Brands and Manufacturers

SKU: LB-OWL-HBRIDGE | Brand: Little Bird

Using the powerful L298N Dual Motor Driver，this module allows full control of two DC Motors or one stepper-motor. Screw Terminals for easy connections；LEDs show power and output status. Requires six digital inputs....

SKU: WS-19343 | Brand: Waveshare

A dual GPIO expander board for the Raspberry Pi Pico that duplicates all GPIO pins into two sets of 2×20 male headers. Plug your Pico into the centre female socket, then connect two expansion modules simultaneously — ...

SKU: WS-19361 | Brand: Waveshare

Quad GPIO Expander for Raspberry Pi Pico, Four Sets of Male Headers, USB Power Connector Quad GPIO Expander For Pico Four Sets Of Standard Raspberry Pi Pico GPIO Male Headers, USB-Powered Support Features At ...

SKU: SF-SEN-13879 | Brand: SparkFun

The SparkFun Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. By connecting the amplifier to your microcontroller you will be able to read the...

SKU: LB-LS7233 | Brand: Little Bird

Upgrade your Raspberry Pi experience with our GPIO Expansion Extension Board Screw Terminal Hat! This beautifully designed screw terminal expansion version is the perfect addition to your electronic experiments. Conve...

SKU: SF-WRL-17146 | Brand: SparkFun

The ESP8266 WiFi Module is a self contained SOC with integrated TCP/IP protocol stack that can give any microcontroller access to your WiFi network. The ESP8266 is capable of either hosting an application or offloa...

SKU: DF-DFR0626 | Brand: DFRobot

This is an IO expansion module that based on the chip MCP23017. The module can expand additional 16 IOs. It can set 8 IIC addresses, which means with this module, the microcontroller can connect 8 modules, and expand ...

SKU: AF-5648 | Brand: Adafruit

The Adafruit STEMMA MOSFET Driver makes it safe and simple to control motors, solenoids, high-power LEDs, and other current-hungry loads from any microcontroller. Instead of wiring up a transistor and flyback diode on...

SKU: DF-DFR0996 | Brand: DFRobot

A Magnetic latching relay is a new type of relay.  It features low power dissipation and noiseless.  Unlike other non-latching relay, the latching relay needs two digital pulse signal to switch ON/OFF state....

SKU: AF-1375 | Brand: Adafruit

This breakout board is the simplest way to create a project with a single "toggle" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to activate the sens...

SKU: DF-DFR0028 | Brand: DFRobot

This is an arduino tilt sensor. It is used to detect orientation. Inside the sensor, there is a ball that make contact with the pins when the case is upright. Tilt the sensor over and the balls don't touch, thus n...

SKU: SF-SEN-21274 | Brand: SparkFun

The SparkFun Qwiic Dynamic NFC/RFID Tag features the ST25DV64KC dynamic Near Frequency Communication (NFC) / Radio Frequency Identification (RFID) tag IC from STMicroelectronics©. The ST25DV64KC offers 64-kBit (8-kByt...

SKU: DF-DFR0913 | Brand: DFRobot

This DFRobot 4-channel optocoupler-isolated level converter translates 12V signals down to 3.3V, making it easy to interface industrial sensors and PLC outputs with Arduino, Raspberry Pi, and other 3.3V microcontrolle...

SKU: AF-5611 | Brand: Adafruit

The Adafruit PCF8575 GPIO Expander Breakout is an affordable 16-channel I2C GPIO expander that doubles your available digital I/O over a simple two-wire connection. Add extra buttons, LEDs, relays, or other digital pe...

SKU: DF-DFR0914 | Brand: DFRobot

This DFRobot 4-channel optocoupler-isolated level converter translates 12V signals down to 5V, making it easy to interface industrial sensors and PLC outputs with Arduino and other 5V microcontrollers. Each channel fe...

SKU: AF-4886 | Brand: Adafruit

The Adafruit AW9523 GPIO Expander and LED Driver Breakout adds 16 I/O pins to any I2C-capable microcontroller or single-board computer. What sets this expander apart is its built-in 256-step linear constant-current LE...

SKU: SF-DEV-17047 | Brand: SparkFun

The SparkFun Qwiic GPIO adds eight additional digital I/O pins to your project via I2C, based on the TCA9534 I/O Expander from Texas Instruments. Read and write pins just like standard Arduino digital pins using the i...

SKU: WS-31159 | Brand: Waveshare

This compact development board from Waveshare combines the Raspberry Pi RP2350A microcontroller with a built-in 1.47″ LCD display, TF card slot, and RGB LED — all in a tiny form factor with pre-soldered headers and US...

SKU: SF-KIT-19518 | Brand: SparkFun

The SparkFun PIR Breakout Starter Kit includes everything needed to get started with passive infrared motion detection. Built around the Panasonic EKMB1107112 PIR sensor, this kit's breakout board offers ultra-low 1µA...

SKU: SF-WRL-18430 | Brand: SparkFun

The SparkFun MicroMod ESP32 Function Board adds additional wireless options to MicroMod Processor Boards that do not have that capability. This special function board acts as a coprocessor that takes advantage of Espr...