Brands

SKU: DF-FIT0172 | Brand: DFRobot

A waterproof DC-DC step-up converter that takes 8–18V DC input and outputs a stable 24V at up to 10A (240W). The sealed, shockproof enclosure makes it suitable for robotics, outdoor installations, and demanding enviro...

SKU: DF-DFR0174 | Brand: DFRobot

The XBee USB Adapter V2 is an update version from DFRobot. It features an Atmega8U2 programmed as a USB-to-serial converter, the same chip found on the Arduino Uno. The Atmega8U2 firmware uses the standard USB ...

SKU: SF-PRT-14313 | Brand: SparkFun

This Digital LED Voltmeter measures the voltage at a particular point of the system it has been hooked up to and then provides a readout on its three 7-segment LEDs. This voltmeter is able to provide a readout of volt...

SKU: DF-FIT0014 | Brand: DFRobot

How can your robot rule the world with an iron fist if it doesn't have a hand? This LG-NS robot gripper makes a great addition to a small arm or mobile base. The gripper features injection molded components and ...

SKU: SF-ROB-09347 | Brand: SparkFun

Here, for all your mechatronic needs, is a simple, high quality continuous continuous rotation servo motor. This servo is able to take in 6 volts and deliver 66.7 oz-in. of maximum torque at 70 r/min. A standard 3-p...

SKU: SF-BOB-09322 | Brand: SparkFun

A simple breakout PCB for the GP1A57HR photo interrupter (also known as a photogate, photodiode, or phototransistor). This PCB has three connections for PWR, GND, and Signal.When the gate is clear, SIG will be high (>...

SKU: SF-DEV-14285 | Brand: SparkFun

The SparkFun Wireless Motor Driver Shield is designed to make connecting motors, sensors and other components to your Arduino-based project as fast and easy as possible. The heart of the Wireless Motor Driver Shield i...

SKU: DF-FIT0187 | Brand: DFRobot

This rubber ring is used to afix ultrasonic sensor. It fits URM37 V4.0 Ultrasonic Sensor For Arduino / Raspberry Pi and URM04 Ultrasonic Sensor (RS485). NOTE: Other ultrasonic sensor may fit, you have to check...

SKU: DF-FIT0084-R | Brand: DFRobot

A pack of 10 red straight male pin header strips, each with 40 pins at standard 2.54 mm (0.1") spacing. These single-row headers are compatible with solderless breadboards, perforated prototyping PCBs, female headers,...

SKU: DF-FIT0036 | Brand: DFRobot

This is a high quality plastic servo horn. It fits DF series servos. Made specifically for DF series servos. SPECIFICATIONS Outside diameter: 20mm(0.79") Center hole diameter: 3mm(0.12") Moun...

SKU: AF-466 | Brand: Adafruit

The VCNL4010 sensor is a nice way to add a small-distance proximity sensor to your microcontroller project. For longer distances (in the range of cm, you can use a SHARP IR distance sensor, but those are only good ...

SKU: DF-FIT0084-B | Brand: DFRobot

A pack of 10 blue straight male pin header strips, each with 40 pins at standard 2.54 mm (0.1") spacing. These single-row headers are compatible with solderless breadboards, perforated prototyping PCBs, female headers...

SKU: SF-WRL-09232 | Brand: SparkFun

This is an adapter that converts an RP-SMA board to an SMA antenna. The adapter will connect to any of our 2.4GHz wireless boards (Bluetooth, Nordic, or XBee) or interface cables and will allow you to use an ant...

SKU: SF-WRL-09233 | Brand: SparkFun

The SMA Male to RP-SMA Male Adapter converts between SMA and RP-SMA connector types, making it easy to pair antennas and cables that use different threading configurations. One end features a standard SMA male connect...

SKU: SF-ROB-09238 | Brand: SparkFun

This is a simple, but very powerful stepper motor with a 4-wire cable attached. This is a Bipolar Motor. Features: Step Angle (degrees) :1.8 2 Phase Rated Voltage : 12V Rated Current : 0.33A Holding Torque : 2.3k...

SKU: AF-2759 | Brand: Adafruit

What is better than smart RGB LEDs? Smart RGB+White LEDs! These NeoPixels now have 4 LEDs in them (red, green, blue and white) for excellent lighting effects. Make your own smart RGBW LED arrangement with the same ...

SKU: SF-TOL-14235 | Brand: SparkFun

The Xcelite 8-in-1 Screwdriver Set provides eight high-quality bits in a single ergonomic tool. Each bit is easily accessible with a spring-loaded magnetic housing that holds the seven included bits you aren’t current...

SKU: AF-2757 | Brand: Adafruit

What is better than smart RGB LEDs? Smart RGB+White LEDs! These NeoPixels now have 4 LEDs in them (red, green, blue and white) for excellent lighting effects. Make your own smart RGBW LED arrangement with the sa...

SKU: DF-SEN0131 | Brand: DFRobot

INTRODUCTION This is an Arduino Propane Gas Sensor. It uses MQ6 probe to detect iso-butane, propane and liquefied petroleum gas (LPG). It is less sensitive with alcohol, cooking fumes an...

SKU: AF-2758 | Brand: Adafruit

What is better than smart RGB LEDs? Smart RGB+White LEDs! These NeoPixels now have 4 LEDs in them (red, green, blue and white) for excellent lighting effects. Make your own smart RGBW LED arrangement with the same ...