New Arrivals

SKU: AF-1778 | Brand: Adafruit

The AD8495 from Analog Devices is an analog-output K-type thermocouple amplifier on a compact breakout board. Simply power the board with 3–18V DC, connect a K-type thermocouple to the terminal block, and read the tem...

SKU: AF-1032 | Brand: Adafruit

A gyroscope is a type of sensor that can sense twisting and turning motions. Often paired with an accelerometer, you can use these to do 3D motion capture and inertial measurement (that is - you can tell how an object...

SKU: DF-SEN0013 | Brand: DFRobot

This SHARP infrared distance sensor takes a continuous distance reading and returns a corresponding analog voltage with a range of 20cm (8") to 150cm (60").It can be usually applied as obstacle avoidance and path p...

SKU: AF-2479 | Brand: Adafruit

The Adafruit Bluefruit LE UART Friend adds Bluetooth Low Energy connectivity to any microcontroller or computer with a hardware or software serial port. With hardware flow control built in, you won't lose data during ...

SKU: DF-SEN0005 | Brand: DFRobot

This low cost SFR02 ultrasonic ranger has both I2C and Serial interfaces. New AutoTune algorithms intelligently back the minimum range right up to the transducer ringdown for the very best performance possible, aut...

SKU: DF-TEL0026 | Brand: DFRobot

A Bluetooth 2.0 serial module for Arduino, featuring the CSR BC417143 chip with a double-board design for electrostatic protection. Provides transparent serial data communication over Bluetooth with a configurable bau...

SKU: DF-DFR0090 | Brand: DFRobot

An 8-digit serial LED display module that uses an SPI (3-wire) interface, requiring only three I/O pins from your Arduino or microcontroller. Multiple modules can be daisy-chained together for longer displays. The fli...

SKU: DF-SEN0233 | Brand: DFRobot

A multifunction air quality monitor that measures particulate matter (PM2.5), formaldehyde concentration, temperature, and humidity. It uses laser scattering to detect suspended particles in the air, an electrochemica...

SKU: DF-TEL0020 | Brand: DFRobot

This is the XBee XB24-Z7WIT-004 module from Digi. Series 2 improves on the power output and data protocol. Series 2 modules allow you to create complex mesh networks based on the XBee ZB ZigBee mesh firmware. Th...

SKU: AF-2633 | Brand: Adafruit

The Adafruit Bluefruit LE SPI Friend adds Bluetooth Low Energy connectivity to any microcontroller with just 4–5 GPIO pins. Using SPI instead of UART means no baud rate configuration or flow control to worry about — c...

SKU: PL-2454 | Brand: Pololu

The QTR-L-1A reflectance sensor incorporates a right-angle infrared LED and a right-angle phototransistor in an inexpensive, tiny 0.35″ × 0.3″ module that can be mounted almost anywhere and is great for e...

SKU: SF-BOB-09322 | Brand: SparkFun

A simple breakout PCB for the GP1A57HR photo interrupter (also known as a photogate, photodiode, or phototransistor). This PCB has three connections for PWR, GND, and Signal.When the gate is clear, SIG will be high (>...

SKU: AF-466 | Brand: Adafruit

The VCNL4010 sensor is a nice way to add a small-distance proximity sensor to your microcontroller project. For longer distances (in the range of cm, you can use a SHARP IR distance sensor, but those are only good ...

SKU: DF-SEN0131 | Brand: DFRobot

INTRODUCTION This is an Arduino Propane Gas Sensor. It uses MQ6 probe to detect iso-butane, propane and liquefied petroleum gas (LPG). It is less sensitive with alcohol, cooking fumes an...

SKU: PL-1483 | Brand: Pololu

This semiconductor gas sensor detects the presence of Carbon Monoxide at concentrations from 10 to 1,000 ppm and combustible gas from 100 to 10,000 ppm. The sensor’s simple analog voltage interface requires ...

SKU: DF-SEN0140 | Brand: DFRobot

The DFRobot 10 DOF MEMS IMU Sensor combines four sensors on a single compact board — the ADXL345 accelerometer, ITG-3205 gyroscope, HMC5883L magnetometer, and BMP085 barometric pressure sensor. Together they provide 1...

SKU: SF-SEN-14049 | Brand: SparkFun

The MAX31820 ambient temperature sensor provides 9-bit to 12-bit Celsius temperature measurements with ±0.5°C accuracy over a +10°C to +45°C temperature range. Over its entire -55°C to +125°C operating range, the devi...

SKU: SF-COM-08348 | Brand: SparkFun

The TEMT6000x01 is a compact ambient light sensor that operates as an NPN phototransistor. The more light that hits the sensor, the stronger the base bias, producing an analog output proportional to the ambient light ...

SKU: SF-SEN-12041 | Brand: SparkFun

If you need to add user input without using a button, then a capacitive touch interface might be the answer. The AT42QT1010 SparkFun Capacitive Touch Breakout offers a single capacitive touch button with easy-to-use d...

SKU: SF-SEN-12040 | Brand: SparkFun

The INA169 is a “high-side current monitor,” which means that you place a resistor (a “shunt resistor”) on the positive power rail and the INA169 measures the voltage drop across that resistor. The INA169 outputs a sm...