Brands and Manufacturers

SKU: LB-OWL-HBRIDGE | Brand: Little Bird

Using the powerful L298N Dual Motor Driver，this module allows full control of two DC Motors or one stepper-motor. Screw Terminals for easy connections；LEDs show power and output status. Requires six digital inputs....

SKU: WS-21354 | Brand: Waveshare

A protective ABS case designed for the Raspberry Pi Zero series, compatible with the Zero, Zero W, and Zero 2 W. The case features precise cutouts for all connectors and a reversed GPIO slot for easy access to the hea...

SKU: DF-DFR0198 | Brand: DFRobot

This is a waterproofed version of the DS18B20 Temperature sensor. Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PV...

SKU: DF-DFR0836 | Brand: DFRobot

Note: The product not inclueded Raspberry Pi Pico. This IO expansion board brings out all IO pins of the Raspberry Pi Pico onto male and female connectors. All pins are clearly labeled to allow beginners to quick...

SKU: WS-22311 | Brand: Waveshare

HRB8825 Stepper Motor HAT For Raspberry Pi, Drives Two Stepper Motors, Up To 1/32 Microstepping Stepper Motor HAT (B) Alternative Solution Of Stepper Motor HAT, Drives Two Stepper Motors, Up To 1/32 Microstep...

SKU: WS-27670 | Brand: Waveshare

The PoE HAT (G) is an IEEE 802.3af/at-compliant PoE (Power Over Ethernet) HAT for Raspberry Pi 5 / CM 5. By using with a PoE router or switch that supports the IEEE 802.3af/at network standard, it is po...

SKU: WS-19343 | Brand: Waveshare

A dual GPIO expander board for the Raspberry Pi Pico that duplicates all GPIO pins into two sets of 2×20 male headers. Plug your Pico into the centre female socket, then connect two expansion modules simultaneously — ...

SKU: WS-19361 | Brand: Waveshare

Quad GPIO Expander for Raspberry Pi Pico, Four Sets of Male Headers, USB Power Connector Quad GPIO Expander For Pico Four Sets Of Standard Raspberry Pi Pico GPIO Male Headers, USB-Powered Support Features At ...

SKU: WS-29320 | Brand: Waveshare

A dual-function HAT for Raspberry Pi 5 that adds M.2 NVMe SSD support via the Pi's PCIe interface and delivers Power over Ethernet (PoE) — combining fast storage and single-cable power/networking into one board. Supp...

SKU: SF-SEN-13879 | Brand: SparkFun

The SparkFun Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. By connecting the amplifier to your microcontroller you will be able to read the...

SKU: LB-LS7233 | Brand: Little Bird

Upgrade your Raspberry Pi experience with our GPIO Expansion Extension Board Screw Terminal Hat! This beautifully designed screw terminal expansion version is the perfect addition to your electronic experiments. Conve...

SKU: LB-LS4690 | Brand: Little Bird

Digital temperature sensor DS18B20, waterproof case. Working range from -55 to 125 degrees. Resolution 0.5 in range from -10 up to 85 degrees.

SKU: AF-5302 | Brand: Adafruit

The Adafruit KB2040 is an RP2040-powered board designed specifically for mechanical keyboard builds, in the Arduino Pro Micro form factor. With castellated pads, USB-C, 8 MB of Flash, and a STEMMA QT / Qwiic connector...

SKU: DF-DFR0924 | Brand: DFRobot

A terminal block expansion board for the Raspberry Pi Pico, designed for makers who prefer screw-terminal connections over soldering or breadboard wiring. Every Pico pin is broken out to a labelled terminal block, pro...

SKU: AF-5778 | Brand: Adafruit

The Adafruit Matrix Portal S3 is the next-generation plug-and-play controller for HUB-75 RGB LED matrix panels. Powered by the ESP32-S3 with built-in WiFi and Bluetooth LE, it plugs directly into the back of any compa...

SKU: PI-PIM721 | Brand: Pimoroni

The Tiny 2350 is a postage-stamp-sized development board powered by the RP2350A — a dual ARM Cortex-M33 running at up to 150 MHz with 520 KB SRAM and 4 MB of QSPI flash. It's programmable via USB-C with C/C++ or Micro...

SKU: SF-SEN-11050 | Brand: SparkFun

This sealed digital temperature probe lets you precisely measure temperatures in wet environments with a simple 1-Wire interface. The DS18B20 provides 9 to 12-bit (configurable) temperature readings over a 1-Wire i...

SKU: SF-WRL-20168 | Brand: SparkFun

The SparkFun ESP32 WROOM Thing Plus is a Feather-compatible development board built around Espressif's ESP32-WROOM module, featuring USB-C, integrated Wi-Fi and Bluetooth, a microSD card slot, LiPo battery management ...

SKU: DF-DFR1096 | Brand: DFRobot

The Arduino Nano ESP32 brings the ESP32-S3 (u-blox NORA-W106 module) into the familiar Nano form factor with a USB-C connector. It supports both Arduino and MicroPython programming, making it an accessible entry point...

SKU: SF-BOB-12009 | Brand: SparkFun

The SparkFun Bi-Directional Logic Level Converter safely translates signals between different voltage levels — stepping 5V down to 3.3V and 3.3V up to 5V on the same channel. It also works with 2.8V and 1.8V devices, ...