Brands and Manufacturers

SKU: DF-DFR0477 | Brand: DFRobot

The Realtek Ameba RTL8195AM is an IoT microcontroller module that combines a 32-bit ARM Cortex-M3 MCU (166 MHz) with Wi-Fi 802.11 b/g/n and NFC (Near Field Communication) on a single chip. It supports Arduino and Micr...

SKU: SF-GPS-14414 | Brand: SparkFun

The SparkFun XA1110 GPS Breakout is a small I2C-supported module built for easy hookup, thanks to our Qwiic Connect System. Equipped with the XA1110 GPS module from GTOP, this board utilizes the MediaTek MT3333 chips...

SKU: SF-GPS-15136 | Brand: SparkFun

With GPS you are able to know where you are, where you’re going, and how to get there anywhere on Earth within 30 seconds. This means the higher the accuracy the better! GPS Real Time Kinematics (RTK) has mastered dia...

SKU: AF-4064 | Brand: Adafruit

The Adafruit Grand Central M4 Express is a powerful development board built around the Microchip ATSAMD51P20 — a 120 MHz Cortex M4 processor with hardware floating point, 1 MB Flash, and 256 KB RAM. In the familiar Ar...

SKU: AF-4019 | Brand: Adafruit

If you're like me, you've dreamed of being a dolphin - smoothly gliding through the water. Using your echo-location abilities to detect tasty fish treats. Until genetic modifications catches up with our desires,...

SKU: AF-3242 | Brand: Adafruit

The Feather 32u4 Bluefruit LE with Stacking Headers combines an ATmega32u4 microcontroller with a Bluetooth Low Energy module, USB connectivity, and LiPo battery charging — with stacking headers pre-soldered so you ca...

SKU: AF-2438 | Brand: Adafruit

With this handy 7 Pin Mini-DIN Connector you can now jack into the hackport on your iRobot and control it with an Arduino or some other favorite microcontroller that has a 5V TTL UART! You can also power your proje...

SKU: AF-2479 | Brand: Adafruit

The Adafruit Bluefruit LE UART Friend adds Bluetooth Low Energy connectivity to any microcontroller or computer with a hardware or software serial port. With hardware flow control built in, you won't lose data during ...

SKU: DF-SEN0005 | Brand: DFRobot

This low cost SFR02 ultrasonic ranger has both I2C and Serial interfaces. New AutoTune algorithms intelligently back the minimum range right up to the transducer ringdown for the very best performance possible, aut...

SKU: DF-SEN0233 | Brand: DFRobot

A multifunction air quality monitor that measures particulate matter (PM2.5), formaldehyde concentration, temperature, and humidity. It uses laser scattering to detect suspended particles in the air, an electrochemica...

SKU: DF-TEL0020 | Brand: DFRobot

This is the XBee XB24-Z7WIT-004 module from Digi. Series 2 improves on the power output and data protocol. Series 2 modules allow you to create complex mesh networks based on the XBee ZB ZigBee mesh firmware. Th...

SKU: DF-DFR0174 | Brand: DFRobot

The XBee USB Adapter V2 is an update version from DFRobot. It features an Atmega8U2 programmed as a USB-to-serial converter, the same chip found on the Arduino Uno. The Atmega8U2 firmware uses the standard USB ...

SKU: SF-DEV-14285 | Brand: SparkFun

The SparkFun Wireless Motor Driver Shield is designed to make connecting motors, sensors and other components to your Arduino-based project as fast and easy as possible. The heart of the Wireless Motor Driver Shield i...

SKU: DF-SEN0135 | Brand: DFRobot

The HRLV-MaxSonar-EZ (MB1013) is a high-resolution ultrasonic distance sensor with 1 mm resolution and a range of up to 5 metres. It features multiple output formats, internal temperature compensation, virtually no de...

SKU: SF-PRT-08780 | Brand: SparkFun

A compact RS232-to-TTL level shifter board that converts both TX and RX lines bidirectionally. Powered from your target application's supply voltage, it automatically converts RS232 signals to match — run it at 5 V fo...

SKU: SF-DEV-14050 | Brand: SparkFun

The SparkFun Serial Basic Breakout is an easy-to-use USB-to-Serial adapter based on the CH340G IC from WCH. It works with 5V and 3.3V systems and should auto install on most operating systems without the need for a...

SKU: SF-SEN-11862 | Brand: SparkFun

RFID (radio-frequency identification) is the wireless non-contact use of radio-frequency electromagnetic fields, for the purposes of identifying and tracking tags attached to objects. This is the ID-3LA, a very simple...

SKU: SF-PRT-00449 | Brand: SparkFun

The smallest and easiest to use serial conversion circuit on the market! This board has one purpose in life - to convert RS232 to TTL and vice versa (TX and RX). This will allow a microcontroller to communicate with a...

SKU: AF-3061 | Brand: Adafruit

The Feather M0 WiFi with uFL pairs the ATSAMD21G18 ARM Cortex M0+ processor with an ATWINC1500 Wi-Fi module, featuring a uFL connector instead of an on-board antenna. This allows you to connect an external 2.4 GHz ant...

SKU: SF-GPS-13670 | Brand: SparkFun

The GP-735 is a slim, ultra-high performance, easy to use GPS smart antenna receiver. With -162dBm tracking sensitivity and only 29 second cold start time, the GP735 is a tiny, yet powerful, piece of tech. The slim de...