Brands and Manufacturers

SKU: AF-169 | Brand: Adafruit

Tiny little servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds you're used to but smaller. You can use any servo code, hardware or library to control these servos...

SKU: SF-COM-11452 | Brand: SparkFun

These color-changing LEDs take the work out of creating crazy, flashy, blinky… ness. Simply apply power and the LED will cycle through the RGB colorspace: no external controller necessary! These bright and festive LED...

SKU: DF-SEN0171 | Brand: DFRobot

A passive infrared (PIR) motion sensor from DFRobot's Gravity series. It detects infrared radiation from people and animals in motion and outputs a digital HIGH signal when movement is detected — ideal for security sy...

SKU: AF-388 | Brand: Adafruit

Infrared LEDs are used for remote controls (they're the little LED in the part you point at your TV) and 'night-vision' cameras, and these little blue guys are high powered ones! They are 940nm wavelength, which is...

SKU: SF-DEV-10899 | Brand: SparkFun

The LilyTiny is a compact LilyPad board with a built-in ATtiny85 microcontroller that drives four pre-programmed LED patterns. Simply sew on four LEDs and connect a battery — no programming or main board required. Ea...

SKU: SF-COM-12986 | Brand: SparkFun

We know these look like a lot of our other LEDs, but they’re not! These are PTH Addressable RGB LEDs with a WS2812 control IC built right into the them. This PTH version is incredibly similar to its SMD cousin, except...

SKU: AF-3328 | Brand: Adafruit

The Adafruit PT100 RTD Temperature Sensor Amplifier is a breakout board for the MAX31865 precision RTD-to-digital converter. It reads 2-, 3-, or 4-wire PT100 platinum resistance temperature detectors over SPI, deliver...

SKU: DF-TEL0094 | Brand: DFRobot

You must have used a GPS receiver. It is easy to be found in most places, such as smartphones, cars, and computers. They are used to track your loaction all over the globe. GPS Receiver for Arduino is a unit embed...

SKU: AF-954 | Brand: Adafruit

The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36" cable are four wire - ...

SKU: DF-DFR0429 | Brand: DFRobot

INTRODUCTION An ordinary DC motor requires an H Bridge to work with a microcontroller such as an UNO. For newcomers to electronics, the process of finding the right motor driver, connecti...

SKU: DF-SEN0204 | Brand: DFRobot

A non-contact liquid level sensor that detects the presence of liquid through a container wall — no direct contact with the liquid required. Using advanced signal processing via the XKC-Y25-T12V chip, it works through...

SKU: AF-3333 | Brand: Adafruit

The Circuit Playground Express is an all-in-one development board packed with sensors, LEDs, and a speaker — all on a round, beginner-friendly PCB with alligator-clip pads. No soldering required. It supports four prog...

SKU: AF-3487 | Brand: Adafruit

This 30mm translucent green arcade button has built-in LEDs for a beautiful illuminated look. Two surface-mount LEDs with resistors are embedded in the button body, ready to light up from a microcontroller pin or dire...

SKU: EF-EF04097 | Brand: ElecFreaks

The Octopus Capacitive Soil Moisture Sensor uses capacitive sensing to detect soil moisture levels, avoiding the corrosion problems common with resistive sensors for a much longer service life. It outputs an analogue ...

SKU: SF-PRT-08430 | Brand: SparkFun

Premium female-to-female jumper wires, 155mm (6″) long, for connecting between male headers on development boards, breakout boards, and breadboards. The 0.1″ pitch connectors fit standard pin headers and can be instal...

SKU: LB-C-25 | Brand: Little Bird

A compact 25cm USB-A to USB-C cable for charging and data transfer. The short length keeps your desk tidy, reduces cable clutter, and is perfect for portable power banks or tight workspaces. Key Features 25cm Lengt...

SKU: LB-LS4437 | Brand: Little Bird

A festive DIY soldering kit that assembles into a two-sided LED Christmas tree, complete with a clear acrylic display case. Perfect for beginners learning to solder or hobbyists who enjoy seasonal electronics projects...

SKU: EC-ILM13103D | Brand: Elecrow

ThinkNode G3 is a high-performance, compact LoRaWAN gateway designed for IoT communications by Elecrow. It uses the ESP32-S3 dual-core processor and Semtech SX1262 transceiver, equipped with a 240MHz dual-core main c...

SKU: LB-CTOB-UNO | Brand: Little Bird

This USB-C to USB-B cable connects your Arduino Uno (and other USB-B devices) to modern laptops and computers equipped with USB-C ports. At 1 metre long, it provides a convenient length for desktop programming and pro...

SKU: WS-25587 | Brand: Waveshare

The Waveshare OLED/LCD HAT (A) combines a 2-inch IPS LCD main screen with dual 0.96-inch blue OLED secondary screens on a single Raspberry Pi HAT. It's ideal for displaying system stats, status indicators, and small g...