New Arrivals

SKU: DF-ROB0003 | Brand: DFRobot

The DFRobot 4WD Arduino Mobile Platform is intended for use with the DFRobot ROMEO Microcontroller and includes 4x drive motors, 4x wheels and a complete chassis with mounting hardware. The included second level...

SKU: DF-SEN0220 | Brand: DFRobot

The Gravity UART Infrared CO2 Sensor uses non-dispersive infrared (NDIR) technology to measure carbon dioxide concentrations from 0 to 50,000 ppm. It offers excellent selectivity with no oxygen dependency, built-in te...

SKU: DF-DFR0053 | Brand: DFRobot

This arduino Slide Position Sensor is based on straight-slip slide potentiometer sensor. The sensor is able to give provide the position of the slider which is often considered as a linear potentiometer . The ...

SKU: DF-FIT0031 | Brand: DFRobot

A pack of 10 analog sensor cables designed for use with DFRobot IO Expansion Shields and compatible analog sensors. Each cable connects a sensor to the expansion shield's analog ports, making wiring quick and tidy. E...

SKU: SF-COM-09542 | Brand: SparkFun

The QRE1113 is a small IR reflectance sensor. This sensor is often used in line following robots because, if it can sense if a surface is white or black. There are four pins on the QRE1113 - two control the IR em...

SKU: SF-PRT-09536 | Brand: SparkFun

Looking to add MIDI to your project? This is a female, 5-pin, right-angle DIN 5/180? connector which will interface with most standard MIDI cables. The pins are spaced by just about 0.1", making these connectors eas...

SKU: AF-770 | Brand: Adafruit

Keep your power source safe and toasty in these waterproof 2xAA battery holders. They're just like classic switched battery holders, but designed for survival! The case has a rubber gasket around the edge of the ca...

SKU: SF-PRT-09498 | Brand: SparkFun

A right-angle 24-pin Molex Mini-Fit Jr. connector, the standard ATX power supply connector found on PC motherboards. Two rows of twelve pins break out to through-hole male headers for PCB mounting. Pair with a standar...

SKU: SF-ROB-12429 | Brand: SparkFun

This compact micro gearmotor packs full metal gears into a tiny 26 × 12 × 10 mm body, delivering up to 460 RPM at 12 V with a 50:1 gear ratio. The 3 mm D-shaft and DC-reversible operation make it a versatile choice fo...

SKU: AF-2076 | Brand: Adafruit

These 2×23 male headers plug directly into the side sockets on the BeagleBone Black, allowing you to attach prototype PCBs or capes. Each pack includes two headers — one for each side of the BeagleBone Black. Key Fea...

SKU: SF-ROB-09454 | Brand: SparkFun

The SparkFun QRE1113 Line Sensor Breakout (Digital) is a compact IR reflectance sensor board that outputs a digital signal based on surface reflectivity. It uses a capacitor discharge circuit — the faster the 10 nF ca...

SKU: AF-881 | Brand: Adafruit

The Adafruit 0.56" 4-Digit 7-Segment Display with I2C Backpack in blue makes it easy to add a bright numeric display to any microcontroller project. The backpack handles all LED multiplexing and driving via I2C, so yo...

SKU: AF-3533 | Brand: Adafruit

The Adafruit 0.96" 160×80 Colour TFT Display Breakout is a tiny, high-density full-colour screen driven by the ST7735R controller. Despite its thumbnail size, it packs 160×80 RGB pixels and communicates over 4-wire SP...

SKU: AF-2089 | Brand: Adafruit

A snap-in battery holder for Sony NP-F series camcorder batteries, with a pre-attached 2.1 mm DC barrel plug for powering 7 V DC devices. Clip in a compatible Li-Ion battery pack and connect directly to robots, Arduin...

SKU: DF-FIT0064 | Brand: DFRobot

A 10-pack of M3 × 50mm hexagonal standoffs with matching screws and nuts. Use them to mount circuit boards, sensors, and other components with consistent 50mm spacing and secure mechanical support. At 50mm height, th...

SKU: SF-SEN-09417 | Brand: SparkFun

This is a simple, thumbnail-size RFID tag. These tags are great for sensing presence, identification, etc., and they’re small, so they can be easily sewn into clothing or inserted into enclosures. Each tag comes with ...

SKU: SF-SEN-09405 | Brand: SparkFun

A simple-to-use MQ-6 gas sensor for detecting liquefied petroleum gas (LPG) — primarily propane and butane — in the air. The sensor detects concentrations from 200 to 10,000 ppm with high sensitivity and fast response...

SKU: AF-2046 | Brand: Adafruit

Oh say can you see By the knob's early light... Sorry - we thought that was clever.  And while it wasn't really, this potentiometer knob definitely is.  It's a 'soft touch' T18 knob that works great with...

SKU: DF-FIT0021 | Brand: DFRobot

A 128×64 pixel graphic LCD module driven by the ST7920 controller. This display supports English characters, Chinese characters, and custom graphics over both serial (SPI) and parallel interfaces, making it a versatil...

SKU: SF-PRT-09390 | Brand: SparkFun

This is a SparkFun exclusive! These are 12" long jumper wires terminated as female to female. Use these to jumper from any male header on any board. Multiple jumpers can be connected next to one another on a 0.1" h...