Brands

SKU: AF-2184 | Brand: Adafruit

These five blank pages are designed for keeping taped parts, specifically for 24mm or smaller tape. Each page has 6 rows or slots that you can slide your tape into. The slots are 3.5" long. These pages are...

SKU: PL-2739 | Brand: Pololu

The Pololu AltIMU-10 v5 is a compact inertial measurement unit (IMU) and altimeter that combines a gyroscope, accelerometer, magnetometer, and barometric pressure sensor on a single board. It provides ten independent ...

SKU: AF-2237 | Brand: Adafruit

The Adafruit DotStar Digital LED Strip (30 LED/m, black flex PCB) delivers superior performance over traditional NeoPixels with its 2-wire SPI interface. Push data at up to 32 MHz clock speed with no critical timing r...

SKU: AF-2242 | Brand: Adafruit

The Adafruit DotStar Digital LED Strip (144 LED/m, white flex PCB) delivers superior performance over traditional NeoPixels with its 2-wire SPI interface. Push data at up to 32 MHz clock speed with no critical timing ...

SKU: AF-2276 | Brand: Adafruit

The 64×32 RGB LED Matrix Panel with 6mm pitch features 2048 bright RGB LEDs in a 384×192mm panel. The widest pixel spacing in the 64×32 range, this panel is designed for viewing from the greatest distance, making it i...

SKU: AF-2270 | Brand: Adafruit

The "poor woman's" Raspberry Pi A+ / B+ / Pi 2 cobbler! This combo of 2x20 pin (0.1 spaced) header and socket is for our popular GPIO Ribbon Cable for Raspberry Pi Model A+/B+/Pi 2 (40 pins).  It comes in...

SKU: AF-2353 | Brand: Adafruit

This 7.0" TFT display packs 800×480 pixels with an LED backlight and 24-bit colour capability via its 40-pin connector (8 red, 8 green, 8 blue parallel pins). It's ideal for projects requiring a large display area for...

SKU: AF-2378 | Brand: Adafruit

The Arduino Pro Mini is SparkFun's minimal design approach to Arduino.  It's essentially a 5v Arduino that runs an 16 MHz bootloader on a super small, super thin board.  There are no connectors attached -...

SKU: AF-2359 | Brand: Adafruit

The Adafruit Raspberry Pi A+ Case is a slim, durable polycarbonate enclosure designed specifically for the Raspberry Pi Model A+. With a smoke-tinted base and clear top, it offers a clean, professional look while keep...

SKU: AF-1839 | Brand: Adafruit

Making Wearables with an Arduino-Compatible Electronics PlatformThis book introduces readers to building wearable electronics projects using Adafruit's tiny FLORA board: at 4.4 grams, and only 1.75 inches in diameter...

SKU: AF-2278 | Brand: Adafruit

The 64×32 RGB LED Matrix Panel with 4mm pitch features 2048 bright RGB LEDs in a 256×128mm panel. This mid-range pitch offers a good balance between pixel density and viewing distance, suitable for indoor displays vie...

SKU: PL-2578 | Brand: Pololu

This module features a fixed-gain, 38 kHz modulated IR sensor and a corresponding IR LED with oscillator circuit to make a tiny proximity sensor. This high-brightness version draws an average of 16 mA at 5&...

SKU: DF-SEN0014 | Brand: DFRobot

The Sharp distance sensors are a popular choice for many projects that require accurate distance measurements. This IR sensor is more economical than sonar rangefinders, yet it provides much better performance than o...

SKU: DF-ROB0021 | Brand: DFRobot

The HCR Mobile Robot Kit is a two wheel drive mobile robot platform with three levels (if you want, you can use only the parts you need, or make a two level robot). The mobile robot kit contains two motors, two ...

SKU: DF-FIT0004 | Brand: DFRobot

A black anodised pan-and-tilt assembly designed for horizontal surface mounting. Built using two DFRobot servo brackets, this kit provides two axes of rotation for cameras, sensors, or other payloads on small robots a...

SKU: AF-2420 | Brand: Adafruit

A slim, high-quality HDMI cable measuring just 450mm (1.5 feet) long with a ultra-thin ~4mm diameter. Designed to connect two HDMI devices together while staying out of the way in tight spaces and tidy setups. Featur...

SKU: DF-FIT0099 | Brand: DFRobot

A prototyping board is one of the main steps in hardware development, also called a perf board. Breadboard, wiring and punching in chips, resistors and leds is probably the first step. While this is good to confirm a...

SKU: AF-2461 | Brand: Adafruit

Wow that's a tiny GPS antenna! This passive antenna is only 15mm x 15mm x 6.8mm in size, with a 50mm long uFL cable. Great for when you want to keep things small. Comes with a standard uFL connector on the end. Pe...

SKU: DF-FIT0104 | Brand: DFRobot

A pack of ten 8-pin female headers with standard 2.54 mm pitch, designed for use with Arduino boards. These headers are ideal for replacing damaged headers, building custom shields, or prototyping on breadboards and p...

SKU: PL-2510 | Brand: Pololu

Overview A Zumo robot preparing to attack a Parallax SumoBot. Zumo Robot for Arduino, v1.2. This Zumo robot is a low-profile tracked robot platform intended for use with an Arduino (or compatible device, such...