Brands and Manufacturers

SKU: AF-424 | Brand: Adafruit

A six-piece precision screwdriver set covering the most common sizes found in consumer electronics, small devices, and maker projects. The set includes three Phillips and three flat-head drivers in a compact carrying ...

SKU: SF-DEV-10914 | Brand: SparkFun

It’s blue! It’s skinny! It’s the Arduino Pro! SparkFun’s minimal design approach to Arduino. This is a 3.3V Arduino running the 8MHz bootloader. Because the system voltage for this board is lower than other Arduino...

SKU: AF-425 | Brand: Adafruit

A 4-pin Molex power cable that matches the hard drive/CD-ROM power connectors found on AT and ATX power supplies. Use it to tap into 5V or 12V DC from a desktop power supply for your projects — a convenient source of ...

SKU: SF-PRT-13061 | Brand: SparkFun

This 6 position screw terminal block provides a simple way to connect wires to a single connection point. These blocks allow wires to be screwed together and self-isolated without needing to twist, solder or any other...

SKU: SF-KIT-13053 | Brand: SparkFun

Holy Wattage, Batman! This Power Resistor Kit comes with 5 each of 5 different 10 Watt resistor values including 1, 2, 4, 8, and 16 Ohms. These resistors are capable of dissipating large amounts of power without damag...

SKU: DF-DFR0352 | Brand: DFRobot

This standard sheild for WRTnode is directly stackable with the WRTnode Mini OpenWRT Dev Board. WRTnode (A Mini OpenWRT Dev Board) uses a MTK MT7620N 580MHZ MIPS CPU, and is powerful in both interface an...

SKU: SF-ROB-10848 | Brand: SparkFun

These steppers have a threaded shaft, which allows them to be used as a linear actuator. As the motor runs, it moves along the shaft at a specific rate of 1cm per 5 full rotations. These are a good choice for linear m...

SKU: SF-PRT-10853 | Brand: SparkFun

This is a wire assembly terminated with the same 8-pin JST-SH connector which is on the Mega Pro Mini. Pick up a few of these to break out all of those pesky pins. Integrating these connectors into your projects ma...

SKU: AF-443 | Brand: Adafruit

For really big projects, give yourself some room to work in, with a massive 2250-point breadboard - equivalent in size to three full sized breadboards side by side.The breadboards are mounted onto a metal plate, and ...

SKU: AF-462 | Brand: Adafruit

Turn any Arduino into an AVR chip programmer with this shield kit. Designed for burning Arduino bootloaders onto blank ATmega328P chips, it can also be configured as a standalone AVR ISP programmer that works without ...

SKU: AF-415 | Brand: Adafruit

EL tape is the flat, wide cousin of EL wire — same glowing effect but in a 1cm-wide strip format. The glowing surface is 1cm wide (plastic coating is about 1.5cm), with adhesive on the back for easy mounting. Covered ...

SKU: AF-475 | Brand: Adafruit

This 30mm translucent green arcade button features a crystal-clear glossy finish and smooth button action. A pre-installed micro-switch with gold-plated contacts provides a satisfying press with tactile feedback — no ...

SKU: SF-WRL-13002 | Brand: SparkFun

This ANT500 is a telescopic antenna designed for operation from 75 MHz to 1 GHz with a total length that is configurable from 20 cm to 88 cm long. Each ANT500 is constructed of stainless steel and features an SMA male...

SKU: AF-3270 | Brand: Adafruit

Adafruit offers fun and exciting stickers for achievement in electronics, science and engineering. We believe everyone should be able to be rewarded for learning a useful skill, a sticker is just one of the...

SKU: SF-CAB-10759 | Brand: SparkFun

Integrating Ethernet support into your project is a great way to relay data through a local area network and even bounce information out to the internet. Sometimes it’s hard to get power to your Ethernet devices. Woul...

SKU: SF-SEN-10740 | Brand: SparkFun

An evaluation board for the MLX90614 non-contact infrared thermometer sensor. It pairs the MLX90614 with an ATmega328 running at 3.3 V (8 MHz Arduino bootloader), giving you a ready-to-use IR temperature sensor with s...

SKU: AF-498 | Brand: Adafruit

This is a fancy upgrade to standard 20x4 LCDs, instead of just having blue and white, or red and black, this LCD has full color RGB characters on a dark/black background! That means you can change the character displa...

SKU: SF-PRT-10739 | Brand: SparkFun

Metal short standoffs: 3/8" long x ¼"OD. Used to get your proto board up off the table. #4-40 thread. Fits all development boards with available holes. Don’t forget the screws! Related below. Note: These are sold as a...

SKU: SF-PRT-10687 | Brand: SparkFun

A 33-metre roll of polyimide (Kapton-style) tape that withstands temperatures up to 258°C (496°F). This high-temperature adhesive tape is an excellent electrical insulator with good corrosion resistance, and its silic...

SKU: AF-499 | Brand: Adafruit

This 20×4 character LCD features black text on a full-colour RGB backlight that you can set to any colour — red, green, blue, purple, teal, white, and everything in between. It's the most daylight-readable character L...