheathing wire is super-flexible and soft, and its also strong! Able to handle up to 200°C and up to 600V, it will do when PVC covered wire wimps out. We like this wire for being extremely supple and flexible...

SKU: AF-1789 | Brand: Adafruit

This 1K potentiometer is a two-in-one, good in a breadboard or with a panel. Its a fairly standard linear taper 1K ohm potentiometer, with a grippy shaft. Its smooth and easy to turn, but not so loose that it will ...

SKU: AF-1792 | Brand: Adafruit

Add a little sparkle to your wearable project with Adafruit LED Sequins. These tiny sewable LED boards are the simpler sibling of Flora NeoPixels — they display a single colour with no digital control needed, making t...

SKU: AF-1863 | Brand: Adafruit

This switched JST connector is the best way to quickly prototype with our LiPoly batteries. We paired a genuine JST connector with a slide switch that can do up to 600mA. Both are soldered onto a breadboard-friendl...

SKU: AF-1875 | Brand: Adafruit

Because the Arduino (and Basic Stamp) are 5V devices, and most modern sensors, displays, flash cards and modes are 3.3V-only, many makers find that they need to perform level shifting/conversion to protect the 3.3V de...

SKU: AF-2222 | Brand: Adafruit

Connect your own PCB to a Raspberry Pi B+ with this normal-height female header.  The female header part is about 8.5mm tall, good for small HATs that do not to clear the USB/Ethernet jacks. This header has 3m...

SKU: AF-2201 | Brand: Adafruit

This is just about the cutest, tiniest little micro servo we could find, even smaller than the 9 gram micro servos we love so much.  It can rotate approximately 180 degrees (90 in each direction) and works just l...