New Arrivals

SKU: WS-19358 | Brand: Waveshare

A 10-DOF IMU sensor expansion board designed for the Raspberry Pi Pico. Combines a 9-axis ICM20948 motion sensor (gyroscope, accelerometer, magnetometer) with an LPS22HB barometric pressure sensor, all communicating o...

SKU: WS-13460 | Brand: Waveshare

NOTE: This product is only 2G Compatible! Unfortunately while there are still 2G networks in some parts of America and Europe, there are no longer 2G networks in Australia anymore.Prohibited by the module manufact...

SKU: PR-PIM638 | Brand: Little Bird

A wireless environmental monitoring board to keep track of inside conditions in your home, office or other habitat. Onboard sensors can measure temperature, humidity, pressure, gas and light. The top of the range...

SKU: DF-DFR0626 | Brand: DFRobot

This is an IO expansion module that based on the chip MCP23017. The module can expand additional 16 IOs. It can set 8 IIC addresses, which means with this module, the microcontroller can connect 8 modules, and expand ...

SKU: LB-LR0051 | Brand: Little Bird

A 4-channel relay module with opto-isolated inputs for safe, reliable switching of high-power loads. Each relay is rated for up to 10A at 250VAC or 30VDC, making it suitable for controlling lights, motors, heaters, an...

SKU: AF-2717 | Brand: Adafruit

The TCA9548A 1-to-8 I2C multiplexer solves the common problem of needing multiple I2C devices with the same address on a single bus. It acts as a gatekeeper, routing I2C traffic to any of its eight downstream channels...

SKU: AF-3386 | Brand: Adafruit

The Adafruit PiRTC is a battery-backed real-time clock that plugs directly onto your Raspberry Pi's GPIO header, letting your Pi keep accurate time even when powered off. Built around the PCF8523 RTC with native Linux...

SKU: SF-GPS-24114 | Brand: SparkFun

The SparkFun GNSS L1/L5 Breakout - NEO-F10N, SMA is a standard precision GNSS board with meter-level positional accuracy. The NEO-F10N uses the L1/L5 bands instead of the more commonly seen L1/L2 bands. Utilizing the ...

SKU: SF-SEN-22397 | Brand: SparkFun

The SparkFun BMI270 6DoF IMU Breakout is a Qwiic-enabled board featuring the ultra-low-power BMI270 inertial measurement unit from Bosch. It combines a 16-bit tri-axial accelerometer and 16-bit tri-axial gyroscope wit...

SKU: DF-SEN0629 | Brand: DFRobot

  The BME688 AI Environmental Sensor is a highly advanced MEMS sensor that combines temperature, humidity, barometric pressure, and VOC detection in a single, compact package. Featuring ±0.5°C temperature accurac...

SKU: AF-2340 | Brand: Adafruit

The Adafruit Capacitive Touch HAT adds 12 capacitive touch sensors to your Raspberry Pi using the MPR121 touch controller over I2C. Each sensor has a figure-8 hole designed for alligator clip connections — attach clip...

SKU: AF-6109 | Brand: Adafruit

The Adafruit A4988 Stepper Motor Driver Breakout simplifies stepper motor control down to just two pins — a direction pin and a step pin. Each pulse on the step pin advances the motor by one step or microstep, making ...

SKU: SF-SEN-22956 | Brand: SparkFun

The SparkFun Photoacoustic Spectroscopy CO2 Sensor features the Infineon XENSIV PAS CO2 (PASCO2V01) sensor, which delivers highly accurate CO2 measurements in direct parts-per-million (ppm) format. The photoacoustic s...

SKU: AF-6413 | Brand: Adafruit

The BMP585 from Bosch is a ported barometric pressure and temperature sensor featuring a tube attachment point for differential or remote pressure measurements. It delivers exceptional precision with altitude noise as...

SKU: SF-SEN-29211 | Brand: SparkFun

The SparkFun VEML7700 Qwiic Ambient Light Sensor provides accurate 16-bit light readings from 0 to 167,000 lux via I2C. The sensor features Vishay's Filtron™ technology for human-eye-like response and ultra-low power ...

SKU: DF-DRI0054 | Brand: DFRobot

##Introduction The multifunctional motor driver expansion board is designed for Raspberry Pi Zero/Zero W/A+/B+/2B/3B/3B+/4B. This fully-featured robot motor expansion board is capable of supporting multiple motors, st...

SKU: SF-SEN-24540 | Brand: SparkFun

Forget ultrasonic and infrared sensors; the SparkFun Qwiic Pulsed Coherent Radar Sensor - Acconeer XM125 brings powerful 60 GHz radar technology to your projects. This sensor isn't limited to surface detection; it c...

SKU: SF-SEN-22494 | Brand: SparkFun

The STHS34PF80 sensor, from ST Microelectronics, is designed to measure the precise black-body radiation (as described by Planck's law) of an object; as well as monitor ambient temperature conditions within its 80° fi...

SKU: AF-5744 | Brand: Adafruit

The Tiny Code Reader from Useful Sensors is a small, low-cost hardware module that reads QR codes. It's designed to be a simple way to provision a system, for example, by providing the Wi-Fi network name and password ...

SKU: SF-SEN-21325 | Brand: SparkFun

Looking for an extremely accurate way to detect motion utilizing AI? We've got you covered with the Qwiic-enabled, SparkFun LSM6DSV16X 6DoF IMU Breakout. The LSM6DSV16X, from STMicroelectronics, is a high-performance,...