DFRobot

SKU: DF-DFR0198 | Brand: DFRobot

This is a waterproofed version of the DS18B20 Temperature sensor. Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PV...

SKU: DF-DFR0339 | Brand: DFRobot

Bluno Beetle - The smallest Arduino Board is another milestone in wearable electronics device area based arduino uno, which makes DIY users have more options in the project design. It is fully compatible with Bluno...

SKU: DF-SEN0308 | Brand: DFRobot

The Gravity Analogue Waterproof Capacitive Soil Moisture Sensor from DFRobot measures soil moisture using capacitive sensing rather than resistive probes, offering significantly better corrosion resistance and longer ...

SKU: DF-KIT0021 | Brand: DFRobot

A waterproof DS18B20 digital temperature sensor kit with everything you need to connect to an Arduino. The stainless steel probe measures temperatures from -55°C to +125°C over a 1-Wire interface, requiring just one d...

SKU: DF-SEN0244 | Brand: DFRobot

The Gravity Analog TDS Sensor is an Arduino-compatible kit for measuring Total Dissolved Solids (TDS) in water. TDS indicates how many milligrams of soluble solids are dissolved per litre — the higher the value, the l...

SKU: DF-SEN0257 | Brand: DFRobot

The Gravity Analog Water Pressure Sensor measures water or gas pressure and outputs a linear 0.5–4.5 V analogue signal proportional to the applied pressure (0–1.6 MPa). Using the DFRobot Gravity 3-pin interface, it co...

SKU: DF-DFR0975 | Brand: DFRobot

FireBeetle 2 ESP32-S3 is a high-performance main controller built around the ESP32-S3-WROOM-1-N16R8 module. ESP32-S3-WROOM-1-N16R8 comes with 16MB Flash and 8MB PSRAM for storing more data. The acceleration for neural...

SKU: DF-DFR0626 | Brand: DFRobot

This is an IO expansion module that based on the chip MCP23017. The module can expand additional 16 IOs. It can set 8 IIC addresses, which means with this module, the microcontroller can connect 8 modules, and expand ...

SKU: DF-SEN0311 | Brand: DFRobot

A commercial-grade waterproof ultrasonic distance sensor with UART serial output. The A02YYUW features a much smaller blind zone (3 cm) and wider sensing angle than many comparable sensors, plus penetration through sm...

SKU: DF-SEN0212 | Brand: DFRobot

The TCS34725 is an I2C RGB colour sensor that detects the red, green, and blue components of light in its environment and returns digital colour values. With high sensitivity, a wide dynamic range, and a built-in IR b...

SKU: DF-SEN0527 | Brand: DFRobot

The Fermion AHT20 is a high-precision, low-cost temperature and humidity sensor breakout from DFRobot. Built around an improved MEMS semiconductor capacitive humidity sensor element, it communicates over a standard I2...

SKU: DF-SEN0374 | Brand: DFRobot

BNO055 is a new sensor IC for implementing an intelligent 9-axis Absolute Orientation Sensor. It is a System in Package, integrating a triaxial 14-bit accelerometer, a triaxial 16-bit gyroscope, a triaxial geomagnetic...

SKU: DF-DFR0296 | Brand: DFRobot

The Bluno Nano combines an Arduino Nano-compatible ATmega328 microcontroller with an integrated TI CC2540 Bluetooth 4.0 (BLE) module in a compact 53 × 19 mm form factor. It enables wireless communication, wireless pro...

SKU: DF-DFR1075 | Brand: DFRobot

The FireBeetle 2 ESP32-C6 is a low-power IoT development board built around a 160MHz RISC-V single-core processor. It supports Wi-Fi 6 (802.11ax), Bluetooth 5, Zigbee 3.0, Thread 1.3, and the Matter smart home standar...

SKU: DF-SEN0032 | Brand: DFRobot

Breakout board for the Analog Device ADXL345. The ADXL345 is a small, thin, low power, 3-axis accelerometer with high resolution (13-bit) measurement at up to ±16 g. Digital output data is formatted as 16-bit twos ...

SKU: DF-DFR0076 | Brand: DFRobot

This Gravity analog flame sensor detects fire and infrared light sources in the 760–1,100 nm wavelength range. With a 60° detection angle and analogue output proportional to flame distance, it's widely used in firefig...

SKU: DF-TEL0163 | Brand: DFRobot

The A7670G is a global 4G CAT1 communication module that brings cellular connectivity to your IoT projects. With support for LTE-FDD, LTE-TDD, and GSM bands worldwide, it provides reliable data transmission at up to 1...

SKU: DF-SEN0572 | Brand: DFRobot

The Fermion MEMS H2 Sensor is a compact hydrogen gas detection module using micro-electromechanical system (MEMS) technology. It provides qualitative measurement of hydrogen concentration from 0.1 to 1000 ppm via an a...

SKU: DF-DFR0023 | Brand: DFRobot

This is an Arduino Temperature Sensor based on LM35 temperature chip. A Temperature Sensor can be used to detect ambient air temperature.The LM35 chip is produced by National Semiconductor Corporation and offers a fun...

SKU: DF-SEN0566 | Brand: DFRobot

Fermion: MEMS Volatile Organic Compounds VOC Gas Sensor employs state-of-the-art microelectromechanical system (MEMS) technology, endowing the sensor with compact dimensions (13x13x2.5mm), low power consumption (<20mA...