New Arrivals

SKU: EC-DTS02078B | Brand: Elecrow

This is a GPIO expansion board for Micro: bit. It completely compatible with the Micro: bit and respectively extended the UART port and IIC port. It can make it easy for you to use the extenal pins of the Micro: bi...

SKU: SF-COM-15141 | Brand: SparkFun

Rotary encoders can be used similarly to potentiometers. The difference being that an encoder has full rotation without limits (It just goes round and round). They output gray code so that you can tell how much and in...

SKU: SF-DEV-15110 | Brand: SparkFun

The SparkFun ESP32 Thing Plus DMX to LED Shield enables sending and receiving DMX data via an on-board XLR-3 jack or over ArtNet. Designed for developing custom DMX fixtures or adding ArtNet capabilities to existing s...

SKU: PR-PIM330 | Brand: Little Bird

Fit a pHAT to your Raspberry Pi Zero without soldering! These spring-loaded pogo pins provide a reliable electrical contact between your Pi Zero and pHAT, making it quick and easy to swap boards between projects with ...

SKU: SF-ROB-14451 | Brand: SparkFun

The SparkFun TB6612FNG Motor Driver breakout can independently control up to two DC motors at a constant current of 1.2 A (3.2 A peak). Each motor channel supports four modes — clockwise, counter-clockwise, short-brak...

SKU: PI-RPI-020 | Brand: Pimoroni

The Official Raspberry Pi Zero Case is designed to fit both the Pi Zero and Pi Zero W. It ships with three interchangeable lids so you can configure it for different use cases: a plain lid for a clean finish, a GPIO l...

SKU: PR-PIM171 | Brand: Little Bird

A handy breakout tool that lets you access all 40 GPIO pins while a HAT or pHAT is connected to your Raspberry Pi. Plug in your HAT, connect the ribbon cable to your Pi, and probe, debug, or extend any pin with ease. ...

SKU: SF-SEN-14520 | Brand: SparkFun

The SparkFun Capacitive Touch Breakout provides a single momentary touch button using the AT42QT1011 capacitive sense chip. Simply supply 1.8–5 V and ground — the chip handles all touch monitoring and outputs a digita...

SKU: DF-DFR0031-G | Brand: DFRobot

This is a Piranha LED light module. A digital pin (LOW on, HIGH off) is used to control it. The brightness of LED can be controller via PWM output. APPLICATIONS DIY Projects Toys Games Audio indicator SPECIFICATIONS...

SKU: DF-DFR0238 | Brand: DFRobot

This small size breakout is programmable full-color RGB LED for hobbyists, industrial designers, prototypers, and experimenters. It is designed to allow the easy addition of dynamic indicators, displays, and lig...

SKU: SF-COM-08033 | Brand: SparkFun

This a simple breakout board for the button pads. Each LED and button is brought out to the side connectors. The connectors are soldered to the back side of the PCB. We recommend trimming the connector leads on the bu...

SKU: PL-1137 | Brand: Pololu

The GP2Y0A02 is the longest-range optical distance sensor we carry, featuring a detection range of 8″ to 60″ (20 cm to 150 cm). The high maximum detection distance makes this sensor a viable alternative to ...

SKU: AF-381 | Brand: Adafruit

This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PVC ...

SKU: PL-837 | Brand: Pololu

The Vishay TSOP34156 is a general-purpose modulated IR receiver for IR-based remote-control projects. It features a wide operating voltage range and allows for relatively high data rates; this particular unit is tune...

SKU: EC-ACC35076R | Brand: Elecrow

This video tank robot vehicle uses ESP32 as the main board, with OV2640 camera, and can control the movement via WiFi. It has a digital microphone interface, which can adjust the volume. The APP can control the shooti...

SKU: WS-26837 | Brand: Waveshare

The RaspRover is an open-source, four-wheel-drive AI robot platform powered by a dual-controller architecture. A Raspberry Pi 4B or 5 (not included) handles high-level AI processing and computer vision, while an onboa...

SKU: WS-28742 | Brand: Waveshare

D-Robotics RDK X5 Development Board – Your Gateway to Advanced Robotics and AI Unlock the potential of innovative robotics and intelligent computing with the D-Robotics RDK X5 Development Board. Experience the sheer ...

SKU: WS-30706 | Brand: Waveshare

Unleash your creativity and develop interactive applications with the RP2350 2.8inch Capacitive Touch Display Development Board. This cutting-edge board is packed with features that make it perfect for hobbyists, educ...

SKU: WS-29962 | Brand: Waveshare

Unleash Your Creativity with the Vibrant ESP32-S3 1.3-inch Display Development BoardAre you ready to elevate your project with a splash of color and advanced functionality? The ESP32-S3 1.3-inch Display Development Bo...

SKU: WS-31159 | Brand: Waveshare

This compact development board from Waveshare combines the Raspberry Pi RP2350A microcontroller with a built-in 1.47″ LCD display, TF card slot, and RGB LED — all in a tiny form factor with pre-soldered headers and US...