DFRobot

SKU: DF-DFR0339 | Brand: DFRobot

Bluno Beetle - The smallest Arduino Board is another milestone in wearable electronics device area based arduino uno, which makes DIY users have more options in the project design. It is fully compatible with Bluno...

SKU: DF-SEN0257 | Brand: DFRobot

The Gravity Analog Water Pressure Sensor measures water or gas pressure and outputs a linear 0.5–4.5 V analogue signal proportional to the applied pressure (0–1.6 MPa). Using the DFRobot Gravity 3-pin interface, it co...

SKU: DF-SEN0212 | Brand: DFRobot

The TCS34725 is an I2C RGB colour sensor that detects the red, green, and blue components of light in its environment and returns digital colour values. With high sensitivity, a wide dynamic range, and a built-in IR b...

SKU: DF-DFR0296 | Brand: DFRobot

The Bluno Nano combines an Arduino Nano-compatible ATmega328 microcontroller with an integrated TI CC2540 Bluetooth 4.0 (BLE) module in a compact 53 × 19 mm form factor. It enables wireless communication, wireless pro...

SKU: DF-DFR0315 | Brand: DFRobot

FEATURESAPPLICATIONSSPECIFICATIONSNote: It has been newest Model: A1M8 --2017/5/15 DOCUMENTS SLAMTEC Website Development Kit SDK & Datasheet Related Rplidar Review by Gavin (@MechatronicsGuy) ICP-SLAM based on Rob...

SKU: DF-TEL0163 | Brand: DFRobot

The A7670G is a global 4G CAT1 communication module that brings cellular connectivity to your IoT projects. With support for LTE-FDD, LTE-TDD, and GSM bands worldwide, it provides reliable data transmission at up to 1...

SKU: DF-SEN0165 | Brand: DFRobot

In the ever-increasing need and awareness for health and safety, water has become a focus point for proper disinfection treatment as aftereffects of industrialization can become a danger for contamination of water...

SKU: DF-SEN0219 | Brand: DFRobot

The concentration of carbon dioxide (0.03% usuallly) is related to daily life. Recently, there's a study showing that the atmospheric CO2 content has reached 0.0385% (385 ppm) which is the highest value since 2.1 ...

SKU: DF-SEN0170 | Brand: DFRobot

A three-cup anemometer kit with 0–5V analog voltage output for building custom weather stations and wind monitoring systems. The aluminium alloy construction provides high strength, weather resistance, and corrosion r...

SKU: DF-SEN0216 | Brand: DFRobot

The Water Flow sensor measures the rate of a liquid flowing through it. The YF-S401 water flow sensor consists of a plastic valve body, flow rotor and hall effect sensor. It is usually used at the inlet end to det...

SKU: DF-SEN0487 | Brand: DFRobot

This tiny MEMS microphone has an amplifier gain of 66. When there is no sound detected, it outputs voltage around 0.66*VCC. When speaking, you can easily get the acoustic waveform by ADC sampling. The module can be us...

SKU: DF-SEN0134 | Brand: DFRobot

The Gravity MQ-9 gas sensor detects carbon monoxide (CO) and combustible gases including methane and propane. It uses a semiconductor SnO2 sensing element that cycles between high and low temperatures — detecting CO a...

SKU: DF-DFR1199 | Brand: DFRobot

An all-in-one stepper motor module combining the 28BYJ-48 geared stepper with an A4988 driver on a single board. The simplified 4-pin interface (STEP, DIR, 5V, GND) connects directly to Arduino, Raspberry Pi, or ESP32...

SKU: DF-SEN0641 | Brand: DFRobot

The RS485 PAR Sensor measures photosynthetically active radiation in the 400–700 nm wavelength range — the light spectrum that plants use for photosynthesis. It converts incident radiation into a signal proportional t...

SKU: DF-DFR1085 | Brand: DFRobot

##Introduction The new Arduino UNO R4 comes in two versions: the UNO R4 WiFi and the UNO R4 Minima. It runs on the Renesas RA4M1 (Arm Cortex®-M4) processor, with a clock speed of 48MHz, which provides a 3x increase ov...

SKU: DF-SEN0623 | Brand: DFRobot

The C1001 mmWave Human Detection Sensor is a high-precision 60GHz millimeter-wave radar sensor engineered for advanced human detection. Unlike standard 24GHz millimeter-wave sensors that are limited to detecting prese...

SKU: DF-SEN0177 | Brand: DFRobot

The Gravity Laser PM2.5 Air Quality Sensor uses laser scattering to measure suspended particulate matter concentrations in the air. It detects particles from 0.3 to 10 µm in diameter and outputs digital concentration ...

SKU: DF-SEN0128 | Brand: DFRobot

An analogue alcohol gas sensor based on the MQ-3 probe, designed for use with Arduino and other microcontrollers. The sensor outputs a voltage proportional to the concentration of alcohol vapour in the surrounding air...

SKU: DF-DFR0356 | Brand: DFRobot

INTRODUCTION The Bluno Beetle Shield expands the Beetle's single analog and digital I/O pins to the 3 pin "gravity" interface, giving more power and ground connections and making it easier to attach gravity inter...

SKU: DF-SEN0002 | Brand: DFRobot

The URM04 Ultrasonic sensor is developed based upon our popular URM37 ultrasonic sensor, it is using RS485 interface which allows multiple sensors to be used simultaneously . The RS485 interface allows a number of...