Brands and Manufacturers

SKU: AF-394 | Brand: Adafruit

Pogo pins are little spring-loaded contacts, very handy for making jigs, or making momentary (but electrically solid) contacts. We use them by the dozen for making programming and testing jigs but they're handy also i...

SKU: AF-3318 | Brand: Adafruit

Check out this handy USB extension cable, which will make it easy for you to enclose a device that has a Mini-B USB type port. We think this would be most handy when putting a Teensy, FTDI friend, USB LiPo charger, Be...

SKU: AF-616 | Brand: Adafruit

Give yourself some more room with an EL wire cable extender. This cable has a 2-pin JST SM plug on one end and receptacle on the other. Use it to extend the reach of EL wire, panel, tape, etc. The cable is a meter ...

SKU: AF-824 | Brand: Adafruit

Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 12" (300mm) long and come in a 'strip' of 40 (4 pieces of each of ten rainbow colors). They have 0.1" male he...

SKU: AF-1949 | Brand: Adafruit

These Female/Female Jumper Wires are handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 12" (300mm) long and come in a 'strip' of 20 (2 pieces of each of ten rainb...

SKU: AF-825 | Brand: Adafruit

Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are approximately 3" (75mm) long and come in a 'strip' of 40 (4 pieces of each of ten rainbow colors). They have 0.1...

SKU: AF-6070 | Brand: Adafruit

If you need to add a panel-mount connection that extends a micro SD card, this Round Panel Mount MicroSD Adapter Plug is the easiest and fastest way to panel-ify your project. The adapter is about 30mm in diameter, so...

SKU: AF-5391 | Brand: Adafruit

If you're messing around with floppy drives, or disk drives, or other devices that are usually powered with a PC motherboard you'll often see these big 'Molex' connectors used to provide power. They are used to give 5...

SKU: AF-4482 | Brand: Adafruit

These premium male-male jumper wires are handy for making wire harnesses or jumpering between headers on PCBs. They're 200mm (~7.8") long and come loose as a pack of 40 (10 pieces of red, blue, yellow, and Adafruit bl...

SKU: AF-4364 | Brand: Adafruit

Just about all electronics use a UART serial port with RX and TX pins for debugging, bootloading, programming, serial output, etc. But it's rare for a computer to have a serial port anymore. Thus, a serial cable is an...

SKU: AF-4150 | Brand: Adafruit

In this world nothing can be said to be certain, except we need headers, headers, and more headers!Each pack contains ten blue 36-pin 0.1" pitch break-away male headers.  These are a little extra special in that ...

SKU: AF-3663 | Brand: Adafruit

If your soldering isn't quite up to scratch, or you just don't own a soldering iron yet, then these nifty hammer headers from Pimoroni might be just what you need.  Absolutely no soldering required! All t...

SKU: AF-2104 | Brand: Adafruit

This 2x8 (16 pin - 0.1" spaced) IDC Breadboard Helper is great in conjunction with any 16-pin IDC cables. It comes in two parts, a 'pin-through' socket and a male header. The socket straddles...

SKU: AF-2101 | Brand: Adafruit

The "poor woman's" Raspberry Pi cobbler! This combo of 2x13 pin (0.1 spaced) header and socket is for our popular GPIO Ribbon Cable for Raspberry Pi Model A and B.  It comes in two parts, a 'pin-through' socke...

SKU: AF-2789 | Brand: Adafruit

The premise of this MicroUSB to 5.5/2.1mm DC Barrel Jack Adapter is simple. There's a MicroUSB plug on one end and a 5.5mm/2.1mm DC barrel jack with center positive polarity on the other. This allows you ...

SKU: AF-248 | Brand: Adafruit

A 6×AA battery holder with a 5.5mm/2.1mm DC barrel plug, ready to power Arduino boards and other electronics with a standard DC jack. Use alkaline AAs for approximately 9V at 3000–4000mAh, or rechargeable NiMH cells f...

SKU: AF-3310 | Brand: Adafruit

A 5.5×2.1mm DC barrel connector plug for adding a standard power connector to the end of your own wires. The outer shell unscrews to reveal solder terminals and a crimp strain relief, making it easy to wire up custom ...

SKU: AF-1858 | Brand: Adafruit

This 2.2"/57mm long antenna has 2dBi of gain and 50Ω impedance so it will work fantastically with just about any 850/900/1800/1900/2100 wireless receiver/transmitter such as any Cellular or GSM/GPRS device. Anten...

SKU: AF-1773 | Brand: Adafruit

This 50-pin top-contact FPC connector is a surface-mount component for connecting 0.5mm pitch FPC/FFC cables to your custom PCB. It's compatible with many 50-pin displays including 2.8″ TFT panels with resistive touch...

SKU: AF-425 | Brand: Adafruit

A 4-pin Molex power cable that matches the hard drive/CD-ROM power connectors found on AT and ATX power supplies. Use it to tap into 5V or 12V DC from a desktop power supply for your projects — a convenient source of ...