Brands and Manufacturers

SKU: SF-PRT-15353 | Brand: SparkFun

Sometimes we want our projects on, but sometimes we want to turn them off for a while to save power. The SparkFun Nano Power Timer will run while only consuming minimal power (approximately 35nA) and turn your project...

SKU: SF-PRT-14765 | Brand: SparkFun

The SparkFun Single Supply Logic Level Converter is logic level and power supply translator in one small package. This little board breaks out the Texas Instruments TXB0104 4-bit bi-directional voltage-level tran...

SKU: DF-TEL0119 | Brand: DFRobot

The USB/TTL Raspberry Pi GPS Tracker is a compact GPS location module built around the L80-39 chip. With 66 search channels and 22 simultaneous tracking channels, it delivers fast satellite acquisition and reliable po...

SKU: SF-ROB-14450 | Brand: SparkFun

The TB6612FNG Motor Driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes: CW, CCW, short-bra...

SKU: AF-1374 | Brand: Adafruit

This breakout board is the simplest way to create a project with a single "momentary" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to activate the sens...

SKU: DF-DFR0126 | Brand: DFRobot

This Audio Analyzer module features the MSGEQ7 graphic equalizer display filter.It will give your arduino ears. Sound is broken down into seven frequency bands and the peak level for each band can be read. The seven ...

SKU: AF-2738 | Brand: Adafruit

Control the same hardware as used in space...build your very own Astro Pi with the new Raspberry Pi Sense HAT! The Raspberry Pi Sense HAT is attached on top of the Raspberry Pi via the 40 GPIO pins to create an ‘As...

SKU: SF-SEN-09299 | Brand: SparkFun

The GP1A57HRJ00F is a slotted optical sensor (photo interrupter) with an infrared emitter on one upright and a shielded infrared detector on the other. When an object passes through the 10 mm gap between the uprights,...

SKU: AF-3015 | Brand: Adafruit

This is the Custom Gamepad PCB for the PiGRRL 2 pack! The board is designed for use in portable gaming projects like the PiGRRL 2 but it's basically everything-you-need to make your very own DIY gaming project with...

SKU: SF-BOB-11771 | Brand: SparkFun

This is a breakout board for the Texas Instruments TXB0104 module. The TXB0104 is a 4-bit bidirectional voltage-level translator with automatic direction sensing. This 4-bit noninverting translator uses two separate...

SKU: SF-SEN-13835 | Brand: SparkFun

The SST Liquid Level Sensor provides single-point liquid detection via a TTL-compatible push/pull output. Its miniature optical design allows installation in tight spaces where traditional float switches won't fit. A...

SKU: SF-BOB-13717 | Brand: SparkFun

This is the SparkFun Pi Wedge, a small board that connects to the 40-pin GPIO connector on the Raspberry Pi and breaks the pins out to breadboard-friendly arrangement and spacing, and even adds a couple of decou...

SKU: SF-SEN-13285 | Brand: SparkFun

This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the ‘alarm’ pin will go low.This unit works great from 5...

SKU: SF-PRT-11214 | Brand: SparkFun

MOSFETs are awesome. They’re like a switch that you flip electronically! This SparkFun MOSFET Power Controller makes it easy to switch a battery supply on and off using your favorite microcontroller. The board also ha...

SKU: SF-COM-10468 | Brand: SparkFun

The MSGEQ7 is a CMOS graphic equaliser IC that divides the audio spectrum into seven frequency bands: 63 Hz, 160 Hz, 400 Hz, 1 kHz, 2.5 kHz, 6.25 kHz, and 16 kHz. Each band is peak-detected and multiplexed to provide ...

SKU: DF-DFR0411 | Brand: DFRobot

INTRODUCTION This DC motor has an integrated transistor built in to the board, eliminating the need for a motor driver. Use PWM to control it for all your DIY project needs. It uses the 3 pi...

SKU: SF-ROB-09454 | Brand: SparkFun

The SparkFun QRE1113 Line Sensor Breakout (Digital) is a compact IR reflectance sensor board that outputs a digital signal based on surface reflectivity. It uses a capacitor discharge circuit — the faster the 10 nF ca...

SKU: DF-SEN0648 | Brand: DFRobot

The TOFSense F2P is a professional-grade laser distance sensor using dTOF (Direct Time-of-Flight) technology. With 50m range, ±3cm accuracy, and 100Hz refresh rate, it's engineered for drones, traffic monitoring, indu...

SKU: SF-BOB-28467 | Brand: SparkFun

A simple breakout board that converts the 22-pin HSTX/camera/display connector to standard 0.1" through-hole pins. Perfect for prototyping and debugging when you need direct access to all the signals from your RP2350 ...

SKU: SF-WRL-28434 | Brand: SparkFun

The SparkFun IoT RedBoard combines the powerful ESP32-D0WDQ6 microcontroller with MicroPython pre-installed, letting you start coding IoT projects right out of the box. No need for complex toolchains – just connect vi...