Arduino Cables and Connectors

SKU: AF-1957 | Brand: Adafruit

A set of 20 premium male-to-male jumper wires in a ribbon cable strip, each 150 mm (6") long. The wires feature 0.1" (2.54 mm) male header contacts on both ends and come in 10 rainbow colours (2 of each). Pull individ...

SKU: AF-4397 | Brand: Adafruit

This 4-wire cable is a little over 150mm / 6" long and fitted with JST-SH female 4-pin connectors on one end and premium female headers on the other. Compared with the chunkier JST-PH these are 1mm pitch instead of 2m...

SKU: SF-PRT-09914 | Brand: SparkFun

This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin JST connector on one end, bare cable on the opposite end. It also comes with the mating connector fo...

SKU: SF-CAB-15364 | Brand: SparkFun

A 150mm (~6") 10-conductor ribbon cable with 2×5 pin female connectors on both ends, using standard 1.27mm (0.05") pitch. Ideal for SWD (Serial Wire Debug) and JTAG connections between debug probes and target boards. ...

SKU: AF-898 | Brand: Adafruit

This here is your standard A-microB USB cable, for USB 1.1 or 2.0. Perfect for connecting a PC to your NETduino, Arduino Leonardo, Raspberry Pi (among other things).Approximately 6.5" long from end to end, its a littl...

SKU: SF-CAB-15463 | Brand: SparkFun

This panel mount USB-B (female) to micro-B (male) cable enables you to more easily enclose a project that contains a USB micro-B port. The cable is 6" in length and includes two 14mm M3 screws compatible with the cabl...

SKU: SF-PRT-08535 | Brand: SparkFun

This 2×5 (10-pin) IDC ribbon cable with 2.54 mm pitch connectors is commonly used for AVR ISP programming and general-purpose communication between boards. The cable is 6 inches (approximately 15 cm) in length. Key F...