Individual LEDs

SKU: SF-COM-12903 | Brand: SparkFun

Sometimes when you have too many choices, it’s hard to make a good decision. In fact, there are times when you just want a bag of LEDs, just one of each, that’s all you want. Well too bad, you are getting two of each!...

SKU: AF-3377 | Brand: Adafruit

Add a little sparkle to your wearable project with Adafruit LED Sequins. These tiny sewable LED boards are the simpler sibling of Flora NeoPixels — they display a single colour with no digital control needed, making t...

SKU: AF-679 | Brand: Adafruit

These are very interesting 5mm diffused RGB LEDs - instead of having 4 pins to control 3 LEDs, they have only two leads - power and ground. When powered, the LEDs perform a slow fade through the rainbow, from re...

SKU: AF-5487 | Brand: Adafruit

These ultra-fine wired LEDs are designed for model-makers and crafters but they could also come in handy for folks who want to add tiny points of light to a design without needing SMT-level soldering skills. Use ...

SKU: AF-1756 | Brand: Adafruit

Add a little sparkle to your wearable project with Adafruit LED Sequins. These tiny sewable LED boards are the simpler sibling of Flora NeoPixels — they display a single colour with no digital control needed, making t...

SKU: SF-DEV-13903 | Brand: SparkFun

This is the LilyPad Rainbow LED strip, with seven LilyPad LEDs that are still attached to one another, letting you snap LEDs apart at your leisure to sew into clothing or whatever else you can dream up.The LilyPad Rai...

SKU: AF-301 | Brand: Adafruit

Need some really bright LEDs? We are big fans of these clear blue LEDs, in fact we use them exclusively in our kits. They are very bright and have about 20degree LED beam. They go easily into a breadboard and will add...

SKU: DF-DFR0438 | Brand: DFRobot

INTRODUCTION The Bright LED module is designed for some special application. It's using a very bright LED component as its light source. Compatible with DFRobot gravity 3-Pin interface, plug and play. What you ne...

SKU: LB-24-2-LED | Brand: Little Bird

Check out our tutorial here There are three pins:Signal: This pin is a signal pin, and can be used to emit a green lightMiddle Pin : This pin is another signal pin, and can be used to emit a red lightGND: Though it ...

SKU: AF-1476 | Brand: Adafruit

A 16mm illuminated pushbutton with a built-in blue LED and latching on/off action. Press once to switch on, press again to switch off — ideal for power switches, mode selectors, and control panels. The LED is wired i...

SKU: AF-2343 | Brand: Adafruit

These APA102C (DotStar) RGB LEDs feature an integrated driver chip inside each 5050 SMD package, giving you individually addressable 24-bit colour control (8 bits each for red, green, and blue). The same smart LED use...

SKU: AF-2350 | Brand: Adafruit

These APA102 (DotStar) warm white LEDs feature an integrated driver chip inside each 5050 SMD package, giving you individually addressable brightness control over three warm white (~3000K) dies. The phosphor coating p...

SKU: SF-COM-08862 | Brand: SparkFun

Huge 10mm through-hole LEDs. Mood light an entire wall! Features: 625-630nm Red 2.1-2.3VDC Forward Voltage 80mA Forward Current 30 degree viewing angle 10,000-12,000 MCD output Documents: Datasheet LED Tutorial

SKU: SF-DEV-14013 | Brand: SparkFun

A pack of five red LilyPad LEDs on a snap-apart strip. Each LED has large sew tabs for stitching into fabric with conductive thread, making them ideal for wearable electronics and e-textile projects. The ultra-thin 0....

SKU: SF-COM-10634 | Brand: SparkFun

Check out these big 10mm through-hole LEDs! The opaque epoxy package causes these LEDs to have a soft, diffuse glow.

SKU: LB-LS7756 | Brand: Little Bird

Packing list: 10 × White LEDs10 × Yellow LEDs10 × Blue LEDs10 × Green LEDs10 × Red LEDs1 × RGB LED2 × Photoresistors (LDR)1 × Thermistor5 × Rectifier Diodes (1N4007)5 × NPN Transistors (PN2222)1 × Optocoupler IC ...

SKU: AF-4776 | Brand: Adafruit

These are the smallest NeoPixel breakouts around! Tiny, bright RGB+White pixels to your project. These little PCBs are only 9.1mm x 9.1mm and have two sets of three pads on the back for soldering wires. These ultra...

SKU: AF-4684 | Brand: Adafruit

These incredibly small surface-mount LEDs are an easy way to add a lot of very tiny (but bright!) colorful dots to your project. They are just mind-bogglingly small - 2mm square. As they are pretty darn tiny, the...

SKU: AF-1477 | Brand: Adafruit

A 16mm illuminated pushbutton with a built-in blue LED and momentary action. The switch contacts connect only while the button is held down and return to their normally-open state when released — perfect for trigger i...

SKU: LB-LR0038 | Brand: Little Bird

This 3W high-power LED module delivers bright, warm white illumination with a luminous output of 180–200 lumens. With a wide 180° viewing angle and a forward voltage of just 3.3–3.6V, it's suitable for lighting projec...