Arduino

SKU: DF-DFR0221 | Brand: DFRobot

Featured in Make: The Maker's Guide to Boards, DFRobot Leonardo with Xbee Socket is an Arduino Leonardo variant processor.The Arduino Leonardo is based on the ATmega32u4 chip. It is the latest addition to the Ardu...

SKU: SF-PRT-08671 | Brand: SparkFun

This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, bare cable on the opposite end. Dimensions: 100mm length Documents: JST connector

SKU: DF-DFR0222 | Brand: DFRobot

Internet of things has become so easy. With Xboard Relay, you can not only monitor data through internet, but also control it through internet. The Xboard Relay combines an Atmega 32u4 microprocessor and wi...

SKU: DF-DFR0225 | Brand: DFRobot

RoMeo V2 [R3] is an All-in-One Arduino based robot board, it is especially designed for robotics applications, and extended devices. Romeo benefits from the Arduino open source platform, it is supported by thousand...

SKU: SF-SEN-08606 | Brand: SparkFun

A simple flex sensor 4.5" in length. As the sensor is flexed, the resistance across the sensor increases. Patented technology by Spectra Symbol - they claim these sensors were used in the original Nintendo Power Gl...

SKU: DF-FIT0302 | Brand: DFRobot

This motor has a long (0.365" or 9.27 mm), D-shaped metal output shaft that matches the Pololu wheel 42x19mm and 32x7mm. The brass faceplate has two mounting holes threaded for M1.6 screws (1.6 mm diameter, 0.35...

SKU: SF-COM-08377 | Brand: SparkFun

1/6th Watt, +/- 5% tolerance PTH resistors. Commonly used in breadboards and perf boards, these 330Ohm resistors make excellent LED current limiters and are great for general use. Need more than one? Checkout our b...

SKU: SF-DEV-13975 | Brand: SparkFun

At SparkFun we use many Arduinos and we’re always looking for the simplest, most stable one. Each board is a bit different and no one board has everything we want, so we decided to make our own version that combines a...

SKU: SF-BOB-13878 | Brand: SparkFun

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. If you open up an electronic bathroom scale, you’ll find a large rat’s ne...

SKU: SF-COM-00299 | Brand: SparkFun

The Texas Instruments CD74HC4067 is a 16-channel analogue multiplexer/demultiplexer IC. It allows you to route one of 16 analogue signals to a single common pin (or vice versa) using just 4 digital control lines plus ...

SKU: SF-DEV-13712 | Brand: SparkFun

The SparkFun OpenLog is an open-source serial data logger based on the ATmega328 running at 16 MHz. It logs incoming serial data directly to a microSD card, supporting cards from 64 MB to 64 GB in FAT16 or FAT32 forma...

SKU: DF-DFR0029-W | Brand: DFRobot

Press to release pleasure! Our redesigned digital push buttons come with LED, immersion gold surface, and bright colored hats. A captital D at left corner indicates that it is a digital sensor. An illustration of b...

SKU: AF-166 | Brand: Adafruit

The Interlink 402 is a round force-sensitive resistor (FSR) with a 12.7 mm (0.5″) sensing area. It changes resistance based on applied pressure — the harder you press, the lower the resistance — making it a simple, lo...

SKU: SF-COM-11451 | Brand: SparkFun

These color-changing LEDs take the work out of creating crazy, flashy, blinky… ness. Simply apply power and the LED will cycle through the RGB colorspace: no external controller necessary! These bright and festive ...

SKU: SF-DEV-13262 | Brand: SparkFun

The CAN-BUS Shield provides your Arduino or Redboard with CAN-BUS capabilities and allows you to hack your vehicle. This shield allows you to poll the ECU for information including coolant temperature, throttle positi...

SKU: AF-3142 | Brand: Adafruit

Our Raw Male/Male Jumper Wires are perfect for making a custom jumper wire sets for wire harnesses or jumpering between headers on PCB's. These premium jumpers are a little over 6" (150mm) long and come in a 'strip...

SKU: SF-WRL-13231 | Brand: SparkFun

The SparkFun ESP8266 Thing is a breakout and development board for the ESP8266 WiFi SoC — a popular platform for IoT and WiFi-connected projects. All module pins are broken out to breadboard-compatible rows, and on-bo...

SKU: AF-371 | Brand: Adafruit

A 150mm (6″) IDC ribbon cable with 6-pin (2×3) socket connectors on both ends at 0.1″ × 0.1″ (2.54mm) spacing. Commonly used for AVR ISP programming connections and other 2×3 header interfaces. Key Features Socket-...

SKU: DF-TEL0092 | Brand: DFRobot

Wifi Bee-ESP8266 is a Serial-to-WIFI module using XBEE design in a compact size, compatible with XBEE slot, applicable to a variety of 3.3V single-chip system. It can be used for Arduino, wireless data transfer,...

SKU: DF-DFR0374 | Brand: DFRobot

The Arduino LCD Keypad Shield V2 includes a 2x16 LCD display and 6 momentary push buttons. Pins 4, 5, 6, 7, 8, 9 and 10 are used to interface with the LCD and Analog Pin 0 is used to read the work status of five...