New Arrivals

SKU: LB-00158 | Brand: Little Bird

This PIR sensor is suitable for use with Arduino and Raspberry PI. The 3.3v logic level is very handy as it allows you to use this sensor with 3.3v Arduinos like the Due or Pro Mini as well as 5V like the Uno as 3....

SKU: LB-LR0230 | Brand: Little Bird

The HC-SR04 is a widely used ultrasonic distance sensor that measures distances from 2cm to 500cm (approximately 5 metres) with 1cm resolution. It works by emitting a 40kHz ultrasonic pulse, then measuring the time it...

SKU: LB-LR0085 | Brand: Little Bird

The 0.96″ 128×64 OLED Display Module delivers crisp, high-contrast visuals in a compact 27 × 27 mm package. Driven by the SSD1306 controller over I2C, it requires only two I/O pins and operates across a wide 3.3–5V ra...

SKU: LB-OWL-HBRIDGE | Brand: Little Bird

Using the powerful L298N Dual Motor Driver，this module allows full control of two DC Motors or one stepper-motor. Screw Terminals for easy connections；LEDs show power and output status. Requires six digital inputs....

SKU: LB-LR0109 | Brand: Little Bird

Add Bluetooth functionality to your project with the HC-05 Bluetooth Module. The module is found on a breakout board which provides breadboard-friendly headers for power, ground, TX, RX and enable pins. The breakou...

SKU: EC-RPI08239D | Brand: Elecrow

This SSD expansion board is specifically designed for the Raspberry Pi 5, featuring PCIe and M.2 M-key interfaces that enable the use of high-speed M.2 NVMe solid-state drives. This setup enhances storage performance ...

SKU: LB-LR0102 | Brand: Little Bird

The DHT22 (also known in Australia by RHT03) is a low cost humidity and temperature sensor with a single wire digital interface. The sensor comes pre-calibrated and in a breadboard compatible module form so you don...

SKU: WS-25081 | Brand: Waveshare

Four versions — choose Memory and Headers above This page sells all four factory versions of the ESP32-S3-Zero. Two axes: how much memory the module carries, and whether the pin headers arrive already soldered on. Bot...

SKU: WS-19343 | Brand: Waveshare

A dual GPIO expander board for the Raspberry Pi Pico that duplicates all GPIO pins into two sets of 2×20 male headers. Plug your Pico into the centre female socket, then connect two expansion modules simultaneously — ...

SKU: PR-PIM357 | Brand: Little Bird

The state-of-the-art BME680 breakout lets you measure temperature, pressure, humidity, and indoor air quality, and is Raspberry Pi and Arduino-compatible! Use this breakout to monitor every aspect of your indoor en...

SKU: LB-LR0062 | Brand: Little Bird

This IR sensor can detect obstacles in front of it.  When an object is detected the green indicator light on the board will light up. There is a low-level output signal on the OUT port.It has a detection range of...

SKU: AF-4754 | Brand: Adafruit

The BNO085 from Hillcrest Laboratories is a 9-DOF IMU with built-in sensor fusion — it combines accelerometer, gyroscope and magnetometer data on-chip and delivers ready-to-use orientation, motion detection and activi...

SKU: WS-19361 | Brand: Waveshare

Quad GPIO Expander for Raspberry Pi Pico, Four Sets of Male Headers, USB Power Connector Quad GPIO Expander For Pico Four Sets Of Standard Raspberry Pi Pico GPIO Male Headers, USB-Powered Support Features At ...

SKU: SF-SEN-10988 | Brand: SparkFun

This is the same temperature sensor that is included in our SparkFun Inventor’s Kit. The TMP36 is a low voltage, precision centigrade temperature sensor. It provides a voltage output that is linearly proportional to t...

SKU: KI-5647 | Brand: Kitronik

The Prong Soil Moisture Sensor mounts directly onto a BBC micro:bit to monitor soil moisture levels. Two conductive tines are inserted into the soil — any moisture conducts an analogue voltage that the micro:bit reads...

SKU: LB-LR0029 | Brand: Little Bird

DHT11 Temperature and Humidity sensor is as powerful as it used to be but easier to use.  This  DHT11 Arduino temperature and humidity sensor has a full range temperature compensation, low power consumption...

SKU: LB-LS6795 | Brand: Little Bird

8-90V to 5V 5A DC-DC Step-Down Converter (25W, USB-C)This compact and efficient DC-DC step-down converter is designed to take an input voltage from 8V to 90V and regulate it down to a stable 5V output at up to 5A (25W...

SKU: LB-LR0214-148A | Brand: Little Bird

This PN532-based NFC module is designed for near field communication projects in the 13.56MHz range, with a maximum communication distance of 30mm.The board includes its own antenna and can communicate via SPI, IIC (I...

SKU: AF-3421 | Brand: Adafruit

The Adafruit I2S MEMS Microphone Breakout features the SPH0645LM4H, a tiny digital MEMS microphone with a purely digital I2S output. Unlike analogue electret microphones, this mic sends digital audio data directly to ...

SKU: LB-OWL-IR | Brand: Little Bird

An infrared receiver module that can read signals from most standard IR remote controls. Useful for adding remote control functionality to Arduino and microcontroller projects. Pair with an IR transmitter module to bu...