Enclosures & Hardware

SKU: AF-6433 | Brand: Adafruit

Keep your Adafruit MagTag safe and looking sharp with this custom-designed 3D-printed enclosure. The snap-together two-piece case accommodates all connection ports and features flexible push tabs for the four front bu...

SKU: DF-FIT0032 | Brand: DFRobot

INTRODUCTIONA This bracket is designed for Gravity: Arduino Adjustable Infrared Distance Sensor which can be used for the obstacle avoidance or objection detection. It provides a easy ins...

SKU: DF-FIT0006 | Brand: DFRobot

This is a mounting bracket designed for our URM ultrasonic sensor series.It is fully compatible with URM37 and URM04. You can also have this item with only 300 reward points. SPECIFICATIONS Mounting Pitch: 14mm(0....

SKU: AF-2458 | Brand: Adafruit

Doesn't this fixture clamp look like a character in a Pixar movie?  If you just drew two little eyes on it then you could just imagine it hopping around on nifty, adorable little adventures that ar...

SKU: DF-FIT0139 | Brand: DFRobot

These nuts can be used to install your circuit boards, sensors and mechanical mountings. The wide flange at one end with an uneven surface eliminates the need for using extra washers to keep the nut tightly secur...

SKU: SF-PRT-08232 | Brand: SparkFun

A 3-pin polarised male header with standard 0.1" (2.54mm) pin spacing. The keyed design prevents incorrect or reversed connections, making it ideal for power and sensor connections on perfboard and PCB projects. Spec...

SKU: SF-PRT-08100 | Brand: SparkFun

Individual crimp pins for use with polarized connector housings. These pins prevent incorrect or reversed connections, making them ideal for power, sensor, and general-purpose wiring on perfboard and PCB projects. At...

SKU: SF-PRT-08097 | Brand: SparkFun

Polarized connectors and headers for your perf board/PCB projects. Use these connectors for power connections or any sensor/general connection to prevent users from connecting the peripheral incorrectly or reversed. T...

SKU: SF-PRT-10739 | Brand: SparkFun

Metal short standoffs: 3/8" long x ¼"OD. Used to get your proto board up off the table. #4-40 thread. Fits all development boards with available holes. Don’t forget the screws! Related below. Note: These are sold as a...

SKU: DF-FIT0475 | Brand: DFRobot

This plywood case is a solid enclosure for your LattePanda Windows 10 SBC. The case protects the board from ESD damage while letting you see status LEDs and providing access to USB, HDMI, SD card, GPIO and anten...